7
ENGLISH
Contra Angle Handpiece
CAUTION
After washing with Thermo-Disinfector and prior to lubrication, dry the product until all internal
moisture is thoroughly removed. Thermo-Disinfector moisture remaining inside the product could
reduce the effect of lubrication and could cause corrosion inside of the product.
To clean the product never use any solvent such as benzine or thinner.
CAUTION
Always insert the bur all the way into the chuck.
Remove the bur only after the handpiece has completely stopped rotating.
Always keep the bur shank clean. Entry of debris into the chuck, via the bur shank, could cause bur
rotation slip and also prevent the bur from being securely located in the chuck.
Do not exceed the bur speed recommended by the bur manufacturer.
Do not exceed maximum bur length recommended by the handpiece manufacturer.
Do not apply excess pressure to the bur as it may break or bend or become difficult to remove.
DO NOT use bur with problems listed below as the bur may break or disengage from the chuck.
- Bent, deformed, worn, rusted, broken, deficient bur.
- Bur which is cracked on the edge or axis.
- Non-ISO standard, or tampered bur.
5-1 Cleaning
1) Remove dirt and debris from the product. Do not use a wire brush.
2) Wipe clean with alcohol-immersed cotton swab or cloth.
This icon denotes that the product can be washed via Thermo Disinfector. (A200E)
Refer to the Thermo-Disinfector manual.
CAUTION
When applying spray be sure to hold the handpiece firmly to prevent the handpiece from slipping out
of the hand due to the spray pressure.
Hold the spray can upright.
3. Check before treatment
Check that the Head Cap is firmly tightened. Also check for handpiece vibration, noise and overheating.
If any abnormalities are found do not use the handpiece and contact your Authorized OSSTEM IMPLANT
Co,. Ltd Dealer.
4. Connection of the Spray Nozzle
1) Attach the FX Spray nozzle to the neck of the handpiece.
2) Trim the tube to the desired length then insert the tube end into the nozzle clamp on the motor. (Fig. 11)
5. Maintenance
After each patient maintain the product as follows.
5-2 Lubrication
PANA SPRAY Plus
Apply PANA SPRAY Plus every time after each use and/or before autoclaving.
1) Remove the bur from the handpiece.
2) Insert the Spray Nozzle into the Spray Port nozzle on the can.
3) Insert the Spray Nozzle in rear of the handpiece. Hold the handpiece and spray for approximately 2-3
seconds. Apply lubricant until it expels from the handpiece head for at least 2 seconds. (Fig. 12)
