Orion XTRPRO102 Manuel utilisateur

Subwoofer

MODEL

XTRPRO102

XTRPRO104

XTRPRO122

XTRPRO124

XTRPRO152

XTRPRO154

OWNER'S MANUAL

FEATURES

1 2

Figure

Figura

Abbildung

10 9

Polypropylene dust cap - moisture and UV resistant.

Oversized NBR (Nitrile-butadiene Rubber) surround for linear controlled

long excursion.

Paper cone - moisture and UV resistant.

4Custom cast aluminum frame.

Vented Aluminum voice coil former (2.5" voice coil former).

68mm steel front plate.

Large 2 stack ceramic magnets.

88mm steel back plate/pole piece T yoke assembly.

1.125"

vent. Part of the enhanced voice coil cooling system (forced

convection).

PVC magnet protector.

High temperature Copper dual 2 ohm or dual 4 ohm voice coil.

Venting in voice coil former. Part of the enhanced voice coil cooling system

(forced convection).

Dual Interlaced Conex spider with stitched and looped tinsel leads

attached.

Custom terminal blocks.

ABS Trim Ring.

2 ohm 2 ohm

WIRING CONFIGURATIONS

Series - One Speaker (dual 2 ohm voice coils)

One dual 2 ohm voice coil woofer with voice coils in connected in series results in a 4

ohm load to the amplifier.

_ _

Figure

Figura

Abbildung 2 + +

1. Connect the woofer in series by connecting the negative (-) of one terminal to the

positive (+) terminal of the other coil.

2. Wire the positive (+) terminal of the first coil to the positive (+) terminal on the

amplifier. Wire the negative (-) terminal of the second coil to the negative (-)

terminal on the amplifier.

Parallel—One Speaker (dual 2 ohm voice coils)

One dual 2 ohm voice coil woofer with voice coils in parallel results in a

ohm load

to the amplifier.

_ _

Figure 3 +

Figura 3 + +

Abbildung

1. Connect the speaker in parallel by connecting the two positive (+) terminals

together and the two negative (-) terminals together.

2. Wire the positive (+) terminals of the woofer to the positive (+) terminal on

the amplifier. Wire the negative (-) terminals of the woofer to the negative (-)

terminal on the amp.

4 ohm

Parallel — One Speaker (dual 4 ohm voice coils)

One dual 4 ohm voice coil woofer with voice coils in parallel results in a 2 ohm load

to the amplifier.

_ _

Figure 4 +

Figura 4 + +

Abbildung

1. Connect the speaker in parallel by connecting the two positive (+) terminals

together and the two negative (-) terminals together.

2. Wire both positive (+) terminals of the woofer to the positive (+) terminal on

the amplifier. Wire both negative (-) terminals of the woofer to the negative (-)

terminal on the amplifier.

4 ohm

Parallel - Two Speaker (dual 4 ohm voice coils)

Two dual 4 ohm voice coil woofers with voice coils in parallel and the two woofers in

parallel results in a

ohm load to the amplifier.

- - - -

+ + + +

Figure 5 +

Figura 5

Abbildung 5 -

1. Connect the speaker in parallel by connecting the four positive (+) terminals

together and the four negative (-) terminals together.

2. Wire the positive (+) terminals of the woofers to the positive (+) terminal on

the amplifier. Wire the negative (-) terminals of the woofers to the negative (-)

terminal on the amplifier.

2 ohm

Series/Parallel - Two Speakers (dual 2 ohm voice coils)

Note: Verify and ensure that the woofer wiring is connected as shown with

the negative connection from the first woofer coil connected to the positive

connection of the second woofer coil.

Two dual 2 ohm voice coil woofers with voice coils in series and then parallel the two

series woofers results in a 2 ohm load to the amplifier.

- - - -

+ + + +

Figure 6 +

Figura 6

Abbildung 6 -

1. Connect each woofer in series by connecting the negative (-) of the first coil to the

positive (+) terminal of the second coil.

2. Wire the positive (+) terminal of the first coil on each woofer to the positive (+)

terminal on the amplifier. Wire the negative (-) terminal of the second coil on

each woofer to the negative (-) terminal on the amplifier.

ohm

Series/Parallel - Three Speakers (dual 4 ohm voice coils)

Note: Verify and ensure that the woofer wiring is connected as shown with

the negative connection from the first woofer coil connected to the positive

connection of the second woofer coil.

Three dual 4 ohm voice coil woofer with voice coils of each woofer wired in series and

then parallel the three woofers for a resulting 2.67 ohm load to the amplifier.

- - - - -

+ + + + +

Figure 7

Figura

Abbildung 7

1. Connect each woofer in series by connecting the negative (-) of the first coil to the

positive (+) terminal of the second coil.

2. Wire the positive (+) terminal of each woofer’s first coil to the positive (+) terminal

on the amplifier. Wire the negative (-) terminal of each woofer’s second coil to the

negative (-) terminal on the amplifier.

ohm

Series/Parallel - Three Speakers (dual 2 ohm voice coils)

Note: Verify and ensure that the woofer wiring is connected as shown with

the negative connection from the first woofer coil connected to the positive

connection of the second woofer coil.

Three dual 2 ohm voice coil woofer with voice coils of each woofer wired in series and

then parallel the three woofers for a resulting 1.33 ohm load to the amplifier.

- - - - -

+ + + + +

Figure 8

Figura

Abbildung 8

1. Connect each woofer in series by connecting the negative (-) of the first coil to the

positive (+) terminal of the second coil.

2. Wire the positive (+) terminal of each woofer’s first coil to the positive (+) terminal

on the amplifier. Wire the negative (-) terminal of each woofer’s second coil to the

negative (-) terminal on the amplifier.

ohm

Series/Parallel - Four Speakers (dual 4 ohm voice coils)

Note: Verify and ensure that the woofer wiring is connected as shown with

the negative connection from the first woofer coil connected to the positive

connection of the second woofer coil.

Four dual 4 ohm voice coil woofers should be wired with the voice coils on each

woofer in series and then parallel the four woofers for a resulting 2 ohm load to the

amplifier.

- - - - - - - -

+ + + ++ + + +

Figure

Figura 9 +

Abbildung

1. Connect each woofer in series by connecting the negative (-) of the first coil to the

positive (+) terminal of the second coil.

2. Wire the positive (+) terminals of the first coil of each woofer to the positive (+)

terminal on the amplifier. Wire the negative (-) terminal of the second coil of each

woofer to the negative (-) terminal on the amplifier.

ohm

Series/Parallel - Four Speakers (dual 2 ohm voice coils)

Note: Verify and ensure that the woofer wiring is connected as shown with

the negative connection from the first woofer coil connected to the positive

connection of the second woofer coil.

Four dual 2 ohm voice coil woofers should be wired with the voice coils on each

woofer in series and then parallel the four woofers for a resulting

ohm load to the

amplifier

- - - - - - - -

+ + + ++ + + +

Figure

Figura 10 +

Abbildung

1. Connect each woofer in series by connecting the negative (-) of the first coil to the

positive (+) terminal of the second coil.

2. Wire the positive (+) terminals of the first coil of each woofer to the positive (+)

terminal on the amplifier. Wire the negative (-) terminal of the second coil of each

woofer to the negative (-) terminal on the amplifier.

Autres manuels pour XTRPRO102

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Orion Subwoofer

Orion

Orion XTR102D Manuel utilisateur

Orion

Orion BLACK COIL HCCA Series Manuel utilisateur

Orion

Orion Cobalt CO104DBX Manuel utilisateur

Orion

Orion BLACK COIL HCCA Series Manuel utilisateur

Orion

Orion HCCA 12.4 Manuel utilisateur

Orion

Orion Cobalt CO104S Manuel utilisateur

Orion

Orion HCCA102 Manuel utilisateur

Orion

Orion XTRPRO122D Manuel utilisateur

Orion

Orion HCCA 10.2 Manuel utilisateur

Orion

Orion XTR102D Manuel utilisateur

Orion

Orion ORION MaxxBass Manuel utilisateur

Orion

Orion ORION H2 10.2 Manuel utilisateur

Orion

Orion HCCA102 Manuel utilisateur

Orion

Orion CO104SBSV-4 Manuel utilisateur

Orion

Orion XTRPRO102 Manuel utilisateur

Orion

Orion HP10D2 Manuel utilisateur

Orion

Orion XTR102 Manuel utilisateur

Orion

Orion Cobalt CO104S Manuel utilisateur

Orion

Orion Cobalt CO104S Manuel utilisateur

Orion

Orion HCCA102 Manuel utilisateur

Orion

Orion XTRPRO102 Manuel utilisateur

Orion

Orion Cobalt CO104S Manuel utilisateur

Orion

Orion P10D2/4 Manuel utilisateur

Orion

Orion HPD2 Manuel utilisateur

Manuels Subwoofer populaires d'autres marques

Sony

Sony XS-AW8 Manuel utilisateur

Sony

Sony XS-L836 Manuel utilisateur

B&C Speakers

B&C Speakers 15 HPL 76W Manuel utilisateur

Velodyne

Velodyne DD-18+ Manuel utilisateur

Sonance

Sonance Cinema Series SUB 10-150 Manuel utilisateur

Hifonics

Hifonics HW-12 Guide de démarrage rapide

Magnat Audio

Magnat Audio ADR 130 BP Manuel utilisateur

Blitz

Blitz BZP106 Manuel utilisateur

Technics

Technics SB-AS500 Manuel utilisateur

Lyngdorf

Lyngdorf BW-2 Manuel utilisateur

Lyngdorf

Lyngdorf BW-3 Manuel utilisateur

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Manuel utilisateur

REL Acoustics

REL Acoustics Q Series Manuel utilisateur

Pioneer

Pioneer Elite S-W1EX Manuel utilisateur

L-Acoustics

L-Acoustics KIVA SB15M Guide de démarrage rapide

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Manuel utilisateur

KEF

KEF KUBE 200 Manuel utilisateur

Yamaha

Yamaha SW500 Manuel utilisateur