Oreck WEDGE GUARD S063 Manuel utilisateur
Simple ON/OFF
switch operation Wedge shape
design prevents
door from opening
Standard 9 volt
battery power
Model SO63
Door Break-In Protection and Alarm
CAUTION
THE WEDGE GUARD ALARM IS EXTREMELY
LOUD. FOR YOUR SAFETY, NEVER PLACE
THE UNIT CLOSE TO YOUR EARS. TO TEST
THE ALARM, DIRECT THE UNIT AWAY FROM
YOU AT ARMS LENGTH AND ACTIVATE.
Instruction
Manual
Instruction
Manual
Warranty Information
Oreck Corporation warrants the Wedge
Guard (Model S063) free from defects in
material and workmanship under normal,
non-commercial use and service. Oreck will
remedy any such defects if they appear
within one (1) year from date of purchase.
This warranty gives you specific legal rights,
and you may have other rights, which vary,
from state to state.
©2003 Oreck Holdings, LLC. All rights reserved.
Register your product on the web at:
WWW.ORECK.COM
Congratulations on your purchase of the
LOCK’N ALARM Wedge Guard model
SO63 door stop and alarm. The Wedge
Guard can be used to provide protection
from forced or unauthorized entry. Its
high output alarm can be a powerful
deterrent to would-be burglars or robbers.
• The alarm siren is very loud, never
place the unit close to your ear, or
allow children to play with this unit.
• Keep this manual for future reference.
1. Make sure the ON/OFF switch is in the
“OFF” position. Remove the bottom plate
of the unit and install a new 9 volt alkaline
battery. Replace the bottom plate.
2. Place the unit on the floor close to the
door without touching the door. (When
the unit is turned on, do not place the
unit against the door with the metal contact
plate depressed or the alarm will sound.)
3. When the unit is switched to the “ON”
position, it will wait approximately
10 seconds then become active. The
unit will now sound the alarm instantly
when vibration is detected or if the
metal contact plate is depressed.
4. When properly set, the unit will sound
its alarm the moment the door is
opened. In cases where there is an
attempt to tamper with the unit from
the outside, or push it out from under
the door, the vibration sensor will
sound the alarm immediately.
5. To disarm the unit, simply slide the
switch to the “OFF” position.
6. When the alarm volume becomes low,
or the unit does not produce a normal
strong alarm sound, replace the battery.
• Provides both contact and vibration
alarm activation
• Wedge stop design prevents entry
• 9 volt battery power
• High output 120 dB alarm siren
• Simple ON/OFF switch operation
FEATURES
IMPORTANT SAFETY TIPS
OPERATION
NOTICE TO CONSUMERS:
DISCLAIMER OF LIABILITY
When utilized correctly, the "Wedge Guard"
can effectively increase your personal
safety in your home or business. However,
Oreck Corp. makes no warranties,
representations or guarantees regarding:
fitness for intended purpose; or its ability
to act as a deterrent to robbery, burglary or
other crime against your person or
property. Oreck Corp. expressly denies
responsibility for any losses, damages, or
injuries which may result from use.
Autres manuels Oreck Système de sécurité
Manuels Système de sécurité populaires d'autres marques
EDM
EDM Solution 6+6 Wireless-AE Manuel utilisateur
Highway Safety Group
Highway Safety Group EA401 Manuel utilisateur
Siren
Siren LED GSM Manuel utilisateur
Detection Systems
Detection Systems 7090i Instructions de montage
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuel utilisateur
Siemens
Siemens FDM273 Manuel utilisateur