4
(2) SETTINGS
TIME ADJUSTMENT (FIGURE 12)
The TIME control knob determines how long the light
will stay on after motion is detected. Turn the TIME
control knob counterclockwise to decrease the light-on
duration (down to 5 seconds). Turn the TIME control
knob clockwise to increase the duration (up to 12
minutes).
FIGURE 12
LUX ADJUSTMENT (FIGURE 13)
The LUX control knob determines at which ambient
Lux level the connected light will turn on when the
sensor is in Automatic Operation mode.
The adjustable Lux range is between 20 and 200 Lux.
Turn the LUX control knob clockwise to the MOON
position and the light will only turn on at night (below
20 Lux). Turn the LUX control knob counterclockwise
to increase the Lux setting. Note that the “T”position
is for TEST mode. Adjust the control knob depending
on your requirements.
FIGURE 13
SENSITIVITY ADJUSTMENT (FIGURE 14)
The Sensitivity control knob determines the detection
distance of the sensor. The detection distance can
be adjusted so that user can prevent undesired light
triggers. Turn the control knob clockwise to increase
the detection distance (up to 12 meters) or
counterclockwise to decrease the detection distance
(down to 3 meters).
FIGURE 14
SENSOR SWIVEL ADJUSTMENT (FIGURE 15)
Depending on individual need, the motion sensor can
be adjusted horizontally 90° to the left or 90° to the
right.
FIGURE 15
DETECTION RANGE ADJUSTMENTS
For limiting the detection range the clip-on lens covers
can be used to blank off lens segments. For different
requirements, the clip-on lens covers can be cut to
size horizontally and vertically to set detection
coverage. (FIGURE 16)
FIGURE 16
1. Follow the grooves on the covers, and cut it to the
suitable size to blank off the lens segment for the
undesirable detection area.
2. Press the two concave surfaces on the attachment
ring to pull off the ring.
3. Place the covers onto the notches at the sensor
lens top. The attachment ring is replaced to the
unit holding the covers steadily in place.
Depending on your needs, you can switch the unit
between the following operation modes: Automatic
Operation and Manual Override.
(1) Automatic Operation
Turn on the wall switch. After 90 seconds warm-up
the sensor will enter Automatic Operation. When the
sensor detects motion and the ambient light level is
lower than the LUX setting, the connected light will
