Optoma UHDCast Pro Manuel utilisateur
UHDCast Pro
User manual
TABLE OF CONTENTS
SAFETY........................................................................................................................................................................... 3
INTRODUCTION.......................................................................................................................................................... 6
Standard accessories....................................................................................................................................... 6
Hardware Installation..................................................................................................................................... 6
SETUP AND INSTALLATION................................................................................................................................... 7
Step 1 - Connect the UHDCast Pro to the projector............................................................................. 7
Step 2 –Turn on projector and select HDMI source ........................................................................... 8
Step 3 –Download and install the EZCast Pro app.............................................................................. 9
Step 4 –Connect to wireless SSID (UHDCastPro_xxxxxxxx) ............................................................ 9
Step 4 –Using the UHDCast Pro................................................................................................................10
FEATURES................................................................................................................................................................13
ADDITIONAL INFORMATION..........................................................................................................................27
SAFETY
Copyright
© Copyright 2019. This publication, including all photographs, illustrations and software, is protected under
international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained
herein, may be reproduced without written consent of the author.
Disclaimer
The information in this document is subject to change without notice. The manufacturer makes no
representations or warranties with respect to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to
revise this publication and to make changes from time to time in the content hereof without obligation of the
manufacturer to notify any person of such revision or changes
Trademarks
Optoma and its logo is a registered trademark of Optoma Corporation. Optoma Europe Ltd is the licensee of
the registered trademark. Android and Chrome OS are registered trademark of Google Inc. Windows is a
registered trademark of Microsoft Corporation in the United States and/or other countries. OS X is registered
trademarks of Apple Inc. iOS is a trademark or registered trademark of Cisco in the U.S. and other countries
and is used under license. HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or
registered trademarks of HDMI Licensing LLC in the United States and other countries. USB-Type C™ and
USB-C™ are registered trademark of USB Implementers Forum).
FCC
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does
cause harmful interference to radio or television reception, which can be determined by turning the device off
and on is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the device into an outlet on a circuit different from that to which the receiver is
connected...
Consult the dealer or an experienced radio/television technician for help.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance with
FCC regulations.
Caution
Changes or modifications not expressly approved by the manufacturer could void the user's authority, which
is granted by the Federal Communications Commission, to operate this projector.
Operation Conditions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Notice: Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Remarque l'intention des utilisateurs canadiens
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.
Declaration of conformity
EMC Directive 2014/30/EU (including amendments).
Low Voltage Directive 2014/35/EU
RED 2014/53/EU
WEEE
Disposal instructions
Do not throw this electronic device into the trash when discarding. To minimize pollution and
ensure utmost protection of the global environment, please recycle it.
INTRODUCTION
Standard accessories
Type-C USB Charging Cable
HDMI extension Cable
Hardware Installation
HDMI connector: Can be connected to your projector.
Type-C Power Connector: Can be connected to the external 5V DC power supply to power
on UHDCast Pro. Please be noted that the electric current should not less than 1.5A.
LED Indicator: The blue LED will be lighted after power on.
Reset Button: Press and hold for 6 seconds to reset to factory resets.
SETUP AND INSTALLATION
Step 1 - Connect the UHDCast Pro to the projector
* Adapter is not included in the box
Step 2 –Turn on projector and select HDMI source
a.
b.
The following screen will be displayed
Step 3 –Download and install the EZCast Pro app
Android / iOS / Windows / OSX / Chrome OS
www.optoma.com
*Supports Android 5 and above, iOS10 and above, Windows 7 and above, Mac OS 10.11
and after, Chrome OS
Step 4 –Connect to wireless SSID (UHDCastPro_xxxxxxxx)
Note: You may be asked to enter a password. The password can be found in the top right
corner of the projector screen
UHDCastPro_xxxxxxxx
Step 4 –Using the UHDCast Pro
1. Open the app
2. Search Device
3. Connect to UHDCastPro_xxxxxxxx
4. Connect to router
The first time you launch the app, there will be a pop up WiFi router list so that you can link
with your WiFi router through UHDCast Pro device to keep internet surfing.
Autres manuels pour UHDCast Pro
1
Table des matières
Autres manuels Optoma Adaptateur
