OOZE Booster Manuel utilisateur
FLEX
TEMP
ONYX
ATOMIZER
PASS-THROUGH
CHARGING
SESH
MODE
WATER PIPE
ADAPTER
Twist the mouthpiece like a car key in the ignition to
unlock & remove.
Load extract into the center of the C-Core dish.
Replace the cap.
GET STARTED
REGISTER YOUR DEVICE
PRESS THE BUTTON 5X TO TURN ON & OFF.
Press the button 3x to switch between the 3 voltage levels.
Each level has a different LED color and heats to a different
temperature range:
HOW TO USE YOUR BOOSTER
The Booster will
remember the voltage
level you selected
during your previous
session. It will remain at
this level unless you
click the button 3x.
SETTING UP YOUR BOOSTER
2.7V
GREEN 3.2V
BLUE 3.7V
RED
1.
2.
3.
Your Booster has an authentication code located on the back of the
device near the base.
Go to ooze.life/register and use this code to fill out the registration
form.
Submit the form. Your Booster is officially registered in our system,
and your warranty is activated!
1.
2.
3.
HOW TO USE
There are 2 ways to operate the Booster:
There are 2 ways to activate a heat cycle:
Use the Booster as a regular extract
vape! Activate a heat cycle and inhale
through the mouthpiece.
MANUAL MODE:
Remove the bottom cap and insert your
Booster into any 14mm water pipe.
Activate a heat cycle and enjoy the dab
rig experience without a torch!
DAB RIG MODE:
The 3 voltage levels have a 15 second safe sesh and
will stop heating afterwards.
SAFE SESH DURATION
Press the button to heat the device
while you inhale, and release
when you exhale.
SAFE SESH MODE:
Click the button twice to activate
sesh mode. The device will heat & LED
will flash without you holding the
button, and shut off after 15 seconds.
SESH MODE:
Keep away from water.
Only charge indoors.
Only charge with
included charger - no others!
Only use in legal and adult
use state/providence/country.
Only use approved
Ooze attachments.
Never leave unattended
around children/pets.
Never disassemble.
Only use wall outlet
for charging.
Do not leave unattended
while charging.
Do not leave
charging overnight.
Always dry thoroughly
after cleaning.
SAFE GUARDS
3 White LED Flashes:
Short circuit in device or atomizer.
5 White LED Flashes:
Open circuit in device or atomizer.
CONNECTION ISSUE
OR ERROR CODE
Needs to Charge: 5 red LED flashes.
While Charging: Flashing white LED.
Charge Complete: Solid white LED.
The Booster takes 60 minutes to fully charge.
CHARGING
Table des matières
Autres manuels OOZE Vaporisateur
Manuels Vaporisateur populaires d'autres marques
iQOS
iQOS lil SOLID 2.0 Manuel utilisateur
CHART
CHART VaporMan 125 Manuel utilisateur
InnoCigs
InnoCigs EGRIP 2 LIGHT Manuel utilisateur
STORZ & BICKEL
STORZ & BICKEL Volcano Hybrid Manuel d'instructions
STEAMAX
STEAMAX STICK X8 Manuel utilisateur
Storz & Bickel GMBH
Storz & Bickel GMBH Crafty Manuel utilisateur
