The OPA-10 Active may also be mounted to any high-quality loudspeaker stand with a
standard 1.375 inch (35 mm) diameter mounting pole. The mounting pole MUST be
located on a level surface that is capable of safely supporting the weight of both the
loudspeaker stand and the OPA-10 Active.
DO NOT ADD OR SUSPEND ANY OTHER ITEMS FROM THE OPA-10 Active OR ITS
LOUDSPEAKER STAND
WARNING
DO NOT ATTEMPT TO SUSPEND ON POINT AUDIO PRODUCTS WITHOUT
UNDERSTANDING LOCAL AND NATIONAL CODES THAT APPLY TO OVERHEAD
SUSPENSION OF PRODUCTS.
DO NOT ATTEMPT TO SUSPEND ON POINT AUDIO PRODUCTS UNLESS YOU
ARE A PROFESSIONAL WITH KNOWLEDGE OF LOCAL AND NATIONAL CODES
RELATED TO SAFE SUSPENSION AND ARE EXPERIENCED IN SUSPENDING
PRODUCTS OVERHEAD.
ON POINT AUDIO IS NOT RESPONSIBLE FOR FAILURES RELATED TO NON-
COMPLIANCE WITH LOCAL AND NATIONAL CODES AND SAFE SUSPENSION
PRACTICE.
DO NOT ATTEMPT TO SUSPEND THIS PRODUCT WITHOUT READING AND
UNDERSTANDING THE DOCUMENT “Suspension of On Point Audio Products”. THIS
DOCUMENT MAY BE FOUND AT: www.onpointaudio.com.
ALL ASSOCIATED RIGGING IS THE RESPONSIBILITY OF OTHERS.
ROTATING THE HF HORN
The OPA-10 Active’s HF horn has a coverage pattern of 90o Horizontal X 40o Vertical
which is preferred when the speaker is positioned vertically. The horn/driver assembly
can be rotated to deliver 40o X 90o when the speaker is positioned horizontally or for
other applications.
To rotate the horn assembly, first remove all the screws on each side of the grille and
remove the grille from the system. Then remove the screws around the perimeter of the
horn. After doing this, the horn can be easily rotated in either direction thanks to its
square shape. It is not necessary to disconnect the connections to the compression
driver when rotating the horn.
