User Guide for Ollee Mini PC MAPMG
2
Always disconnect the computer from its power source and from any network before performing any of the
procedures described in this guide.
Failure to disconnect power or networks before you open the computer or perform any procedures can result in
personal injury and/or equipment damage. Some circuitry on the board can continue to operate even though the
front panel power button is off.
Follow these guidelines before you begin:
•Always follow the steps in each procedure in the correct order.
•Create a log to record information about your computer, such as model, serial numbers, installed options,
and configuration information.
•Electrostatic discharge (ESD) can damage components. Perform the procedures described in this chapter
only at an ESD workstation using an antistatic wrist strap and a conductive foam pad. If such a station is
not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to
a metal part of the computer chassis.
Installation Precautions
When you install and test the Ollee Mini PC, observe all warnings and cautions in the installation instructions.
To avoid injury, be careful of:
•Sharp pins on connectors
•Sharp pins on circuit boards
•Rough edges and sharp corners on the chassis
•Hot components (such as SSDs, processors, voltage regulators, and heat sinks)
•Damage to wires that could cause a short circuit
Observe Safety and Regulatory Requirements
If you do not follow these instructions, you increase your safety risk and the possibility of noncompliance with
regional laws and regulations.
This guide tells you how to:
•Change/install an M.2 SSD
•Change/install a 2.5-inch drive
It also includes the specifications for the MAPMG and MAPMG1.
