Oki ES9465 Manuel
Procedure for the Installation of the
RADF Paper Feed Maintenance Kit
ES9465/ES9475 MFP
Step 1
Unit Disassembly, Part Replacement
Step 2
PM Counter Reset
PN: 45735719
DF-KIT-3018
KIT: PERIODICAL MAINTENANCE
DF-KIT-3018
Pick up roller
ASYS-ROL-FEED
1
Feed roller
ASYS-ROL-FEED
1
Separation roller
ASYS-ROL-RET
1
Step 1 – Unit Disassembly, Part Replacement
1
Open the jam access cover. Remove
2 screws and take off the bracket.
4
3
2
Remove 1 clip and slide 2
bushings.
Be careful not to drop the
pin because it will come
off when the shaft is
pulled out.
5
Remove 4 screws and take off the
bypass upper guide.
Take off the paper feeder unit.
Remove 1 clip and pull out the shaft. Take off
the pickup roller and replace it.
6
7
Remove the clip, pull out the
shaft and take off the feed roller.
Replace the roller.
Remove 2 screws. Slide the
feeder upper
Make sure you
assemble the
pickup roller with
the one-way
clutch in the
correct direction.
Remove 2 screws and take off the
separation roller holder and
separation roller unit.
Remove 1 bushing and clip, and then
take off the separation roller.
PM Part
PM Part
Make sure you assemble the feed roller
with the one-way clutch in the correct
direction.
9
8
PM Part
Step 2 - PM Counter Reset
(1)Enter PM Support Mode
Enter Service Mode [6]+[START]+[POWER]ON
(2)Authentication screen
If a service password has been registered enter the service password and select “OK”. If a service password
has NOT been registered leave password blank and select “OK”.
(3)Use the page down to go to page 3 of 4. Highlight “RADF” and select “RESET”.
(4)Select “INITIALIZE”.
(5)Once completed turn the main power switch OFF/ON.
This function resets:
•Pick up Roller
•Feed Roller
•Separation Roller
Autres manuels pour ES9465
1
Ce manuel convient aux modèles suivants
1
Autres manuels Oki Équipement industriel
