OHAUS TAJ Series Manuel utilisateur

Quick Start Guide TAJ Series

Ohaus Corporation www.ohaus.com iTAJ Carat & Gold Series Quick Start Guide

PREPARATION FOR USE

Install Pan, Release Locks

Install the metal pan over the sub-platform.

Before using the scale, release the

Transportation Lock. On the scale bottom,

slide the locking pin to the position.

Calibration Lock: to change, see Instruction

Manual. (Otherwise leave as is.)

Check Power

Voltage rating on scale’s power adapter must

match local line voltage. If not, contact an

Ohaus dealer. To use battery power, remove

battery cover and insert LR6 (AA) batteries.

Set Draft Shield (Carat models –

see page 3.

)

SELECTING THE LOCATION

Place on a firm, steady surface.

Avoid locations with excessive air current,

vibrations, heat sources, or rapid temperature

changes.

Level the scale: Adjust leveling feet so bubble

is centered.

SAFETY PRECAUTIONS

For safe and dependable operation of this product, please comply with the following

safety precautions:

•Verify that the input voltage printed on the power Adapter and the plug type matches

the local power supply.

•Make sure that the power cord does not pose an obstacle or tripping hazard.

•Disconnect the product from the power supply when cleaning.

•Do not operate this product in hazardous or unstable environments.

•Do not drop loads on the pan.

•Use only approved accessories and peripherals, as available.

•Operate the product only under ambient conditions specified in the Instruction Manual.

•Service should be performed by authorized personnel only.

Transportation

Lock

Leveling

Bubble

Power Input Jack

Remove

Battery

Cover to

insert

Batteries:

LR6 (AA).

Leveling

Feet

Calibration

Lock

Communication

Interface

compartment

(See page 3.)

TAJ Series Quick Start Guide

TAJ Carat & Gold Series Quick Start Guide ii Ohaus Corporation www.ohaus.com

CONTROLS

Carat Series Controls are identical: see bottom of this page.

Key Name Function

Primary function (Short Press) – If scale is Off, turn On.

If scale is on, perform Zero/Tare.

Secondary function (Long Press) – Turn scale Off.

On-Zero

Off

Yes

Menu function – (Yes) Use this key to accept the currently

displayed setting.

Primary function (Short Press) – Send the current display

value to serial port if installed.

Cal Secondary function (Long Press) – Starts Span Calibration

as available in menu.

Primary function (Short Press) – Advances to next available

unit.

Unit

No Menu function – (No) Use this key to reject the displayed

setting and advance to next available setting.

Symbols for

weighing modes.

ct - carats

GN - grains

g- grams

oz - ounces

ozt - ounce troy

thk – taels-Hong Kong

tsg – taels-Singapore

ttw – taels-Taiwan

tola - tola

tical - tical

dwt - penny

lb - pound

PC - parts counting

Battery

discharging

indicator

Stability

indicator

Center of Zero

indicator

Quick Start Guide TAJ Series

Ohaus Corporation www.ohaus.com iii TAJ Carat & Gold Series Quick Start Guide

OPERATION

POWER On/Off: With scale off, press ON. The scale performs a display test,

then displays zero. With scale on, press and hold Off until OFF is displayed.

Remove load from pan and press ZERO to set display to zero.

Manual Tare: Place an empty container on the pan and press ZERO.

The display reverts to 0. Place material to be weighed in the container.

The net weight is displayed.

To clear Tare value, remove container and press ZERO.

ADDITIONAL OPERATIONS

Changing Unit of Measure:

First make units available in Setup/Units menu.

(See next page.)

Then press Unit to advance to next available weighing Unit.

Parts Count Mode: to count parts of uniform weight

Press On-Zero to tare a container or to set display to zero.

Press and hold Mode until the display shows PC. CLr.APU appears.

Press No to use previously saved APW, or Yes to set a new APW.

The display shows number of pieces to use for the new APW.

For a different sample size, press No until desired sample size appears (5, 10, 20, 50, or 100).

Put specified number of pieces on the pan. Press Yes to accept new APW.

After new APW is established, the number of pieces is shown on the display.

For more menu operations, see next page. For calibration, see the Calibration Guide.

Draft Shield Installation (Carat models)

Lay the dome shaped draft shield over the notched metal

ring with the open end facing towards the back of the

balance. With downward pressure rotate the draft shield

allowing the bottom edges to slide under the notches of

the metal ring. Continue rotating the draft shield until the

opening is facing forward.

COMMUNICATION OPTIONS

RS232 or USB interface kits are available as optional accessories.

RS232 Interface Kit:

USB Interface Kit:

TAJ Series Quick Start Guide

TAJ Carat & Gold Series Quick Start Guide iv Ohaus Corporation www.ohaus.com

MENU NAVIGATION

Main level menus are identified by decimal points between each letter, for example S.E.t.U.P.

Enter Menu:

With the scale off, press and hold the On button.

Continue holding the On button until S.E.t.U.P appears.

Press Yes to enter each main menu.

Press No to advance to the next main menu.

Change Settings:

Within each main menu are sub-menus.

Press Yes to enter each sub-menu.

Press No to advance to the next main menu.

Press Yes to accept the displayed sub-menu setting.

Press No to advance to the next setting.

Menu Exit:

The last item in each sub-menu is EnD.

Press Yes to return to the main menu.

Press No to return to the first sub-menu.

The last item in the main menu is E.n.D. Press Yes to return to the previous weighing mode.

MENU STRUCTURE

S.e.t.u.p

S.e.t.u.pS.e.t.u.p

S.e.t.u.p

A-Off On

OFF

OFFOFF

OFF

SpaN

Yes / No

Lin

Yes / No

End

Yes / No

U.n.i.t

U.n.i.tU.n.i.t

U.n.i.t

On On

Off

Off Off

Off

On On

Off

Off Off

Off

On On

Off

Off Off

Off

On On

Off

Off Off

Off

ozt

On On

Off

Off Off

Off

t-hk

On On

Off

Off Off

Off

t-sg

On On

Off

Off Off

Off

t-tw

On On

Off

Off Off

Off

tola

On On

Off

Off Off

Off

tical

On On

Off

Off Off

Off

dwt

On On

Off

Off Off

Off

On On

Off

Off Off

Off

On On

Off

Off Off

Off

End

Yes / No

Stable

APrint

End

On-OFF

BaUd

Parity

Hand h

End

On-OFF

BaUd

Parity

Hand h

End

E.n.d

E.n.dE.n.d

E.n.d

Yes / No

*Print, RS232, and USB menus are only seen after the corresponding interface is installed.

*80252976*

P/N 80252976

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels OHAUS Échelle

OHAUS

OHAUS B10P Manuel utilisateur

OHAUS

OHAUS Carat Manuel utilisateur

OHAUS

OHAUS Ranger 3000 Series Manuel utilisateur

OHAUS

OHAUS TROOPER Manuel utilisateur

OHAUS

OHAUS Ranger Manuel utilisateur

OHAUS

OHAUS RANGER 4000 Series Manuel utilisateur

OHAUS

OHAUS CKW3R Manuel utilisateur

OHAUS

OHAUS Scout pro Manuel utilisateur

OHAUS

OHAUS Catapult 1000 Manuel utilisateur

OHAUS

OHAUS Explorer EX1241 Manuel utilisateur

OHAUS

OHAUS SCOUT Manuel utilisateur

OHAUS

OHAUS Navigator NVT1601M Manuel utilisateur

OHAUS

OHAUS TA152 Manuel utilisateur

OHAUS

OHAUS TROOPER SCALE Manuel utilisateur

OHAUS

OHAUS 5000 Manuel utilisateur

OHAUS

OHAUS Valor 1000 Manuel utilisateur

OHAUS

OHAUS Aviator 7000 Series Manuel utilisateur

OHAUS

OHAUS Compass CX Series Manuel utilisateur

OHAUS

OHAUS Navigator Series Manuel utilisateur

OHAUS

OHAUS SB1200 Manuel utilisateur

OHAUS

OHAUS Ranger Manuel utilisateur

OHAUS

OHAUS TA152 Manuel utilisateur

OHAUS

OHAUS JR 300T Manuel utilisateur

OHAUS

OHAUS Adventurer series Manuel utilisateur

Manuels Échelle populaires d'autres marques

AWS

AWS ZEO-50 Manuel utilisateur

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur