OHAUS CL Series Manuel utilisateur

CL Series

Instruction Manual

99 Washington Street

Melrose, MA 02176

Phone 781-665-1400

Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

EN-1CL Series Scales

1. INTRODUCTION

This manual contains installation and operation instructions for the CL Series Scales.

Please read the manual completely before using the scale.

1.1 Safety Precautions

Please follow these safety precautions:

•Verify that the AC Adapter input voltage matches the local AC power supply.

•Use the scale only in dry locations.

•For best results, use the scale in the specified optimum operating

temperature.

•Do not operate the scale in hostile or unstable environments.

•Use your scale with care, gently loading items to be weighed onto the center

of the pan. Avoiding rough treatment will aid in the life of your scale.

1.2. General Product Features

•Power Up test: When the scale is turned on, all display segments will be

displayed for a few seconds, indicating that the unit is self adjusting to zero.

Once the “0” is displayed, the scale is ready for use.

•Stable Reading indication: A star indicator will appear in the lower left

corner of the display when a stable reading has been reached.

•Overload: If the applied load exceeds the capacity of the scale, an “E” will

appear on the display and the load should be removed immediately. The

scale will return to normal operation.

•Tare Function: Values can progressively be added to a sample. By pressing

the ON/ZERO OFF button, the scale display returns to zero. After adding

additional mass, press ON/ZERO OFF to zero the scale again. Additional

mass may be added up to the capacity of the scale.

•Negative Value: When a load is removed from the scale, any zeroed value

will be displayed as a negative number. To return to normal operation, the

zeroed value can be cancelled by pressing ON/ZERO OFF button.

•Low Battery Indication: The display will show “Lo” when the batteries are

weak and need to be replaced.

EN-2 CL Series Scales

•Auto Shut-Off: To extend battery life, the scale will automatically turn off after

approximately (4) minutes if no active weighing is occurring. This feature is

active with battery operation only.

2. INSTALLATION

2.1 Power

Power the scale using the AC power adapter (not included) or 3 AA batteries.

Battery Installation

Remove the battery cover on the bottom of the scale and place the 3 “AA” size

batteries into the compartment as indicated. Do not use excessive force or press the

weighing pan. Re insert the battery cover.

AC Power Connection

Connect the AC adapter (not included) to the receptacle at the rear of the scale.

Plug the AC adapter into a properly grounded electrical outlet.

2.2 Load cell Lock

Slide the load cell lock to the unlock position for use. Lock for storage, stacking,

or transport.

The scale base allows for the efficient stacking of one scale on top of another.

Note: do not stack more that 4 scales on top of each other.

EN-3CL Series Scales

3 T

•

cale is on. Press and hold this button for

•weighing unit. Press and

on to begin the calibration process.

r intervals. This is especially important if

e scale is in use for prolonged periods.

Cali tio

•

•tion process can be aborted by turning the

•

s –C– while the scale stores the zero

•here xxx is the

•ppropriate calibration weight on the

•hile the scale stores the

•e display returns to the normal

bration steps are not

followed or the wrong weight was used.

3. OPERATION

.1 wo Button Keypad

ON/ZERO OFF: Pressing this button turns on the scale. This same button

operates the zero feature when the s

three seconds to turn the scale off.

UNIT CAL: Press this button briefly to change the

hold this butt

3.2 Calibration

For best results calibrate the scale at regula

bra n weights are not provided with the scale

Press and hold the UNIT CAL button to start the

calibration process. The display will show CAL.

The calibra

scale off.

Press the ON/ZERO OFF button to capture 0. The

display show

load signal.

The display will show C xxx w

calibration weight in grams.

Place the a

platform.

•Press the ON/ZERO OFF button.

The display shows –C– w

calibration point signal.

After calibration, th

weighing mode.

The message CAL E will appear if the cali

EN-4 CL Series Scales

4. ACCESSORIES

AC Power adapter: Ohaus Part No.

Universal Adapter 46001724

Universal Plugs kit (4) 46001780

Calibration Masses:

200g (for 201, 501 models) 51025-25

1000g (for 2000 models) 51025-16

2000g (for 5000 models) 51025-26

Stainless steel pan 80010623

Carrying Case 80010624

5. SERVICE INFORMATION

For service assistance or technical support in the United States call toll-free 1-800-

526-0659 between 8.00 AM and 5:00 PM EST. An Ohaus product service specialist

will be available to provide assistance. Outside the USA, please visit our web site,

www.ohaus.com to locate the Ohaus Office nearest you.

6. TECHNICAL DATA

6.1 Specifications

TABLE 6-1. SPECIFICATIONS.

Model 201 501 2000 5000

Capacity (g) 200 500 2000 5000

Readability (g) 0.1 0.1 1 1

Repeatability (g) 0.1 0.1 1 1

Linearity (g) (+/-) 0.1 0.1 1 1

Weighing Units: CL

CLxxxT

grams, pound:ounces, troy ounces, pennyweights

grams, Hong Kong tael, Singapore tael, Taiwan tael

Tare Range To capacity by subtraction

Stabilization Time ≤3 seconds

Power Requirements AC Adapter (optional) or 3-AA (LR6) alkaline batteries

Calibration Digital with external weight

Optimum Operating Temperature 64° to 77°F / 18° to 25°C

Typical Battery Life 300 hours

Overall Size (mm/in) 205 x 145 x 45 / 8.00 x 5.75 x 1.75

Pan Size (mm / in) 120 / 4.75 dia

Net Weight (kg / lb) 0.4 / 0.9

Shipping Weight (kg / lb) 0.6 / 1.3

EN-5CL Series Scales

6.2 Compliance

Compliance to the following standards is indicated by the corresponding mark on the

product

Mark Standard

This product conforms to the EMC directive 2004/108/EC and the

Low Voltage Directive 2006/95/EC. The complete declaration of

Conformity is available from Ohaus Corporation.

AS/NZS4251.1, AS/NZS4252.1

Disposal

In conformance with the European Directive 2002/96 EC on Waste

Electrical and Electronic Equipment (WEEE) this device may not be

disposed of in domestic waste. This also applies to countries outside the

EU, per their specific requirements.

Please dispose of this product in accordance with local regulations at

the collecting point specified for electrical and electronic equipment.

If you have any questions, please contact the responsible authority or

the distributor from which you purchased this device.

Should this device be passed on to other parties (for private or

professional use), the content of this regulation must also be related.

Thank you for your contribution to environmental protection.

For disposal instructions in Europe, refer to www.ohaus.com/weee.

FCC Note

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

Autres manuels pour CL Series

Table des matières

Autres manuels OHAUS Échelle

OHAUS

OHAUS D31P75SD Manuel utilisateur

OHAUS

OHAUS Ranger 4000 Count Series Manuel utilisateur

OHAUS

OHAUS Scout STX Series Manuel utilisateur

OHAUS

OHAUS Valor V31XH202 Manuel utilisateur

OHAUS

OHAUS Valor 1000 Manuel utilisateur

OHAUS

OHAUS Navigator Series Manuel utilisateur

OHAUS

OHAUS Courier 3000 Manuel utilisateur

OHAUS

OHAUS Adventurer Pro Grain Manuel utilisateur

OHAUS

OHAUS Navigator Manuel d'utilisation et d'entretien

OHAUS

OHAUS Explorer EX35001N Manuel utilisateur

OHAUS

OHAUS Adventurer AX224 Manuel utilisateur

OHAUS

OHAUS 1500 Series Manuel utilisateur

OHAUS

OHAUS PX Series Manuel utilisateur

OHAUS

OHAUS TAJ Series Manuel utilisateur

OHAUS

OHAUS valor 5000 series Manuel utilisateur

OHAUS

OHAUS TROOPER Manuel utilisateur

OHAUS

OHAUS Adventurer Pro Manuel d'utilisation et d'entretien

OHAUS

OHAUS DS Series Manuel utilisateur

OHAUS

OHAUS valor 5000 series Manuel utilisateur

OHAUS

OHAUS Ranger 3000 Series Manuel utilisateur

OHAUS

OHAUS CS 2000 Manuel utilisateur

OHAUS

OHAUS JE 120 Manuel utilisateur

OHAUS

OHAUS Adventurer AX124 Manuel utilisateur

OHAUS

OHAUS Ranger7000 Manuel utilisateur

Manuels Échelle populaires d'autres marques

AWS

AWS ZEO-50 Manuel utilisateur

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur