Numatic WVP 800 DH Caractéristiques techniques

WVP 800 DH Operator Instructions

1) Once model no WVP 800 DH has been removed from its packaging, lay all

components next to main unit to ensure the following accessories have been included.

1 x WVP 800 DH

1 x 4mtr discharge hose

4 x 76mm locking castors

1 x 2.5 mtr vacuum hose/bend assembly

4 x 32mm plastic extension tubes

1 x wet pick up nozzle

1 x nozzle cleaner with slide on brush

Setting up the vacuum

2) Connect 2.5 mtr hose/bend assembly to hose inlet fitted on the front of the drum

assembly.

3) Connect 4 x 32mm plastic extension tubes together and then fit into 32mm plastic

bend fitted to the end of the hose.

4) Fit wet pick up nozzle onto the end of the 32mm extension tube.

5) Connect 4 mtr discharge hose (screw fitting) to rear of drum assembly.

6) Fully uncoil discharge hose and place into a suitable drainage system which must be

lower than the vacuum to work effectively.

7) Move vacuum unit into position, ensuring that is placed on level ground. Push down

the locking mechanism on each castor to secure the unit in place.

8) Ensure that power switch on the vacuum unit is switched off before plugging the

mains lead into a suitable mains power outlet. You may wish to connect the vacuum to an

R.C.D (rated at 30 Milli Amps) before connecting to a power supply.

9) Turn on vacuum switch.

10) Lower extension tubes and wet pick up nozzle into pond.

11) The Vacuum will start to suck up the liquid/debris and when full will automatically

empty the contents via the discharge hose. The quantities of water/waste can be adjusted

by adjusting the auxiliary air inlet on the plastic bend. Please note that the vacuum switch

will need to be turned off before further vacuuming commences.

12) Sometimes sediment may settle in the bottom of the drum assembly, this can easily

be rectified by flushing the unit through with clean water.

Cleaning Sides of pond

13) Remove wet pick up nozzle and extension tubes from hose assembly.

14) Connect slide on brush onto nozzle cleaner to the end of the curved wand section,

or if you are working at a greater depth add 1 or more straight wand sections.

15) Ensure slide valve is fully open on wand section, turn on vacuum and place into

the pond, and scrub pond sides to remove algae and grime.

Things to remember before using the vacuum

•This vacuum is intended only for the use of cleaning/ maintenance of Fish ponds.

•The vacuum must always be secured in place using the 4 x locking castors and on

level ground.

•The vacuum must not be used with extension leads greater than 10 metres.

•The vacuum should not be used for the removal of Hazardous or Volatile

substances.

•Do not allow children near the pond when using the vacuum or let them use the

machine.

•Never use this machine in or around the pond unless you have a Residual

Current Device Fitted (R.C.D)

•The manufacturer of this appliance cannot accept responsibility for loss of stock

or damage to ponds while using this machine.

12.03.07

Table des matières

Autres manuels Numatic Aspirateur

Numatic

Numatic Henry Allergy HVA160-11 AS9 Manuel utilisateur

Numatic

Numatic RSV 200-11 Manuel utilisateur

Numatic

Numatic HDK.201-11 Manuel utilisateur

Numatic

Numatic PPR 180-11 Manuel utilisateur

Numatic

Numatic PPH 320A Manuel utilisateur

Numatic

Numatic HVR 200-12 Manuel utilisateur

Numatic

Numatic PPH 320-11 Manuel utilisateur

Numatic

Numatic HHR 200-11 Manuel utilisateur

Numatic

Numatic CVC 370 Manuel utilisateur

Numatic

Numatic NACECARE NBV 220 NX Manuel utilisateur

Numatic

Numatic HEB 160 Hetty Manuel utilisateur

Numatic

Numatic Henry Allergy HVA160-11 Manuel utilisateur

Numatic

Numatic HZC 390S-2 Manuel utilisateur

Numatic

Numatic RSB150 Manuel utilisateur

Numatic

Numatic HET 200A Manuel utilisateur

Numatic

Numatic Kit AS0 Manuel utilisateur

Numatic

Numatic JVH 180-11 Manuel utilisateur

Numatic

Numatic Henry Xtra HVX 160-11 Manuel utilisateur

Numatic

Numatic NVR170H-11 Manuel utilisateur

Numatic

Numatic ERP 180-11 Manuel utilisateur

Numatic

Numatic CVC 370 Manuel utilisateur

Numatic

Numatic GVE 370 Manuel utilisateur

Numatic

Numatic HZC 390S-2 Manuel utilisateur

Numatic

Numatic WV 1500 Manuel utilisateur

Manuels Aspirateur populaires d'autres marques

Bissell

Bissell LittleGreen Proheat 1425 Series Manuel utilisateur

Panasonic

Panasonic MC-YL637S147-AE Manuel utilisateur

NEFF

NEFF N17XH10 0 Series Manuel utilisateur

LG

LG A9 Series Manuel utilisateur

Oreck

Oreck Cordless Captura BK51700 Series Manuel utilisateur

Kogan

Kogan KAVACROBVWA Manuel utilisateur

Kränzle

Kränzle VENTOS 50 ID Guide de l'utilisateur

EVVO

EVVO Ai35 Manuel utilisateur

DeWalt

DeWalt DWH200D Manuel utilisateur

Pontec

Pontec Pondomatic Vacuum Cleaner Manuel utilisateur

Cleanmaxx

Cleanmaxx PC-P007E Manuel utilisateur

Exido

Exido 240-114 Manuel utilisateur

RIDGID

RIDGID WD1685AU0 Manuel utilisateur

Ezviz

Ezviz RE4P Manuel utilisateur

STG global

STG global TANVAC HDV3000 Manuel utilisateur

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manuel utilisateur

Factory

Factory M3340 Manuel utilisateur

Shop-Vac

Shop-Vac VN92 SERIES Manuel utilisateur