3. Do not boil or wash the Thermometer.
4. Wash and sanitize the pacifier only by washing in hot water with gentle detergent, rinse
thoroughly and boil in and open pan of water for 2 minutes.
HOW TO OPERATE:
1. Install and check that the Thermometer is secured into the Pacifier. If not, follow the
installation instruction below.
2. Press the ON/OFF button and the display will read "188.8M°E", confirming that the display
is working.
3. Upon releasing the on-off button, last measured temperature will be showed for about two
seconds with letter “M” under the degree sign, then 37.0°C/98.6°F, and then Lo°C/Lo°F
displayed (if the room temperature is greater than 32°C/ 90°F, it will be displayed rather
than Lo°C/ Lo°F). The flash °C/°F indicates the thermometer is ready to take a
temperature.
4. Position the pacifier bulb into baby's mouth as normal pacifier.
5. Note: Drinking or eating prior to use may affect the reading. Measurement should be
taken one and half hours after eating or drinking.
6. After the degree sign (°C or °F) on the display has stopped flashing (approx. 3 minutes),
the alarm will sound Bi—Bi—Bi. If temperature exceeds 37.8°C/100°F, it sounds Bi-Bi-Bi
---Bi-Bi-Bi. It represents that the Pacifier Thermometer has detected the baby’s
temperature and the reading is reflecting the baby’s oral temperature.
7. It is recommended to leave the thermometer in baby's mouth for 6- 8 minutes to allow the
pacifier nipple to warm up and to get more accurate reading.
8. The Thermometer will automatically turn off in 10 minutes. However, to prolong battery
life. It is recommended to press the ON/OFF button to turn it off after each use.
9. Repeat operation procedures if interrupted during use.
insert the probe and shaft into the hole at the back of the pacifier.
2. Rotate the Thermometer clockwise until you feel the snap. (LCD display unit should be
horizontal to the pacifier and the pointer is pointing to the “Close” or “Lock” position.)
Patented
TO DETACH THE THERMOMETER:
1. While holding the pacifier shield with one hand,
rotate the Thermometer counterclockwise
until the pointer is pointing to “Open” or “Unlock”
position. (LCD display unit is vertical, 90°C, from
the pacifier.)
2. Pull the Thermometer straight up until the probe
is totally removed from the pacifier.
3. Do not bend or temper with the probe or the
Thermometer.
TO INSTALL THE THERMOMETER
1. While holding the pacifier shield with one hand,
thermometer
pointer
close
open
grids
probe
pacifier
