NORPOLE R-NPPAC6KWM Manuel utilisateur
1
READ THIS MANUAL CAREFULLY BEFORE USING YOUR PORTABLE AIR
CONDITIONER AND KEEP IT FOR FUTURE REFERENCE.
Model R-NPPAC6KWM / R-NPPAC8KWM / R-NPPAC10KWM
Refubished Portable
Air Conditioner
6000/8000/10000 BTU
User’s Manual
2
PRODUCT REGISTRATION
Thank you for purchasing a refurbished Norpole™ product. The first step to protect your product is to complete the
product registration on our website: www.arcaugusta.com/register-my-product.htm. The benefits of registering your
product include the following:
1. Registering your product will allow for more efficient warranty service processing when warranty service
is required.
2. Registering your product could act as your proof of purchase in the event of insurance loss.
Once again, thank you for purchasing a Norpole product.
3
CONTENTS
PRODUCT REGISTRATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
IMPORTANT SAFETY INSTRUCTIONS.............................. 4
SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
PARTS IDENTIFICATION ......................................... 7
INSTALLATION INSTRUCTIONS ................................... 8
REMOTE CONTROL (FOR NPPAC6KWM) . . . . . . . . . . . . . . . . . . . . . . . . . . 13
REMOTE CONTROL (FOR NPPAC8KWM & NPPAC10KWM). . . . . . . . . . . . 15
OPERATION INSTRUCTIONS .................................... 17
CARE AND MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
TROUBLESHOOTING .......................................... 21
LIMITED WARRANTY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
4
IMPORTANT SAFETY INSTRUCTIONS
NOTE: This user manual encompasses information for the NPPAC6KWM, the NPPAC8KWM and the
NPPAC10KWM. Make note of the unit you own while reading operation instructions as there may be some
discrepancies.
ExPLANATION OF SYMBOLS
WARNING: Hazards or unsafe practices which COULD result in severe personal injury or death.
CAUTION: Hazards or unsafe practices which COULD result in minor personal injury or property damage.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions before using the appliance.
2. WARNING: To prevent injuries or property damage, the following instructions must be followed.
3. This appliance should not be operated, cleaned or maintained by anyone that is not able to follow
proper safety procedures or does not have experience with this type of equipment, unless under
close supervision.
4. WARNING: DO NOT use in an area where it may be exposed to combustible gases or liquids, as
this may cause a re.
5. CAUTION: Installation must be performed according to the installation instructions and ALWAYS
use the correct tools as specied. Use only accessories and parts included with the appliance.
Improper installation can cause water leakage, electrical shock, or re.
6. Place the unit on a level, sturdy section of the oor, away from heat sources or anywhere it could get
wet.
7. DO NOT operate in a wet environment, such as a bathroom or laundry room.
8. DO NOT stand, sit, or place anything on top of the unit.
9. DO NOT let children operate or play on or around the air conditioner. Children should be supervised
around the unit at all times.
10. CAUTION: The power cord is equipped with a 3-prong grounding plug to protect against shock
hazards. ALWAYS plug cord into a properly installed and grounded 3-prong wall receptacle. Refer to
the manufactures rating label for electrical and other technical data specic to this unit.
11. DO NOT modify or cut the power cord, or use any other cord or plug. If the cord or plug is damaged,
DO NOT use. Contact customer service or a qualied service technician for replacement or repair.
12. DO NOT run cord under carpeting, throw rugs, runners, or similar coverings. DO NOT route cord
under furniture, appliances, or any heavy object. Place the cord where it will not be tripped over.
13. DO NOT start or stop the unit by turning the power on or off.
14. DO NOT insert or pull out the plug with wet hands.
15. DO NOT use this item on a solid state speed control device (such as a fan control wall switch).
16. DO NOT obstruct the unit to ensure proper function and safety.
17. DO NOT insert your nger or other foreign objects into grills or openings.
18. CAUTION: ALWAYS turn off and unplug the unit prior to cleaning or maintenance.
5
19. Contact customer service or an authorized service technician for repair or maintenance of this unit.
DO NOT try to take apart or repair the unit by yourself.
20. Turn off and unplug the unit if strange sounds, smells, or smoke come from it.
21. If the appliance is knocked over during use, turn off the unit and unplug it immediately. Visually
inspect the unit to ensure there is no damage. If there is any damage, or you suspect the unit has
been damaged, contact a technician or customer service for assistance.
22. If water spills into the unit, turn it off, unplug it, and contact a qualied service technician.
23. DO NOT try to move the unit when the tank is full, or force the castors to roll on carpet. Doing so
may cause the unit to tip over and spill water.
24. ALWAYS insert the lters securely. Clean lter once every two weeks.
READ AND FOLLOW THIS
SAFETY INFORMATION CAREFULLY
SAVE THESE INSTRUCTIONS
6
SPECIFICATIONS
Model NPPAC6KWM NPPAC8KWM NPPAC10KWM
Dimensions (W x H x D) 13.0” x 24.2” x 12.5” 13.0” x 24.2” x 12.5” 14” x 27.7” x 13.6”
Weight 41.4 lbs. 44.1 lbs. 52.9 lbs.
BTU 6000 8000 10000
SACC BTU 3000 3800 5500
Voltage 115V / 60Hz 115V / 60Hz 115V / 60Hz
Watts 676 900 1110
Current 6.0A 8.5A 9.8A
Refrigerant Type R410A / 7.4 oz. R410A / 9.52 oz. R410A / 10.58 oz.
Operating Temperature
Range
Cool Mode: 62-95°F (17-35°C)
Dry Mode: 55-95°F (13-35°C)
H
W
D
Figure 1
7
PARTS IDENTIFICATION
a. Control Panel
b. Remote Signal Receptor
c. Horizontal Louver Control Lever
(Fixed or manually adjusted)
d. Vertical Louver Control Lever
(Fixed or manually adjusted)
e. Panel
f. Caster
g. Handle (Both sides)
h. Air Filter (Behind the grille)
i. Upper Air Intake
j. Drain Outlet
k. Air Outlet
l. Lower Air Intake
m. Bottom Tray Drain Outlet
n. Remote Control
NOTE: Exhaust hose and other installation accessories should not be discarded.
Figure 2
n
FOR NPPAC6KWM
FOR NPPAC8KWM
& NPPAC10KWM
g
h
i
jk
l
m
a
cd
e
f
b
Front Rear
ON/OFF
MODE
FAN
SLEEP
TEMP
SHORT
CUT
TIMER
ON
TIMER
OFF
LED
8
INSTALLATION INSTRUCTIONS
TOOLS NEEDED
• Medium Philips screwdriver
• Tape measure or ruler
• Knife or scissors
• Saw (optional, to shorten window adaptor for narrow windows)
ACCESSORIES
smaller windows.
Part Description Quantity
Unit Adaptor 1 pc
Exhaust Hose 1 pc
Window Slider Adaptor 1 pc
Bolt 1 pc
Window Slider A 1 pc
Window Slider B 1 pc
Foam Seal A (Adhesive) 2 pc
Foam Seal B (Adhesive) 2 pc
Foam Seal C (Non-Adhesive) 1 pc
Security Bracket and 2 Screws 1 set
Drain Hose 1 pc
Remote Controller and Battery 1 set
ON/OFF
MODE
FAN
SLEEP
TEMP
SHORT
CUT
TIMER
ON
TIMER
OFF
LED
FOR NPPAC6KWM FOR NPPAC8KWM
& NPPAC10KWM
9
INSTALLTION
NOTE: Once the Exhaust Hose Assembly and Adjustable Window Slider are prepared, install according
to the type of window you are using.
Figure 4
Figure 5
Figure 6
WINDOW INSTALLATION KIT
1. Preparing the Exhaust Hose Assembly:
Press the exhaust hose into the window
slider adaptor and unit adaptor and clamp
with the buckles of the adaptor.
2. Attach the Exhaust Hose Assembly to the Unit:
Push the Exhaust hose into the air outlet
opening of the unit along the arrow direction.
3. Prepare the Adjustable Window Slider:
Measure the size of your window opening.
If needed, cut the window slider to the
correct length. You may need both window
sliders, in which case, slide Window Slider
B into Window Slider A, adjust to correct
size, and use the bolt to fasten the window
sliders together.
Exhaust Hose Exhaust Hose Assembly
Unit Adaptor
Bolt
Window
Slider B
Window
Slider A
Window Slider Adaptor
LOCATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on a level surface to
minimize noise and vibration.
• The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
• The unit should be located at least 12” (30cm) from the
nearest wall to ensure proper air conditioning.
• DO NOT cover the Intakes, Outlets or Remote Signal
Receptor of the unit, as this could cause damage to the unit.
50cm
19.7inch
NOTE:
All the illustrations in the manual are for explanation
purpose only. Your machine may be slightly different.
The actual shape shall prevail.
The unit can be controlled by the unit control panel alone or
with the remote controller. This manual does not include
Remote Controller Operations, see the <<Remote Controller
Instruction>> packed with the unit for details.
Recommend Installation
Figure 3
10
2Window Slider A
Window Slider B
(if required)
Insert the window slider
assembly into the window
opening.
3
Foam seal C
(Non-adhesive type)
Cut the non-adhesive foam
seal C strip to match the
width of the window. Insert
the seal between the glass
and the window frame to
prevent air and insects from
getting into the room.
4
2 Screws
Security Bracket
If desired, install the
security bracket with
2 screws as shown.
Type 1: Hung Window Installation
1
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Cut the adhesive foam seal
A and B strips to the proper
lengths, and attach them to
the window sash and frame
as shown.
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels NORPOLE Climatiseur
