Nokia RA-8 Manuel utilisateur
Issue 1 11/05 COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All Rights Reserved.
Nokia Customer Care
5 - Disassembly/
Reassembly Instructions
Issue 1 11/05 COMPANY CONFIDENTIAL 2
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
[This page left intentionally blank]
Issue 1 11/05 COMPANY CONFIDENTIAL 3
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
Table of Contents Page No
RA-8 Disassembly Instructions ......................................................................... 5
Reassembly ....................................................................................................... 14
Issue 1 11/05 COMPANY CONFIDENTIAL 4
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
[This page left intentionally blank]
RA-8
Nokia Customer Care 5 - Disassembly/Reassembly Instructions
5 COMPANY CONFIDENTIAL Issue 1 11/05
Copyright © 2005 Nokia. All Rights Reserved.
RA-8 Disassembly Instructions
(Also see the video clips on care point.)
1.) Protect the window with a film. 2.) Fit protective film to the LCD Module.
3.) Press down the Latch and open the Bat-
tery Cover. 4.) Be sure that the battery is removed and
then continue with disassembly. Note to put
back the Sealing Tape after the re-assem-
bly.
5.) Push the Latch and open the A-Cover
Assy. 6.) Protect the LCD Module with a film.
Issue 1 11/05 COMPANY CONFIDENTIAL 6
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
7.) Remove the Keypad. Note the guide
openings on the UI Shield Assy when
assembling the Keypad.
8.) Unscrew the four, Torx Plus®size 6
screws in the shown order. Always use new
screws when re-assembling! For assembly,
reverse the order and use a Torx Plus®size
6 driver with a torque setting of 25Ncm.
9.) The screws are not reusable. 10.) Open the flap carefully by using the
dental tool.
11.) Remove the SHIELD in shown order. 12.) Remove the Power Key.
RA-8
Nokia Customer Care 5 - Disassembly/Reassembly Instructions
7 COMPANY CONFIDENTIAL Issue 1 11/05
Copyright © 2005 Nokia. All Rights Reserved.
13.) Push out the Speaker with SRT-6. 14.) Open the LCD connector carefully.
15.) Lift and remove the LCD Module. 16.) From shown side only, open the UI
Module connector carefully.
17.) Use the SRT-6 as a lever to lift the
Shield.18.) Hold the unit as shown in the picture.
19.) Use a slotted screwdriver to unlock the
snap. 20.) The snap of the C-Cover is locked to
the Shield. Bend the snap a bit in the shown
direction and push it out carefully.
Issue 1 11/05 COMPANY CONFIDENTIAL 8
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
21.) Press out the C-Cover Assy carefully. 22.) Take away the C-Cover Assy.
23.) The Command Buttons drop out by
pushing them out. 24.) Place the SRT-6 between Qwerty Key-
pad and the DC-Jack and lift the Qwerty
Keypad carefully.
25.) Open the hooks carefully by using the
SRT-6 as a lever. 26.) Unlock the hooks along the edge of the
Qwerty Keypad as shown.
27.) The same procedure on the shown
side. 28.) Now, the Qwerty Keypad can be
removed.
RA-8
Nokia Customer Care 5 - Disassembly/Reassembly Instructions
9 COMPANY CONFIDENTIAL Issue 1 11/05
Copyright © 2005 Nokia. All Rights Reserved.
For assembly only!
Always use a new Adhesive Qwerty Key-
pad when re-assembling! 29.) Unscrew the eight, Torx Plus®size 6
screws in the order shown. Always use new
screws when re-assembling! For assembly,
reverse the order and use a Torx Plus®size
6 driver with a torque setting of 25Ncm.
30.) Remove the Chassis Assy. Always
start from the antenna side. 31.) Remove the DC-Jack by using the DC-
plug.
32.) Remove the Microphone by using the
dental tool. 33. Remove the WLAN Antenna with
tweezers.
Issue 1 11/05 COMPANY CONFIDENTIAL 10
Copyright © 2005 Nokia. All Rights Reserved.
RA-8
5 - Disassembly/Reassembly Instructions Nokia Customer Care
34.) Note the placement of the RF Coax
Cable before continuing the disassembly. 35.) First remove the Antenna Assy. Do
Not open the Antenna RF connector!
36.) Remove the RF Coax Cable from its
guidance. 37.) Do not pull up on the cable.
38.) Lift RF connector straight up by using
angled tweezers, do not bend it sideways.
For repair only!
RF Coax Cable cannot be disconnected
from the Antenna. If Antenna Assy or RF
Coax Cable is defect, use always a new
Antenna Assy and a new Coax Cable.
First place the Antenna Assy onto the
Shield and than connect the RF Coax
Cable.
Autres manuels pour RA-8
1
Autres manuels Nokia Téléphone portable
Nokia
Nokia N72 Manuel utilisateur
Nokia
Nokia N97 Manuel utilisateur
Nokia
Nokia NOKIA C3-00 Guide de l'utilisateur
Nokia
Nokia E63 Manuel utilisateur
Nokia
Nokia N-GAGE Manuel de service
Nokia
Nokia C5-03 Manuel utilisateur
Nokia
Nokia 302 Manuel utilisateur
Nokia
Nokia X2-00 Manuel utilisateur
Nokia
Nokia 6126 - Cell Phone 10 MB Manuel utilisateur
Nokia
Nokia Lumia 710 Manuel utilisateur
Nokia
Nokia NPM-2NX Mode d'emploi
Nokia
Nokia C2 Manuel utilisateur
Nokia
Nokia 6125 - Cell Phone 11 MB Manuel utilisateur
Nokia
Nokia 3310 3G Manuel utilisateur
Nokia
Nokia 6060 - Cell Phone 3.2 MB Manuel utilisateur
Nokia
Nokia 6090 Comment utiliser
Nokia
Nokia 6500 classic RM-265 Manuel utilisateur
Nokia
Nokia 6103 - Cell Phone 4.4 MB Manuel utilisateur
Nokia
Nokia C5-06 Manuel utilisateur
Nokia
Nokia C6-00 Manuel utilisateur
