16
15
FCC NOTICE
The following statement applies to all products that have received FCC approval. Applicable products bear the FCC
logo, and/or an FCC ID in the format FCC ID:2AAP6M7859 on the product label. This device complies with
part 15 of the FCC Rules. Operation is subjected to the following two conditions: This device may not cause
harmful interference, and this device must accept any interference received, including interference that may
cause undesired operation. This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RF EXPOSURE INFORMATION (FCC SAR)
DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for
wireless mobile devices employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC with the device transmitting at its highest certified power level
in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the device while operating can be well below the maximum value.
This is because the device is designed to operate at multiple power levels so as to use only the poser required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.
The highest SAR value for the device as reported to the FCC when tested for use when worn on the body, as
described in this user guide, is W/kg. (Body-worn measurements differ among device models, depending
upon available accessories and FCC requirements.) While there may be differences between the SAR levels of
various devices and at various positions, they all meet the government requirement. The FCC has granted an
Equipment Authorization for this device with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with
the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid/ after searching on
FCC ID: 2AAP6M7859
0.693
Compliance Information Warning Statement
Operation is subject to the following two conditions: this device may not cause
interference, and this device must accept any interference, including interference that
may cause undesired operation of the device.
IMPORTANT NOTICE:IC Radiation Exposure Statement
This EUT is compliance with SAR for general population/ uncontrolled exposure limits in
IC RSS-102 and had been tested in accordance with the measurement methods and
procedures specified in IEEE 1528. This equipment should be installed and operated
with minimum distance 0.5cm between the radiator and your body. this device and its
antenna (s) must not be colocated or operating in conjunction with any other antenna or
transmitter.
Limitations and Exclusions
NOBIS'S one-year limited warranty only covers defects in materials and workmanship.
This warranty does not cover: cosmetic damage, units that are dropped, normal wear and
tear, improper operation, improper voltage supply or power surges, signal issues, damages
from shipping, acts of God, any type of customer misuse, modifications or adjustments, as
well as installation and set-up issues or any repairs attempted by anyone other than by a
NOBIS authorized service center. Products with unreadable or removed serial numbers, or
requiring routine maintenance are not covered. This one year limited warranty does not
cover Products sold:"AS IS","FACTORY RECERTIFIED" or by a non-authorized reseller.
