Nitsuko NVM-2e Manuel utilisateur

NVM-2e

Installation Instructions and

Release Notes for Versions 1.08 and

1.08.02

Part No. 17780INS04

Issue 1-0, September 1999

This manual has been developed by Nitsuko America. It is intended for the use of its customers and service

personnel, and should be read in its entirety before attempting to install or program the system. Any comments or

suggestions for improving this manual would be appreciated. Forward your remarks to:

Nitsuko America, Telecom Division

4 Forest Parkway

Shelton, CT 06484

Attention: Manager, Technical Publications

Nothing contained in this manual shall be deemed to be, and this manual does not constitute, a warranty of, or

representation with respect to, any of the equipment covered. This manual is subject to change without notice and

Nitsuko America has no obligation to provide any updates or corrections to this manual. Further, Nitsuko America

also reserves the right, without prior notice, to make changes in equipment design or components as it deems

appropriate. No representation is made that this manual is complete or accurate in all respects and Nitsuko America

shall not be liable for any errors or omissions. In no event shall Nitsuko America be liable for any incidental or

consequential damages in connection with the use of this manual. This document contains proprietary information

that is protected by copyright. All rights are reserved. No part of this document may be photocopied or reproduced

without prior written consent of Nitsuko America.

Printed in U.S.A.

Table of Contents

Issue 1-0 i

About NVM-2e.......................................................................................................................1

About This Supplement.........................................................................................................2

Installation Instructions.........................................................................................................3

Voice Mail Specifications ......................................................................................................7

Site Requirements.................................................................................................................7

Install NVM-2e.......................................................................................................................8

Connect a Laptop to the NVM-2e..........................................................................................9

Connect a Phone System to NVM-2e.................................................................................11

Program NVM-2e for the Correct Phone System................................................................14

Program Your Phone System for Voice Mail.......................................................................14

Program NVM-2e................................................................................................................14

Start Up the System Configuration Management Program:................................................15

Release Notes for Software Version 1.08...........................................................................17

Changes and Additions in the System Configuration Management Program.....................21

Changing Ranges of Mailboxes in the Numbering Plan...............................................21

Port Options for Lamping and Message Notification.....................................................25

System Options ............................................................................................................27

¾Lamp On string...............................................................................................28

¾Lamp Off string...............................................................................................28

¾Silence limit during recording (secs)...............................................................29

¾Eliminate silence during recording?................................................................29

Channel Parameters.....................................................................................................30

¾DTMF detection time (10 ms) during playback - Default is 5..........................31

¾DTMF detection time (10 ms) during record - Default is 6..............................31

Call Processing Parameters.........................................................................................31

¾CmdInputTimeout (sec) Time limit for dialing commands (for call routing).....33

¾DtmfTimeout (sec) time allowed user between dialing digits

(for call routing)..............................................................................................33

¾NoAnswerRings Number of ringback seconds before regarding call not

answered........................................................................................................34

¾NormalGain Default volume setting for recorded messages (Min: -10 Max:

10)...................................................................................................................34

¾PromptAtten Volume setting for Voice Prompts (Min: -10 Max: 10) ...............34

Changes in Drive Letters Displayed....................................................................................35

Actions Added to the Dial Action Table (CR,27 and HU, 48)..............................................35

Immediate Recording of Message for Subscriber...............................................................35

Pressing SA or E While Listening to Messages..................................................................35

Message Notification...........................................................................................................36

Release Notes for Software Version 1.08.02......................................................................37

Changes and Additions in the System Configuration Management Program.....................41

Dial Strings.....................................................................................................................41

Revisions to the Names of Various Parameters............................................................41

Appendix A...........................................................................................................................43

User’s Menu...................................................................................................................43

System Administrator Menu...........................................................................................44

Database Management Menu........................................................................................45

NVM-2ex Installation Instructions and Software Release Notes

Issue 1-0 1

About NVM-2e Your NVM-2e generally operates and is programmed as described in

the NVM-2 Setup Guide (P/N 17690SET02 or higher), NVM-2

Programming Guide (P/N 17690INS02 or higher) and NVM-2 Release

Notes for Version 1.05.07 (P/N 17690UPG01 or higher).

The NVM-2e cabinet is different from the NVM-2. (The NVM-2 is

the unit shown in the documentation mentioned above.) See Figures 1

and 2 for different views of the NVM-2e.

NVM-2e is flash-RAM based. Batteries are not required to back up

system memory.

Note: You should ignore the battery installation instructions in the

NVM-2 documentation.

NVM-2e is available as a 2 port, 3 hour unit (P/N 17780-2P) or as a 4

port, 3 hour unit (P/N 17780-4P). NVM-2e has all of the features of an

NVM-2 as well as all of the changes and enhancements described in

this supplement.

Figure 1: NVM-2e (Back Panel)

Note: The LEDs are lit when:

the unit has power (Power LED)

the Voice Mail is up and running (Voice Mail LED).

A particular port is busy (Port Status LEDs).

Figure 2: NVM-2e (Front Panel)

NVM-2ex Installation Instructions and Software Release Notes

2Issue 1-0

About This Supplement

This supplement is divided into two sections: Installation Instructions

and Software Release Notes.

The Installation Instructions tell you how to install the NVM-2e. The

Software Release Notes describe any new or enhanced features that are

available in software release 1.08 and 1.08.02.

Use this supplement with the NVM-2 Setup Guide (P/N 17690SET02

or higher), NVM-2 Programming Guide (P/N 17690INS02 or higher)

and the NVM-2 Release Notes (P/N 17690UPG01 or higher) to install

and program your NVM-2e.

Issue 1-0 3

NVM-2e

Installation Instructions

Table of Contents

Issue 1-0 5