Original instruction
8 / 14
The battery should always be removed whenever you are not using the tool and especially when you
are adjusting or transporting the tool to avoid accidental operation.
To insert the battery, slide it into the battery cradle on the top of the line trimmer, aligning the ribs in the cradle
with the slots in the battery until it latches into place. Check that the battery is securely locked into place
To remove the battery press and hold the latch on the rear of the battery pack and slide the battery away from
the trimmer.
Rewinding the spool
The spool is supplied with the line pre-wound. The twisted line is 1.65mm (0.065”) in diameter, which gives good
cutting performance and reduced noise. Follow the instructions below to rewind new line onto the spool.
To remove the string head, press and hold the shaft lock button and unscrew the head anti-clockwise.
Component parts of the string head
Cut a piece of nylon line 1.65mm (0.065”) in diameter maximum 12m long (you may find it easier to practice with
a shorter line length at first). Find the centre of the line and loop it onto the notch in the centre flange of the
spool. Wind the line around the spool, in the direction indicated by the arrow on the spool, keeping each end of
the line in its own channel. Keep the line tight as you wind so that the line coils smoothly onto the spool
Wrap the line around the spool leaving about 20cm line exposed on each side
Keep the line tight and clip the lines into the notches in the bottom flange of the spool to hold the line in place
while you fit the spool into the housing.
The smaller end of the spring goes into the top of the spool
Then put the spool and spring into the housing leaving the ends of the line protruding from the cut outs on each
