Nilfisk-Advance Advance SC400 Manuel utilisateur

Nilﬁsk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk-advance.com

www.nilﬁsk.com

ATTENTION! Do not use the machine before you have read and understood the User Manual

2. Fill the tank with a solution suitable

for the work to be performed.

Always follow the dilution instructions

on the label of the chemical product

used to prepare the solution. Its tem-

perature must not exceed 40°C.

1 Disconnect the battery charger cable

from the electrical main.

3. Install the squeegee and fasten it

with the handwheels, then connect

the vacuum hose to the squeegee.

4. Place the brush or the pad-holder

under the deck. Use the appropriate

brush to clean the ﬂoor.

17. Charge the batteries: Connect the

battery charger cable to the

electrical main

15. Check and clean the squeegee

blades

16. Clean the machine using a damp

cloth and where needed use a

neutral cleaning product

18. Park the machine with the recovery

tank cover open

12. Clean the ﬁlter by: Remove the

transparent cover and the gasket

10. At the end of the work. Empty

the recovery tank with the hose. Then

empty the solution tank with the

trasparent hose

11. Wash with clean water the recovery

tank and the vacuum grid

13. Remove the brush/pad and clean

them

14. Take the squeegee off and remove

debris.

7. Press the solution ﬂow control

switch as necessary, depending on the

type of cleaning to be performed

5. Switch on the brush and vac motors

to activate the machine

6. Press the handle switch to engage

the brush and run the machine

8. Lower the squeegee with the lever. 9. Press the enabling push-button together

with the brush levers for starting ﬂoor

cleaning. If solution applied ﬂows outside

the brush housing during use, reduce the

ﬂow of solution.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to

carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

OPERATING GUIDELINES

SC400

Nilﬁsk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk-advance.com

www.nilﬁsk.com

ATTENTION! Do not use the machine before you have read and understood the User Manual

The machine

doesn’t work

as it should?

The suction

doesn’t work

as it should?

The machine

doesn’t clean

as it should?

The brush

don’t work as they

should?

TROUBLESHOOTING

SC400

1Check if the power cable is correctly

connected.

1Check if the suction hose is

correctly installed and cleaned.

1Check if you have the right water

settings.

1Check if the brush are correctly in-

stalled and not worn out.

2Check if the battery is charged.

2Open the recovery tank and check

if the vacuum grid and gasket are

cleaned.

2Check if the solution tap is open.

2Check if there isn’t any brush motor

overload i.e. 3 battery Ledsﬂash si-

multaneously.

3Check if squeegee blades are

damaged or dirty.

3Check if there are external materials

avoiding brush rotating.

4Close the recovery tank cover prop-

erly and/or verify the gasket wear.

3Check if the solution ﬁlter is

cleaned.

Autres manuels pour Advance SC400

Table des matières

Autres manuels Nilfisk-Advance Scrubber

Nilfisk-Advance

Nilfisk-Advance 56390916 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC350 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BA 855 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BR 752 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 908 7144 020 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Hydro-Retriever 2052 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC6000 36C Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Kent 56302300 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BA 340 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Advance SC8000 48 LPG Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance PS 333 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 56390926(850SC) Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Captor 5400 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC800 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC401 Series Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 56315036(28D) Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Liberty SC60 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Warrior ST Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW4000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance CA 340 ET Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Advance SC900 ST-28D Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC351 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance AquaRide Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC351 Guide de l'utilisateur

Manuels Scrubber populaires d'autres marques

Olympus

Olympus M200H Manuel utilisateur

Clarke

Clarke BEXT 100H Manuel d'installation et d'exploitation

JOHNY VAC

JOHNY VAC JVC70BCT Manuel utilisateur

RCm

RCm Elan Series Manuel

Kärcher

Kärcher B 120 W Manuel utilisateur

Truvox

Truvox Orbis MotorScrubber 20 Manuel utilisateur

Numatic

Numatic TTB 4045/100 Manuel utilisateur

U.S. Products

U.S. Products PEX 500-C-TICK Mode d'emploi

Mclennan

Mclennan C510 Manuel utilisateur

Tennant

Tennant T20 LPG Manuel utilisateur

Columbus

Columbus ARA 66 BM 100 Manuel utilisateur

Numatic

Numatic TTV 678G / 300T Manuel utilisateur

American-Lincoln

American-Lincoln 505-945 Manuel utilisateur

FIORENTINI

FIORENTINI ET 65-75 Manuel utilisateur

Floorpul

Floorpul ruby 48 blt Guide de l'utilisateur

Onyx

Onyx RX-34 Manuel utilisateur

Dustbane

Dustbane Hurricane 400 Manuel utilisateur

Sana

Sana EUJ-702 Manuel utilisateur