Night Stick 5522-BATT Manuel utilisateur
Instructions – 5522-BATT
WARNINGS
yWARNING: It is recommended that a qualied technician perform the replacement
of the rechargeable battery pack in this light.
yWARNING: Failure to follow these instructions may impair the intrinsic safety of
this ashlight.
yWARNING: To prevent ignition of a hazardous atmosphere, do not open the lens
bezel in the hazardous environment. This task must only be performed in an area
known to be non-hazardous.
yWARNING: When exchanging the rechargeable battery pack, use only the
approved 5522-BATT rechargeable battery pack from bayco products.
yWARNING: To prevent ignition of a hazardous atmosphere, the rechargeable
battery pack must only be exchanged in an area known to be non-hazardous.
REPLACING THE LITHIUM-ION RECHARGEABLE BATTERY
yLoosen the locking screw on the side of the bezel. CAUTION: Do NOT remove
the locking screw.
yUnscrew the lens bezel from the housing in a counter-clockwise direction.
yLoosen each of the two charger contact pins located below the Floodlight Lens.
These two screws should be loosened until approximately 1/8” of thread is visible.
CAUTION: Do NOT remove these two screws.
yTurn the light upside down and remove the reector/circuit assembly. CAUTION:
Do NOT touch the reector surface with your nger. Doing so may damage the
reector surface.
yRemove the old 5522-BATT rechargeable battery pack paying attention to the
battery pack’s orientation within the handle. Please recycle the used battery.
yUsing only the approved replacement 5522-BATT rechargeable battery pack from
Bayco Products, slide the new battery pack into the handle of the light using the
directional arrow marked on the side of the pack as a guide for proper orientation.
yAlign the reector/circuit assembly so that the switches on the assembly are aligned with
the switches on the housing. Fully insert the assembly back into the ashlight housing.
yTighten both of the charger contact screws fully.
yReplace the lens bezel onto the housing in a clockwise direction until tight.
yTighten locking screw located on the side of the lens bezel. CAUTION: Do NOT
over-tighten. Doing so may damage the threads.
WARRANTY
2-Year Limited Warranty. Go to www. nightstick.com for warranty information.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098
1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-5522-BATT-21
Instructions – 5522-BATT
WARNINGS
yWARNING: It is recommended that a qualied technician perform the replacement
of the rechargeable battery pack in this light.
yWARNING: Failure to follow these instructions may impair the intrinsic safety of
this ashlight.
yWARNING: To prevent ignition of a hazardous atmosphere, do not open the lens
bezel in the hazardous environment. This task must only be performed in an area
known to be non-hazardous.
yWARNING: When exchanging the rechargeable battery pack, use only the
approved 5522-BATT rechargeable battery pack from bayco products.
yWARNING: To prevent ignition of a hazardous atmosphere, the rechargeable
battery pack must only be exchanged in an area known to be non-hazardous.
REPLACING THE LITHIUM-ION RECHARGEABLE BATTERY
yLoosen the locking screw on the side of the bezel. CAUTION: Do NOT remove
the locking screw.
yUnscrew the lens bezel from the housing in a counter-clockwise direction.
yLoosen each of the two charger contact pins located below the Floodlight Lens.
These two screws should be loosened until approximately 1/8” of thread is visible.
CAUTION: Do NOT remove these two screws.
yTurn the light upside down and remove the reector/circuit assembly. CAUTION:
Do NOT touch the reector surface with your nger. Doing so may damage the
reector surface.
yRemove the old 5522-BATT rechargeable battery pack paying attention to the
battery pack’s orientation within the handle. Please recycle the used battery.
yUsing only the approved replacement 5522-BATT rechargeable battery pack from
Bayco Products, slide the new battery pack into the handle of the light using the
directional arrow marked on the side of the pack as a guide for proper orientation.
yAlign the reector/circuit assembly so that the switches on the assembly are aligned with
the switches on the housing. Fully insert the assembly back into the ashlight housing.
yTighten both of the charger contact screws fully.
yReplace the lens bezel onto the housing in a clockwise direction until tight.
yTighten locking screw located on the side of the lens bezel. CAUTION: Do NOT
over-tighten. Doing so may damage the threads.
WARRANTY
2-Year Limited Warranty. Go to www. nightstick.com for warranty information.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098
1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-5522-BATT-21
Table des matières
Autres manuels Night Stick Lampe de poche
Night Stick
Night Stick NSK-NSR-2522RM Manuel utilisateur
Night Stick
Night Stick NSR-9940XL Manuel utilisateur
Night Stick
Night Stick USB-588XL Manuel utilisateur
Night Stick
Night Stick MT-210 Manuel utilisateur
Night Stick
Night Stick Xtreme Lumens TWM-850 Manuel utilisateur
Night Stick
Night Stick TAC-550 Manuel utilisateur
Night Stick
Night Stick Xtreme Lumens TWM-350 Manuel utilisateur
Night Stick
Night Stick TAC-500 Manuel utilisateur
Night Stick
Night Stick NSR-9612 Manuel utilisateur
Night Stick
Night Stick XPP-5422GX Manuel utilisateur
Night Stick
Night Stick NSR-9920XL Manuel utilisateur
Night Stick
Night Stick TAC-460XL-K01 Manuel utilisateur
Night Stick
Night Stick NSP-1162 Manuel utilisateur
Night Stick
Night Stick VIRIBUS XPR-5580G Manuel utilisateur
Night Stick
Night Stick XPP-5410G Manuel utilisateur
Night Stick
Night Stick FDL-300R-K01 Manuel utilisateur
Night Stick
Night Stick TAC-460XL-K01 Manuel utilisateur
Night Stick
Night Stick Fortem XPP-5466 Manuel utilisateur
Night Stick
Night Stick NSP-2414GXL Manuel utilisateur
Night Stick
Night Stick XPR-5522GM Manuel utilisateur
