Nextiva S4100 Series Installation Guide
www.verint.com/manuals 4
For more information, refer to the Nextiva S4100 Series User Guide, which is available on www.verint.com/manuals.
© 2007-2009 Verint Systems Inc. All Rights Reserved Worldwide. 23-500-0029-004
6. In the Passkey box, enter the wireless passkey common to the
transmitter and receiver. This user-supplied passkey is case sensitive
and must have exactly 16 characters.
7. In the Video Quality box (two boxes are available for a -2V product),
select the desired video quality. For the definition of the six available
presets, refer to the Nextiva S4100 Series User Guide.
8. Click Save. The S4100-T receives its configuration through the
wireless network. The devices reboot.
9. In the Unit Wireless Configuration window, click Close.
10. In the SConfigurator window, click Exit.
11. Unplug the Ethernet cable from the S4100-R device, then put back the
dust cap on the network (RJ-45) connector.
12. Connect the monitor and camera to the devices; ensure that RF and
video communication works properly in your wireless system.
13. Change the IP address of the computer back to its original value.
Installation
1. Fix the mounting assembly on the device, then install the device in its
final location. For instructions, refer to the Nextiva S4X00 Mounting
Assembly Installation Guide included with the mounting assembly set.
2. Remove the dust caps from the main (Video/Serial/Power) and
optionally the auxiliary connectors.
3. Plug the video/serial/power cable on the main connector of the S4100
device. To properly install the cable connector on the device, use your
hands and turn until it blocks. Do not use pliers.
4. Plug the BNC video connector of the video/serial/power cable on the
target equipment associated to video 1.
5. Perform the serial connection to the target equipment.
6. If your device is a -2V model:
a. Connect the second video/serial/power cable to the Auxiliary
connector of the S4100 device.
b. Plug the BNC video connector of the second video/serial/power
cable on the target equipment associated to video 2.
c. Perform the serial connection to the target equipment.
7. If you purchased the alarm/audio option, plug the supplied
alarm/audio cable into the Auxiliary connector of the device.
For more information about surge protection, refer to the “Surge
Protection” appendix in the Nextiva S4100 Series User Guide.
8. To properly fuse the power supplied to the wireless device, install a
fuse between the power source and the power cable. The fuse must
have the following ratings: UL Listed, 250V, 2.5A, Fast-Acting.
9. Power up the S4100 device.
10. Repeat step 1 to step 9 for the second device.
Note: You must install the mounting assembly on the S4100. It is
required to properly mount and securely ground the wireless
device.
Tip: For easy maintenance, it is strongly recommended to plug an
outdoor Ethernet cable on the device and to run it down the pole.
Tie the cable to the pole 2 feet (0.7 meter) or less below the device,
while ensuring that there is no tension between the device and the
tie point. Insert the other end of the cable in a waterproof electrical
box for outdoor applications. Add external surge protection near the
device to protect the Ethernet port.
Tip: If you are installing the S4100 equipment in a lightning prone
environment or in a site where large AC mains power fluctuations
are a common occurrence, add external surge protection to secure
your equipment.
Tip: If the S4100 is directly exposed to the sun in an environment likely
to reach 122°F (50°C), install a sun shield. Otherwise, reduce the
maximum operating temperature by 18°F (10°C) to protect the
equipment; that is, without a sun shield, the maximum temperature
should be 104°F (40°C).
