Zigbee Pushbutton Interface 2-gang 230 V
7 Commissioning
Commissioning is carried out via the NEXENTRO Config App, which step by step guides you
through the commissioning. This requires a mobile end device (smartphone or tablet) with a
Bluetooth interface and the Android or iOS operating systems.
The NEXENTRO Config App for the operating systems Android or iOS must be down-
loaded from the App Store (iOS) or Google Play Store (Android) and then installed.
App functions
– Joining an existing network
– Setting up your own network
– Assigning a device name
– Setting device parameters: Operating mode, venetian blind movement direction, scenes,
switch-on behaviour (dimming level, colour temperature)
– Connect the push-button interface to Zigbee actuators and Zigbee lamps
– Displaying the switching status of the connected switches or push-buttons
– Displaying device information: Device type, software version, hardware version
– Performing a software update
– Resetting to the default setting
The following operating modes can be set via the app:
–Control: For operation with one or two push-buttons for switching on and off and dimming
lights (default setting). When the push-button is operated, the load is switched over, e.g.
lights that are switched on are switched off and vice versa.
–Switch: For operation with one or two switches for switching loads on and off. When the
switch is operated, the load is switched over, e.g. lights that are switched on are switched
off and vice versa.
–Sensor: For operating sensors with relay contact 230 V, e.g. motion detectors. The load is
always switched on when the relay contact is closed and always switched off when it is
opened.
–Scene: For operation with two push-buttons for opening individual scenes.
–OFF: Input unused.
–Blinds: For operation with two push-buttons for operating a venetian blind or a shutter.
Registering new devices in the NEXENTRO Config app
NEXENTRO devices must be registered for commissioning in the NEXENTRO Config App. To
do this, the new unit must be put into pairing mode, which is active for approx. 1 minute after
mains voltage recovery.
￭ Re-energise the NEXENTRO device and start the search in the NEXENTRO Config App.
￭ Add the new device to the list of registered devices.
￭ Assigning device names (optional).
With a registered device, connecting to a terminal is possible at any time.
Adding a push-button interface to a Zigbee network with gateway
To be able to control devices of a Zigbee network, the push-button interface must be added to
the network.
With certain gateways, adding to a network is done via the Touchlink function, see http://
www.nexentro.de/help.
￭ Start the search mode for new devices in the app of the gateway to open the network for
further Zigbee devices. The function call depends on the gateway, e.g. "Search devices".
￭ In the NEXENTRO Config App, set the operating mode for both inputs of the push-button
interface.
￭ Select the Join Network function.
The push-button interface joins the Zigbee network.
5 / 8
82403320 17.11.2021
