
1. Hold the down-rod vertically with Slit side downward.
2. Pass the connection wires through slit hole at the Bottom end of
down rod (3) and remove them from the top end of down rod
(Figure 2). Slide canopy stopper (4a) from bottom side & ensure
connection wire will be aligned with stopper slot (Figure 6a).
3. Insert the bottom end of down rod (3) (with slit) on spindle (6)
and insert bolt (7) Place the plain washer (8), spring washer (9),
and fully tighten nut (10), insert the split pin (11) in the small
hole on the bolt end and open the ends, so that it does not fall
off. The assembly of bolt (7), plain washer (8), spring washer
(9), nut (10), split pin (11) is separately packed with hanger
assembly (18).
4. Align hole in downrod (3) and slot in canopy stopper(4a) and
push canopy stopper (4a) from top to rest it on bolt (3) &
connect connection wire to the terminal block. (Figure 3).
5. Slide the bottom canopy (4) from top end of down rod (3) and
rest it on canopy stopper (4a) (Figure 4).
6. Slide the top Canopy(5) in Bottom canopy (4) and push it
downward. (Figure 5)
7. Slide the false ceiling cover (5b) from top end of down rod (3)
and rest it on top canopy (5) (Figure 5).
8. Remove the split pin (17), nut (16), spring washer (15), plain
washer (14), bolt (13), at the bottom end of hanger assembly
(12).(Figure 6)
9. Place hanger assembly (12) in ceiling hook in such a way that
rubber reel (18) rests on the ceiling hook.
10. Insert the top end of down rod (3) between the steel clamps of
hanger assembly (12). Match the holes with holes in down rod
(3). Insert bolt (13), place plain washer (14), spring washer (15),
and fully tighten nut (16), insert the split pin (17) in the small hole
on bolt end and open the ends, so that it does not fall off.
11. Assemble top canopy (5) and false ceiling cover (5b) together
and lift the Top canopy (5) and false ceiling cover (5b) to cover
hanger assembly and fix with screw (5a) (Figure 6).
12. Connect the regulator (not supplied along with fan) in the series
with fan.
Figure 6
Figure 6 a
Classification | Internal
CONNECTION
WIRES
TERMINAL
BLOCK
16
14
17
15
12
13
TOP END OF
DOWN ROD
6
7
9
11
10
8
1
2
7a
BOTTOM END OF
DOWN ROD
WITH SLIT
MOTOR
BODY
THERMO BUFFER
18
4
5
3
SCREW
5a
Canopy stopper
4a
5b
CONNECTION
WIRES
CANOPY
STOPPER