1. Open the App’s Home Screen. Here you will see listed all the Devices that you have paired.
Press > to the right of “Sensor”. This will take you to the SENSOR List page where you can
choose the Sound you will hear on your phone when an Alarm notification is received from a
Sensor. Press the icon on the right hand side of each Sensor to select the mode.
Alert Mode = Siren Sound (5 seconds repeated twice) + incoming Notification
Chime Mode = Short Alert Tone + incoming Notification
Silent Mode = No Siren, no Alert Sound, just the Notification
Off Mode = No Siren, no Alert Sound and no Notification (All alerts from the Sensor will still
be listed the DEVICE’s HISTORY page).
2. Whilst you are still on the SENSOR page, press the small circle around the raised line on the
top of the Button. You will see the blue LED flash once followed, a few seconds later by a
further two quick flashes, to indicate a notification Alert has been sent to the APP. If you see
3 flashes, it means the Alert has not been sent, so wait 20 secs and repeat the process.
Depending on the Alert Mode you have chosen, this will be audible or silent. You will see the
notification appear on your phone and a red dot light up alongside the activated Device. Press
the “Refresh”Button in the middle of the top of the page to cancel the red dot. If you now
press the Device’s name or picture, you will be taken to its MAIN PAGE. On this page you can:
i) Toggle between turning a Local Alarm ON or OFF (On means that when the sensor is
triggered, the optional Netzhome WIFI socket with built-in buzzer will also start go into alarm
for 5 minutes, or until manually turned off by pressing a button on the socket.)
ii) Check the “History”which will list the last 30 notifications time and date stamped.
iii) Click on “Off Time”to get to the “Device Disabled Settings”. Here you can select up to 4
daily periods in which the Sensor is automatically switched to Off Mode. You can also
temporarily turn the Device to be always OFF by selecting the Off Mode - see 1 above.
a) Tap on One of the 4 periods to take you to the Time Selection Screen.
b) “From”will be flashing. Click AM or PM at the bottom of the screen. Select the Hour on the
dial and click “From”. Now select the minute on the dial. Click “To”and repeat the procedure.
Click OK to save.
c) You will now be taken to the “Repeat”Screen. Click on the days of the week you wish to
repeat the Device to be automatically disabled for this period and click OK. The Disabled Time
will now be displayed along with the illuminated days to which it applies.
Advanced Information for the DEVICE MAIN PAGE
