9
Most of the sensor settings are the same as any other sensor configuration (page 39 of the ENVIROMUX-xD manual) but for the
DC Current Sensors there are some differences:
Sensor Settings Description
Sensor Unit The default Sensor Unit is “%”. When a sensor value report that is a percent of its full scale is
desired, use this unit. The value of all hall effect sensors will be reported accurately with this
setting, regardless of their nominal range.
Note: If the Nominal Range (below) is changed from the default “100”, the Sensor Unit
must be changed to “A” or “Amps” to properly represent the value reported on the
sensor Status and Summary pages.
Nominal Range The default Nominal Range value is “100”. When combined with the default Sensor Unit of
“%”, this value will allow the ENVIROMUX to report accurately any hall effect sensor that is
connected, regardless of its range.
However, if you wish to have the value on the sensor Status or Summary page reported in an
accurate range of amperage, change this value to the maximum capacity of the connected hall
effect sensor and be sure to change the Sensor Unit value (above) to “Amps”.
TECHNICAL SPECIFICATIONS
Description Specification
Polling rate 1Sa/s
DC Voltage Range Non-isolated -60 to +60V DC
DC Reporting Accuracy 1.2VDC
DC Resolution 0.12VDC
Current Measurement Requires Hall-Effect transducer (sold
separately)
Power 12VDC from AUX PWR or AC Adapter or
CATx cable from ENVIROMUX Sensor port
Voltage Range Absolute maximum 10.8VDC to 16.5VDC
Current Draw 34mA (without load) +26mA per Hall Effect
Sensor Connected (190mA Maximum)
Size (In.) W x D x H 6.83 x 3.0 x 1.75
Regulatory Approvals CE, RoHS
COPYRIGHT
Copyright © 2009-2017 Network Technologies Inc All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written consent of Network Technologies Inc, 1275 Danner Drive , Aurora, OH 44202.
CHANGES
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the
right to make changes in the product design without reservation and without notification to its users.
WARRANTY INFORMATION
The warranty period on this product (parts and labor) is two (2) years from date of purchase. Please contact Network
Technologies Inc at (800) 742-8324 or 330-562-7070 for information regarding repairs and/or returns. A return authorization
number is required for all repairs/returns.
MAN257 Revised 6/22/2017
