4. Set up Instruction
On/Off
Power on
Insert batteries. (Open the battery back cover and insert two 1.5V AA size
batteries into the battery slot)
Turn on Press and hold the function key till the green indicator flashes once.
Turn off
(Restore to factory setting)
Press and hold the function key for 5 seconds till the green indicator flashes
20 times.
Power off Remove batteries
Note
1. After insert batteries and press the button at the same time, the device
will be in engineering test mode.
2. Remove and insert the battery; the device will remember the previous
on/off status by default.
3. On/off interval is suggested to be about 10 seconds to avoid the
interference of capacitor inductance and other energy storage
Network Joining
Never joined the network
Turn on the device to search the network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Had joined the network
(not restore to factory setting)
Turn on the device to search the previous network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Fail to join the network
Suggest to check the device verification information on the gateway or
consult your platform server provider.
Press and hold for 5 seconds
Restore to factory setting / Turn off
The green indicator flashes 20 times: success
The green indicator remains off: fail
Press once
The device is in the network: The green indicator flashes once and sends a
data report
The device is not in the network: The green indicator remains off
Sleeping Mode
The device is on and in the
network
Sleeping period: Min Interval.
When the reportchange exceeds setting value or the state changes: send a
data report according to Min Interval.
The device is on but not in
the network
1. Suggest to remove batteries if the device is not used.
2. Suggest to check device verification on gateway.
Low Voltage Warning
Low Voltage 2.4V
