Enquiries: 0344 482
1414
hp://www.neostar-electronics.co.uk
Seng the Relave Humidity to the Desired Level
1. Switch the unit on by flicking the on/off switch to the on posion, wait a few seconds unl the RH level
display (4) reads the current RH level.
2. Press the RH up or down buons (5) to select your desired RH level.
3. The display will flash ten mes, then revert to showing the current environment RH.
Emptying the W
ater
Tank
1. The Dehumidifier will automacally turn offonce tank is full.
2. The tank full LED (3) will turn on (yellow).
3. Before removing the water tank, switch the unit offby flicking the on/offSwitch (1) to the offposion.
4. Insert twofingers into tank pull-out handle (10) and gently slide out the water tank.
5. Pull out the plug from the water displacement hole (11).
6. Pour the water out of the tank into a drain or sink.
7. Re-insert the plug and slide the tank back into device unl it clicks.
8. The device is now ready to use again.
Cleaning and Maintenance Instrucons
To clean:
1. Disconnect the power cord from the mains.
2. To clean the air vents use a sobristled brush to remove dust buildup.
3. To clean the water tank, remove the water tank. Clean the water tank filter using a neutral detergent
and a sobristled brush or cloth. Clean the inside of the water tank using a sobrush or cloth and a
neutral detergent. Clean offthe detergent using clean water, and dry with a dry socloth.
4. Clean the mainunit with a neutral detergent and a socloth. When you have finished ensure that no
water is leon the control panel. Cleaning is now complete.
WARNING:Always unplug the product from the electrical supply before cleaning.
Always ensure that the product is completely dry before plugging it back into the mains electricity supply
and switching the unit back on.
Specificaon
Model number : MD898
Power supply : AC 230V ~ 50Hz
Power consumpon : 60W
Capacity : Approximately 750ml per day
Water tank capacity : 2 litres
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
The crossed out Wheelie Bin logo is used to highlight electrical products that should not be
disposed of with normal household waste. Scos Ltd has contributed to the funding of an
alternave network of UK recycling facilies. Please visit www.recycle-more.co.uk to find where
your nearest recycling point is and recycle this product at the end of its life.
Made in China for Scos Ltd. 910-241400-0120-100