5
Electricity supply installation must be carried out in accordance with
regulations in force.
To avoid danger of lesions or death due to electrical current, we
suggest to disconnect tension from the feeding line before doing any
cable or regulation operation.
To assure a good separation from the line, install a sectioning device
with differential protection of 30mA at the start of the electrical line.
Never clean the device with solvents or jets of water.
Before doing any cleaning or maintenance operation be sure of having
disconnected the device from the line. For more certainty we suggest to
disconnect electrical connections.
Eventual repairs must only be carried out by qualified staff at a service
centre authorized by the manufacturer.
Always require exclusive use of original spare parts. Failure to comply
with this stipulation could compromise safety and forfeit warranty
benefits for the device.
In the event of trouble or doubts, please refer to your trust retailer or
directly to the producer.
2. ACCESSORIES
The ALì SW power supply unit comes assembled in a box and ready for
connection. The appliance consists of:
Electrical power supply enclosed in plastic container.
200 mm connection cable. Also available in 800 mm length on request.
Touch-switch button on commercial cover with arrows indicating direction.
(Product is on VIMAR module IDEA series, but other types of models can
be supplied on request).
3 module support for insertion on boxing or externally (supplied only on
request).
External cover plate (supplied only on request).
Instructions manual.
3. ELECTRICITY SUPPLY
The ALì SW power supply is for connection to grids with alternate current from
100V~ to 240V~, 50÷60Hz.
This product has been designated as a Class II safety product.
6
4. ASSEMBLY AND ELECTRICAL CONNECTION
These indications are intended for the attention of technicians and specialized
personnel. Basic job and safety techniques are therefore not included.
4.1. Requirements and checks
All operations for preparation, assembly and electrical connection must be
performed by competent and specialised technical personnel to guarantee
optimal performance and good function of the appliance.
First check that the following basic conditions have been met:
Remove the unit from its packaging and visually check for any damage that
may have occurred during transport.
Unit performance must be sufficient to guarantee the energy required for
correct function of the motor in question, do not exceed the limits indicated
in the technical data table for the product (p. 7).
Attention: Make sure that output tension corresponds to that required for
function of the motor in question to avoid compromising good function.
Check that electrical wiring is appropriate and has the correct section
dimensions to comply with safety standards in force.
Check that the casing for the unit has been correctly fitted, is easily
accessible and does not impede the control action for the motor connected.
4.2. Electrical connection to grid
Remove the support plate and place to one side. Check the two fixing
screws are present. If not, use appropriately sized screws.
Remove the unit from the packaging box in preparation for connection. Do
not open the plastic container, connection can be performed externally.
Connect the two electrical grid wires to the terminals in the plastic box area
marked “100÷240VAC”. Do not connect the earth wire, the unit has double
Class II safety insulation.
Connect the two wires supplying power to the motor to the other terminal
board marked with “24VDC”.
Attention: terminals which have not been connected properly could
damage the appliance and compromise safety.
Check wires have been inserted completely into the terminal and ensure
screws have been appropriately tightened.
Remove any dust or residual waste created during connection from the
wall box (or other container) and check that the electrical wires can be
placed in position free of obstacles, crushing or damage.
Insert the unit into the wall box.
Check that the connectors for the cables between the unit and the touch-
switch have been inserted correctly. If cabling has been disconnected, take
