NAVTEK NRP6Di Manuel utilisateur
www.navtek.ie
www.navtek.uk
Made in China
Smart Vacuum Pump
NRP6D NRP8D NRP6DV NRP8DVi i
User Manual
NRP6DV
110V-120V 50/60Hz
220V-230V 50/60Hz
6 CFM
15 micron
3/4
15
14x5.3x11.9
25.35
1/4", 3/8", 1/2" Flare
NRP8DV
110V-120V 50/60Hz
220V-230V 50/60Hz
8 CFM
15 micron
3/4
15
14x5.3x11.9
25.35
1/4", 3/8", 1/2" Flare
NRP6Di
110V/60Hz
6 CFM
15 micron
3/4
15
14x5.3x11.9
25.35
1/4", 3/8", 1/2" Flare
NRP8Di
110V/60Hz
8 CFM
15 micron
3/4
15
14x5.3x11.9
25.35
1/4", 3/8", 1/2" Flare
Oil level sight glass
NAVTEK inverter drive dual-stage rotary vane vacuum pumps are used to remove air, moisture, and
other non-condensables from sealed HVACR systems. The products can be used for evacuation of
HVACR repair and new installations, with refrigerants including CFC, HFC, HCFC, and , such as A2L
R-12, R-22, R-410A, R-404A, R-134A, R-32, 1234yf, etc.
26 lbs (11.8 kg).
NAVTEK
1. Verify the power supply being used, to match the voltage on the nameplate.
2. Ensure that the pump is switched off prior to connecting to the power source.
3. Check for proper oil level, or change if needed.
4. Remove the oil fill cap, filling oil to the level in between the two oil sight glass lines, as shown in the
drawing below. For specific pump oil volume, please see the technical specification table.
Note: In order to avoid personal injury, please carefully read and follow the instructions in this user
manual and the user guide of the pump.
NAVTEKVACUUM PUMPS ARE NOT ALLOWED TO BE USED FOR A3 OR FLAMMABLE
REFRIGERANTS.
1. NEVER CONNECT A VACUUM PUMP TO A PRESSURIZED SYSTEM. Always check to make
sure that system and piping pressure is NOT ABOVE ATMOSPHERIC PRESSURE.
2. When handling refrigerants, please wear an eye-protection such as safety glasses or goggles.
3. Avoid direct physical contact with refrigerants, you will get burned.
4. When connecting the power source, all equipments must be grounded in order to prevent
electrical hazards.
5. When the pump is in operation, the enclosure surfaces will be hot. Do not touch the oil box or the
motor case. Allow adequate ventilation space for heat dissipation.
6. When using R-32, 1234yf or other flammable refrigerants, use an explosion proof electrical outlet.
7. Keep pump dry and away from water, mud, and dirt at all times.
8. Operating pump with intake fittings open to the atmosphere must not exceed 3 minutes.
Power outlet must be grounded.
(right).
NAVTEK
NAVTEK
one
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels NAVTEK Pompe à eau
Manuels Pompe à eau populaires d'autres marques
Sykes AmeriPumps
Sykes AmeriPumps GP100M Guide de dépannage
DUROMAX
DUROMAX XP WX Series Manuel utilisateur
BRINKMANN PUMPS
BRINKMANN PUMPS SBF550 Manuel utilisateur
Franklin Electric
Franklin Electric IPS Manuel utilisateur
Xylem
Xylem e-1532 Series Manuel utilisateur
Milton Roy
Milton Roy PRIMEROYAL Manuel utilisateur