Nautilus EV7.16 Manuel utilisateur

Model: EV716 & EV718

P/N: 000-3603 Rev D (5/05/2007)

Assembly Manual

Pro Series Elliptical

EV718 model

EV716 model

iMPORTANT SAFETY PRECAUTiONS

SAVE THESE INSTRUCTIONS

The following deﬁnition applies to the word “Warning” found throughout this guide:

Read All Instructions

1. Read, understand and carefully follow all warnings, instructions and procedures in this manual. Failure to do so can produce a

serious electrical shock hazard or other serious injury.

2. Due to the elliptical trainer’s size and weight, the unit requires (2) people to move and assemble.

3. Carefully unpack the machine.

4. Connect the AC power cord to a properly grounded AC wall outlet.

5. After the elliptical is assembled, read through your Owner’s Manual for complete safety information,installation requirements

and operating instructions, electrical shock hazard or other serious injury.

Failure to follow the conditions set forth below shall limit, to the extent allowed by law, Nautilus, Inc. responsibility for the safety,

reliability, and performance of this equipment.

• The operator manual must be read in full by each owner and trainer before the product is ﬁrst used. Each user must be instructed

in the proper use of the elliptical and its accessories.

• The equipment must be used in accordance with the instructions for use.

• Only Nautilus-trained or Nautilus-authorized personnel should carry out assembly operations, extensions, readjustments,

modiﬁcations, or repairs.

7!2.).'

!44%.4)/.

$!.'%2

)--%$)!4%!#4)/.2%15)2%$

#!54)/.

Used to call attention to POTENTIAL hazards that could result

in personal injury or loss of life.

Nautilus® Pro Series Elliptical Assembly Manual

HARDWARE

Required Assembly Tools

• Torque Wrench

• 10 mm Allen Wrench

• 13 mm Box Wrench

• 19mm Socket

• 6 mm Allen Wrench

• Adjustable Wrench

• 17mm Socket

• 8 mm Allen Wrench

• Long and short #2 Phillips Screw Drivers

• 3/8” drive ratchet with 6mm, 8mm, and 10mm hex bit sockets will speed the assembly

process greatly.

Hardware Contents

Item Number Item Description Quantity

120mm Allen Head Bolt 4

21/2” Spring Washer 4

615mm Phillips Head Screw 36

10 70mm Hex Head Bolt 2

11 8mm Washer 4

12 M8Locking Nut 2

14 M10 x 65mm Allen Head Bolt 6

15 M10 Washer 12

16 M10 Locking Nut 6

17 M12 x 70mm Allen Head Bolt 8

18 M12 Spring Washer 8

19 M12 x 100mm Allen Head Bolt 4

21 M12 Locking Nut 6

25 M12 x 90mm Allen Head Bolt 2

28 M8 x 40mm Allen Head Bolt 4

30 30mm Phillips Head Screw 6

34 10mm Phillips Head Screw 13

37 15mm Machine Screw 2

39 35mm Pan Head Bolt 6

42 M8 Spring Washer 4

REFERENCE CHART

Actual Size Hardware Reference Chart

#17 M12 x 70mm Allen Head Bolt

#1 20mm Allen Head Bolt

#2 1/2” Spring Washer

#6 15mm Phillips Head Screw

#10 70mm Hex Head Bolt

#11 8mm Washer

#12 M8 Locking Nut #34 10mm Phillips Head Screw

#30 30mm Phillips Head Screw

#28 M8 x 40mm Allen Head Bolt

#18 M12 Spring Washer

#21 M12 Locking Nut

#42 M8 Spring Washer

Nautilus® Pro Series Elliptical Assembly Manual

REFERENCE CHART

Actual Size Hardware Reference Chart

#39 35mm Pan Head Bolt

#14 M10 x 65mm Allen Head Bolt

#15 M10 Washer

#16 M10 Locking Nut

#25 M12 x 90mm Allen Head Bolt

#37 15mm Machine Screw

#19 M12 x 100mm Allen Head Bolt

.AUTILUS¸%6%64ORQUE3ETTINGS

When assembling the EV716 and EV718, please reference and use the torque settings on this page.

You must use the correct torque settings to ensure proper assembly and safe usage.

600 kg•cm

200 kg•cm

600 kg•cm

500 kg•cm 500 kg•cm

500 kg•cm

Front View

TORQUE SPECiFiCATiONS

7!2.).'

!44%.4)/.

$!.'%2

)--%$)!4%!#4)/.2%15)2%$

#!54)/.

WHEN ASSEMBLINGTHE EV716 & EV718 IT IS IMPERATIVETHAT

YOU REFERENCE AND USE THE TORQUE SETTINGS LISTED IN

THE ASSEMBLY STEPS. COMPLETE TORQUE SPECIFICATIONS,

INCLUDING PRE-ASSEMBLED SETTINGS, ARE LISTED BLEOW.

Nautilus® EV716/EV718 Torque Settings

Nautilus® Pro Series Elliptical Assembly Manual

TORQUE SPECiFiCATiONS

.AUTILUS¸%6%64ORQUE3ETTINGS

When assembling the EV716 and EV718, please reference and use the torque settings on this page.

You must use the correct torque settings to ensure proper assembly and safe usage.

600 kg•cm

200 kg•cm

600 kg•cm

500 kg•cm 500 kg•cm

500 kg•cm

Rear View

Nautilus® EV716/EV718 Torque Settings

7!2.).'

!44%.4)/.

$!.'%2

)--%$)!4%!#4)/.2%15)2%$

#!54)/.

WHEN ASSEMBLINGTHE EV716 & EV718 IT IS IMPERATIVETHAT

YOU REFERENCE AND USE THE TORQUE SETTINGS LISTED IN

THE ASSEMBLY STEPS. COMPLETE TORQUE SPECIFICATIONS,

INCLUDING PRE-ASSEMBLED SETTINGS, ARE LISTED BLEOW.

ASSEMBLY PROCESS

Step 1: Removing Packing & Shipping Materials

1-1 Use box knive to cut the plastic strapping and remove.

1-2 Remove the box lid and the styrofoam containing the unit covers (Figures 1 & 2).

1-3 Remove the outer box cover (Figure 3).

1-4 Use box knive to cut the shrink wrap on the left side of the unit and remove Console box (set aside). Continue

to remove the shrink wrap and the corner supports (Figure 4).

Figure 1 Figure 2

Figure 3 Figure 4

Console Box

Nautilus® Pro Series Elliptical Assembly Manual

ASSEMBLY PROCESS

1-5 Cut tape holding styrofoam together and remove the side foot pedal box (Figure 5)

1-6 Gently angle styrofoam downward and remove (pull down & outwards) from around pod assembly and swing

arm (Figure 6).

1-7 Remove the side pod assembly (Figures 7 & 8).

1- 8 Repeat Steps 1-5 through 1-7 on the other side.

1- 9 Remove any remaining plastic on base unit.

Step 1: Removing Elliptical from Packing/Shipping Materials

Figure 7

Figure 6

Figure 5

Foot Pedal Box

ASSEMBLY PROCESS

2-1 Use (4) 20mm Allen Bolts (Ref #1) and (4) 1/2” Spring Washers (Ref #2) to attach the rear frame (#3) to the

Base Unit (#4).

NOTE: Tighten bolts in a criss-cross pattern

2-2 Attach the plastic Flange Cover (#5) to the Rear Frame (#3) using (2) 15mm Phillips Head Screws (Ref #6).

NOTE: (Ref #) refers to the Hardward Reference Chart on pages 5 & 6.

Tip: Tilt the Base unit forward, about an inch, while inserting the Allen Bolts

Base Unit

Rear Frame

IT IS HIGHLY RECOMMENDED THAT YOU

DO NOT ATTEMPT TO LIFT, MOVE OR

TILT THE ELLIPTICAL MACHINE WITHOUT

HELP.

7!2.).'

!44%.4)/.

$!.'%2

)--%$)!4%!#4)/.2%15)2%$

#!54)/.

1-10 With the assistance of another person lift base unit from box and set aside.

1-11 Cut strapping on Box 2.

1-12 Remove lid from top of box and set aside. Proceed to assembly instructions.

Step 2: Attach Rear Frame

Autres manuels pour EV7.16

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Nautilus vélo elliptique

Nautilus

Nautilus EV916 Manuel utilisateur

Nautilus

Nautilus BE STRONG E916 Manuel utilisateur

Nautilus

Nautilus E614 Manuel utilisateur

Nautilus

Nautilus EV916 Manuel utilisateur

Nautilus

Nautilus EV916 Manuel utilisateur

Nautilus

Nautilus R614 Manuel utilisateur

Nautilus

Nautilus 2 st OVERHEAD PRESS Manuel utilisateur

Nautilus

Nautilus BE STRONG E916 Manuel utilisateur

Nautilus

Nautilus 6 Series Manuel utilisateur

Nautilus

Nautilus Schwinn 470 Manuel utilisateur

Nautilus

Nautilus EV916 Manuel utilisateur

Nautilus

Nautilus NE 3000 Manuel utilisateur

Nautilus

Nautilus BE STRONG E916 Manuel utilisateur

Nautilus

Nautilus E614 Manuel utilisateur

Nautilus

Nautilus E10 Instructions de montage

Nautilus

Nautilus StairMaster Clubstride 5100 NSL Manuel utilisateur

Nautilus

Nautilus E514c Manuel utilisateur

Nautilus

Nautilus E618 Manuel utilisateur

Nautilus

Nautilus NE 2000 Manuel utilisateur

Nautilus

Nautilus E514 Manuel utilisateur

Nautilus

Nautilus E7000 Manuel utilisateur

Nautilus

Nautilus NE 3000 Manuel utilisateur

Nautilus

Nautilus NE 2000 Manuel utilisateur

Nautilus

Nautilus Schwinn 450 Manuel utilisateur

Manuels vélo elliptique populaires d'autres marques

Weslo

Weslo Momentum 4.0 Elliptical Manuel d'utilisation et d'entretien

Progear Fitness

Progear Fitness Air elliptical pro 1307 Manuel utilisateur

Torque Fitness

Torque Fitness XPLLP Manuel utilisateur

Octane Fitness

Octane Fitness PRO3700C Manuel utilisateur

Xterra

Xterra FS5.8e Manuel utilisateur

Bodyguard

Bodyguard E-40 Manuel utilisateur

Bonn Germany

Bonn Germany Concept 2.2 Manuel utilisateur

Precor

Precor Resolute RSL 620 Manuel utilisateur

NordicTrack

NordicTrack E 9.2 Elliptical Manuel utilisateur

Vision Fitness

Vision Fitness X6600iNetTV Manuel utilisateur

Matrix

Matrix MX-A5x Manuel utilisateur

SportsArt Fitness

SportsArt Fitness ECO-NATURAL Elite E874 Manuel utilisateur

Sears

Sears FREE SPIRIT C249 30737 0 Manuel utilisateur

True

True FS-64 Manuel utilisateur

Sport-thieme

Sport-thieme ST 310 Manuel utilisateur

VIRTUFIT

VIRTUFIT CTR 1.1 Manuel utilisateur

Kettler

Kettler GIRO C 1 Manuel utilisateur

CIRCLE FITNESS

CIRCLE FITNESS E7 Manuel utilisateur