Nature Power 30400 Manuel utilisateur
SAVE THESE INSTRUCTIONS
#30400
Nature Power 400 Watt Power Inverter
User Manual
V1.1-M 11Aug2020
WARNING:
Read carefully and understand all assembly and operation
instructions before operating. Failure to follow the safety rules and other basic
safety precautions may result in serious personal injury.
Intended Use
Parts List
Inverter
O ring to 12V DC car plug cable
O ring to battery clamp cable 1
1
1
1
Parts Description Quantity
Manual
Page 2 of 8
Power Inverters convert DC electricity to AC electricity then offer power to small electrical
equipment and digital products. It has been widely used in cars, steamboats, mobile
office, post and telecommunications, public security and emergency.
Electrical equipment can not be used:
1, Generally capacitive load and perceptual load appliances are inapplicability: Air
condition, high power electric drill, fridge, microwave oven, blender.
2, Not recommend appliances which have strict requirements on power supply, such as
precise equipments. Please refer to appliances manual before use.
This product can expose you to chemicals, including Di (2-ethylhexyl) phthalate (DEHP)
which is known to the State of California to cause cancer, birth defects or other reproductive
harm. For more information, go to www.p65warnings.ca.gov
Este producto puede exponerlo a productos químicos, incluidos Di (2-etilhexil) ftalato (DEHP)
que el estado de California sabe que causa cáncer, defectos de nacimiento u otros daños
reproductivos. Para obtener más información, vaya a www.p65warnings.ca.gov
WARNING
ADVERTENCIA
Page 3 of 8
Specifications
Operating input voltage .................................................................................10-15 VDC
Nominal output voltage ................................................................................115±5 VAC
Nominal input voltage .............................................................................12.8-13.2 VDC
Output frequency ..............................................................................................60±3 Hz
Continuous output power........................................................................... Up to 400 W
USB............................................................................................................. 2 x 5V/2.1A
Surge output power...............................................................................................700W
Waveform
Efficiency (typical)................................................................................................ > 83%
No load current.....................................................................................................<0.4A
........................................................................................ Modified sine wave
Input over voltage shutdown....................................................................15.5±0.5 VDC
Input under voltage shutdown ..................................................................10.0±0.3 VDC
Input under voltage recovery....................................................................12.0±0.5 VDC
Output power overload / short circuit protection.......................................................Yes
Replaceable 12V car plug fuse.................................................................................Yes
Over temperature shutdown.......................................................................149 +5/-10ºF
Over temperature recovery................................................................................140±5ºF
Important Safety Instructions
Page 4 of 8
1. This manual contains important safety and operating instructions for power inverter.
This manual will show you how to use your inverter safely and effectively.
Please read, understand and follow these instructions and precautions carefully.
2. Keep out of reach of children.
3. Do not expose inverter to rain or snow.
4. Use of an attachment not recommended or sold by the unit manufacturer may result in
a risk of fire, electric shock, or injury to persons.
5. Do not disassemble the unit; take it to a qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of electric shock or fire.
6. To reduce risk of electric shock, unplug unit from outlet before attempting any mainte
nance or cleaning. Turning off controls will not reduce this risk.
7. For the most effective use, place the power inverter on a flat surface.
8. Do not place the inverter on or near heating vents, radiators or other sources of heat of
flammable materials.
9. Do not place the inverter in direct sunlight. The ideal air temperature for operation is
between 41° and 95°F.
10. Only connect the power inverter to a 12V battery or power supply. Do not attempt
to connect the inverter to any other power source, including an AC power source.
Connecting to a 6V or 16V battery will cause damage to the inverter.
11. Do not use the inverter with a product that draws a higher wattage than the inverter
can provide, as this may cause damage to the inverter and product.
Operating instruction
Page 5 of 8
Connecting inverter to 12V battery / vehicle
1. Locate the Positive and Negative terminals on the inverter
2. From the POSITIVE (RED) and the NEGATIVE (BLACK) terminals, remove the hex nut,
3. Place the POSITIVE (RED) ring connector onto the POSITIVE (RED) inverter terminal.
Place the NEGATIVE (BLACK) ring connector onto the NEGATIVE (BLACK) inverter
terminal.
4. Put hex nut back on inverter and tighten.
5. Switch the inverter to OFF (O) position. Connect battery clamp to 12V battery, positive
to positive, negative to negative.
or use the 12V DC car plug connecting to the 12V outlet on vehicle.
+
-
Page 6 of 8
Lights and Alarms
Green POWER Indicator Light will illuminate when the inverter is turned On and operating
properly. If the light goes out the DC power source is missing or possibly a fuse is blown.
Red FAULT Indicator Light may illuminate reasons include; overload, output short circuit,
low input voltage and over temperature of the unit.
Alarm: The power inverter will make a beeping sound when the battery voltage is low.
Turn the inverter OFF and disconnect the inverter from battery.
Cautions
1, If more than one device is to be powered, start one device at a time, to avoid a power
surge and overloading the inverter. The surge load of each device should not exceed the
inverter’s Continuous Operation wattage rate.
2, Load devices should not exceed 150 Watt when using in the vehicle.
3, Keep the car running at all times when using the inverter.
4,The inverter draws low amperage from the battery with the main ON/OFF switch turned
on and no load connected. To prevent battery discharge, turn the inverter off when you
are not using it.
Operating
1. Connect the inverter to power source (see inverter connecting section).
2. Switch the inverter’s ON/OFF switch to the ON (I) position.
3. The GREEN LED indicator will light, indicating the inverter is receiving power.
4. Switch the inverter’s ON/OFF switch to the OFF (O) position.
5. Make sure the device to be operated is turned OFF.
6. Plug the device into the inverter’s AC outlet.
7. Switch the inverter’s ON/OFF switch to the ON (I) position.
8. Turn the device on.
9. To disconnect, reverse the above procedure.
Trouble Shooting
Page 7 of 8
Problem
RED LED is ON
Alarm sounds
and/or inverter
does not function
Check for poor connection to battery or
power supply. make sure connection points
are clean.
Unplug the inverter and reverse the clamps.
Switch OFF inverter and change battery.
Switch OFF inverter to lower temperature
and check the load device power rated.
Use a higher capacity inverter or lower
rated device.
Poor contact at terminals
Connection reversed
Battery low
Over temperature
The inverter may not
have the required
capacity to operate the
device
Device does not
operate properly
when first connect
to the inverter
Possible Cause Reason/solution
Page 8 of 8
Please contact Nature Power Products to acquire more information:
1-800-588-0590
www.naturepowerproducts.com
Made in China
Limited Warranty
Nature Power warrants our products to the original purchaser that this product is free from
defects in materials and workmanship for the period of 1 year from date of purchase, In
the case of product defect, contact Nature Power customer service to receive trouble
shooting. If defective part or unit should be returned, a Return Authorization Number must
be issued by Nature Power and the defective part or unit should be returned to the
authorized location at the purchasers’ expense. A dated proof of purchase is required to
receive warranty service. Once received at authorized location and defect proves to be the
result of defective material and workmanship, the defective part or unit will be replaced at
warrantors’ option and returned to the original purchaser at warrantors’ expense. No
refunds will be granted by the warrantor, in the event of buyer’s remorse please contact
your point of purchase within and in adherence to their return policy. Refunds are granted
at the retailers’ discretions.
Table des matières
Autres manuels Nature Power Onduleur
Nature Power
Nature Power 49802 Manuel utilisateur
Nature Power
Nature Power 37100 Manuel utilisateur
Nature Power
Nature Power 38210 Manuel utilisateur
Nature Power
Nature Power 40066 Manuel utilisateur
Nature Power
Nature Power 42015 Manuel utilisateur
Nature Power
Nature Power Solar Generator 1800 Manuel utilisateur
Nature Power
Nature Power 37800 Manuel utilisateur
Nature Power
Nature Power 60032 Manuel utilisateur
Nature Power
Nature Power 38304 Manuel utilisateur
Nature Power
Nature Power 37120 Manuel utilisateur
Nature Power
Nature Power 38330 Manuel utilisateur
Nature Power
Nature Power 37750 Manuel utilisateur
Nature Power
Nature Power 38326 Manuel utilisateur
Nature Power
Nature Power 37002 Manuel utilisateur
Nature Power
Nature Power 40400 Manuel utilisateur
Nature Power
Nature Power Solar Security Light 1600 Manuel utilisateur
Nature Power
Nature Power 37001 Manuel utilisateur
Nature Power
Nature Power Pure Sinewave Manuel utilisateur
