Napoleon PTH55PSS-1 Mode d'emploi

TERRACE AND PATIO HEATER

USER INSTALLATION AND OPERATION

GUIDE

INDEX

General and specifications ……………….1,2

Security and caution …………………….. 3

Tools and accessories required ………… 5

Assembly instructions …………………… 5 - 7

Operation (Lighting Instruction) ………… 9

Parts available to order ………………... 10

Warranty info

Carefully read this guide and all safety information

before assembling and setting up the heater

THIS APPLIANCE IS APPROVED

FOR OUTDOOR USE ONLY

Napoleon Appliance Corporation

214 Bayview Dr., Barrie, Ontario, Canada L4N 4Y8

Phone: 1-705-726-4278 Fax: 1-705-725-2564

Customer service: 1-866-539-2039 or wecare@napoleonproducts.com

READ SAFETY REQUIREMENTS BEFORE OPERATION

1. The installation must conform with local codes or in the absence of local codes, with either

the National Fuel Gad Code, ANSI Z223.1, or CSA B149.1, Propane Installation Code.

2. This outdoor gas appliance is not intended to be installed in or on recreational vehicles

and/or boats.

3. Maintain proper clearances from combustible construction top 45 CM, sides 60 CM.

4. Inspect the hose before each use of the outdoor gas appliance. If it is evident there is

excessive abrasion or wear, or the hose is cut, it must be replaced prior to this outdoor gas

appliance being put into operation. The replacement hose assembly must be that specified

by the manufacturer.

5. Properly locate the gas hose, keep out of pathways where people

may trip over it or in areas where the hose may be subject to accidental damage.

6. Maintenance Instruction

-Keep outdoor gas appliance area clear and free from combustible materials, gasoline

and other flammable vapors and liquids.

-Do not obstruct the flow of combustion and ventilation air.

-Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.

-Cleaning this outdoor gas appliance, including special surfaces, with recommended

cleaning agents, if necessary.

-Check and clean burner tube to remove any insects and insect nests. Blocked burner

tube can lead to a fire.

7. Maintain adequate clearance around air openings into the combustion chamber, clearances

from combustible material. Air passages to the burner & combustion chamber must be open

and clear.

8. Certain materials or items, when stored under the appliance, will be subjected to radiant

head and could be seriously damaged.

WARNING:

1. Children and adults should be alerted to the hazards of high surface temperature

and should stay away to avoid burns or clothing ignitions.

2. Young children should be carefully supervised when they are in the area of the heater.

3. Clothing or other flammable materials should not be hung from the heater, or placed

on or near the heater.

4. Any guard or other protective device removed for servicing, the appliance must be

replaced prior to operating.

5. Installation and repair should be done by a qualified service person. The heater

should be inspected before use and at least annually by a qualified service person.

More frequent cleaning may be required as necessary. It is imperative that control

compartment, burners and circulating air passageway of the appliance be kept clean.

SAFETY RULES FOR OUTDOOR GAS APPLIANCE

1. LP-gas supply cylinder to be used must be constructed and marked in accordance with

the specifications for LP-gas cylinders of the U.S. Department of Transportation(DOT)

Cylinders, or Spheres and Tubes for the Transportation of Dangerous Goods,

CAN/CSA-B339.

2. The gas supply piping and electrical supply (if applicable) shall be done in accordance

with all local and applicable codes. Only those licensed and qualified in the installation

of gas-fired appliances should be engaged to install this appliance.

3. This gas appliance shall be used outdoors and shall not be used in a building, garage or

any other enclosed area. When used in indoor or enclosed area may cause personal

injury or property damage.

4. If this outdoor gas appliance is not in use, the gas must be turned off at the supply

cylinder.

-Storage of this outdoor gas appliance indoors is permissible only if the cylinder is

disconnected and removed.

-Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.

Disconnected cylinders must have threaded valve plugs tightly installed and must not

be stored in a building, garage or any other enclosed area.

5. The pressure regulator and hose assembly supplied with the outdoor gas appliance

must be used.

Replacement pressure regulators and hose assemblies must be those specified by

the manufacturer.

6. The cylinder must be provided with a shutoff valve terminating in an LP-gas supply

cylinder valve outlet specified, as applicable, for Connection No. 510 in the Standard

for Compressed Gas Cylinder Valve Outlet and Inlet Connections, ANSI/CGA-V-1.

7. The cylinder supply system must be arranged for vapor withdrawal.

8. The cylinder used must include a collar to protect the cylinder valve.

This appliance is an infrared transportable heater.

The burner is controlled and adjusted by the gas control knob.

Gas supply is controlled by the valve on the gas cylinder.

The burner is made of stainless steel. Heat diffusion is assisted by the

reflector above.

Technical specification:

●Operating pressure : 11”W.C.

●Maximum output : 45.000 btu/h

●Minimum output : 25.000 btu/h

●Gas consumption at HIGH: 1 kg/h

●Approx. weight ; 27 kg

●Burner orifice size : 1.95 mm

FOR YOUR SAFETY

1. If you smell gas :

a. Close gas supply at cylinder valve.

b. Extinguish all open flame

c. Proceed to a leak test

d. If bubbles are detected, retighten connections. If no leaks are detected,

open gas valve at cylinder and verify if you smell gas.

e. If you still smell gas, shut-off heater completely and gas valve at cylinder.

Call the retailer where you purchased the heater or contact a gas appliance

service center.

2. Never store or handle gas, or any other flammable vapors or liquids in the

vicinity of your Patio Heater or any gas appliance.

CAUTION

●Faulty installation, modifications, repairs or maintenance to the appliance may

be the cause of injury or damage to property.

●Carefully read this User Guide before assembling and setting up the heater.

●Keep this guide for future reference.

●DO NOT operate the heater in an explosive environment. Keep this appliance

away from areas where are gas, or other flammable liquids are stored.

●Before use, verify that no parts are damaged, inspect gas hose.

●Never modify this appliance in anyway,.

●Never use the heater without the reflector.

●Minimum clearance from combustibles are seen in figure 12 must be adhered to.

●Always place heater on a leveled, stable and hard surface.

●Only use this heater outdoors.

●Never clean with abrasive, corrosive or flammable cleaners.

●Do not paint the heater or some of its parts.

●When fully assembled proceed to a leak test.

●A leak test must be performed before operating the appliance.

●NEVER LEAK TEST with an open flame or while smoking.

●The gas cylinder must be closed at all times when not using the heater.

●Children and adults should be made aware of hot surfaces on the heater.

●Clothing and other accessories or object are not to be hung on the heater,

laid on or near it to dry.

●Do not obstruct the ventilation opening (hand hole) on cylinder cover.

●Installation, maintenance and repair of this heater should always be performed

by a qualified gas technician.

PARTS LIST

1 Base

2 Cylinder cover

3 Ventilation opening

4 Post

5 Ignitor

6 Gas control

7 Burner assembly

8 Flame screen

9 Reflector

TOOLS AND EQUIPMENT REQUIRED

10 and 13mm wrench,

Philips screwdriver, medium blade

Leak test solution: MIX 50/50 water and soap

1 Propane cylinder (not supplied), with QCC 1 valve

Attention: Please start to assemble wheel set first before assembling

complete unit.

ASSEMBLY INSTRUCTION FOR WHEEL

(1) Screw * 8

(2) Nut * 2

(3) Wheel * 2

(4) Bracket * 2

(5) Bolt * 2

(6) Base * 1

(7) Nut * 8

(8) Screw * 8

(9) Bracket * 2

(10) Nut * 8

ASSEMBLY STEPS

Fix the 3 vertical supports to the base

using the 3 bolts M8 x 15.

B C

Fasten post to the vertical supports Slide cylinder cover on post.

with 6 bolts M6 X 35 and 6 nuts M6.

Before assembling the burner head on

post, please fix the 3 supported brackets

onto burner head for assembling reflector

Slide hose through bottom of post and

connect to burner head.

Then fasten burner on post with the 4

Philips mechanical screws M6x10mm.

Assemble the reflector pieces to the

middle piece using the small washers and

the acorn nuts.

Place a steel washer over each bolt on

the burner top (figure 8)

Lay reflector over the burner top bolts

add another steel washer to each bolt.

Install a full gas cylinder on the base.

Connect the gas regulator hose to the QCC1

Cylinder valve by turning the knob clockwise

manually.

Do not use a tool, tighten firmly by hand.

Replace cylinder cover.

LEAK TEST

Now that the heater is assembled, for your safety you must perform a leak test of all

connections and hoses.

Mix in a spray bottle equal parts of water and soap.

1. Ensure that the heater gas control knob is fully closed by turning

completely clockwise

2. Open cylinder valve.

3. Apply generously the solution to all connections and hoses.

If you detect bubbles, there is a leak. Close cylinder valve completely. Retighten the

leaking connection and repeat leak test process.

If the leak cannot repaired permanently, close cylinder valve completely and contact

the customer service department at 1-866-539-2039 or a qualified gas technician.

A SAFE LOCATION FOR THE HEATER

CAUTION

When objects are left under a heater in operation, they will be subject to radiant heat

and might be damaged.

●The principal application of this heater is to provide heat to pool and

spa areas, terraces, work areas, etc.

This heater is approved for outdoor use only.

●Provide fresh air ventilation at all times

●Respect minimum clearances to combustibles as shown in figure 11 below.

●Install heater on a leveled, solid and stable ground.

●Do not install in an explosive environment. Keep away from areas from where gas,

vapors or flammable liquids are stored or used.

●In case of high winds, shut-off completely the heater and the cylinder gas valve.

Remove reflector dome.

●Do not move the heater when hot.

CLEARANCES FROM COMBUSTIBLES

Respect clearances as shown:

-Sides of reflector : 60 cm

-Above reflector : 45 cm

OPERATION

TO LIGHT：

1. From ‘OFF’ position, depress knob, turn 90°counter-clockwise and hold.

2. Press the igniter until flame is established.

3. Release the knob and check that the flame stays lit.

4. If the flame goes out, wait 5 minutes then repeat steps 1 & 2 above.

5. For maximum temperature, turn knob fully counter–clockwise.

TO TURN OFF：

1. Turn the knob clockwise to the stop position.

2. Then depress knob and turn fully clockwise to completely

shut off the gas supply.

STORAGE

When heater is not in use for a prolonged period of time, remove

gas cylinder. Verify that the gas valve is closed tightly.

Do not store the gas cylinder indoors.

Store gas cylinder in a well ventilated area.

PREVENTIVE CARE AND MAINTENANCE

Once a year, the heater should be inspected for debris, insects, or spider webs that

could obstruct the burner. The burner area is likely to attract spiders. This may

damage the burner if it is not kept clean of debris.

HAVE HEATER INSPECTED IF ……..

●You smell gas combined with yellow tipped flames on burner.

●Heater does not provide expected heat capacity.

●Burner makes little explosion sounds while operating.

This sound is normal when turning off the heater.

PRECAUTIONS

●Verify periodically for leaks in the system, or immediately when you smell gas.

●In case a leak is detected, put out all open flame in the area.

●Never leak test while smoking.

●If you cannot repair a leak, turn off gas supply at the cylinder valve and contact

the retailer where you purchased the heater or a qualified technician.

●Do not alter or modify in any way.

●The installation of this appliance should be done by a certified gas technician in

accordance with all local, building and municipal codes.

●Contact the manufacturer at 1-866-539-2039 for replacement parts.

Table des matières

Autres manuels Napoleon Chauffage de terrasse

Napoleon

Napoleon PATIOFLAME GPFS40 Manuel utilisateur

Napoleon

Napoleon TERRACE AND PATIO HEATER Mode d'emploi

Napoleon

Napoleon BELLAGIO PTH31GTSSP Manuel utilisateur

Napoleon

Napoleon PTH38PSS, PTH38PCP, PTH38PGM Manuel utilisateur

Napoleon

Napoleon PATIOFLAME GPFR40 Manuel utilisateur

Napoleon

Napoleon Tabletop Patio Heater Manuel utilisateur

Napoleon

Napoleon PTH31GT Manuel utilisateur

Napoleon

Napoleon PTH31GT Manuel utilisateur

Napoleon

Napoleon SkyFire Bellagio PTH31GTSS Manuel utilisateur

Napoleon

Napoleon PTHC38PK Manuel utilisateur

Napoleon

Napoleon PTH-103-3G Manuel

Napoleon

Napoleon SRPH02-XXXX Manuel utilisateur

Napoleon

Napoleon PTH31GT Manuel utilisateur

Napoleon

Napoleon SRPH02S Manuel utilisateur

Napoleon

Napoleon PTHC38PK Manuel utilisateur

Napoleon

Napoleon PTH31GT Manuel utilisateur

Napoleon

Napoleon PATIOFLAME HAMP2 Manuel utilisateur

Napoleon

Napoleon PTH40PGM Manuel utilisateur

Napoleon

Napoleon Patioflame Manuel utilisateur

Napoleon

Napoleon PTH10PSS Manuel utilisateur

Manuels Chauffage de terrasse populaires d'autres marques

empasa

empasa HMXD-E-NHS Manuel utilisateur

Sunred

Sunred Indus Manuel utilisateur

HEAT1

HEAT1 ECO pro-line 2300W Manuel utilisateur

Heatmaxx

Heatmaxx SRPH98 Manuel utilisateur

Sunjoy

Sunjoy A30600640 Manuel utilisateur

Event Furniture

Event Furniture 16091 Guide de dépannage

Prem-I-Air

Prem-I-Air EH1462 Manuel utilisateur

Blumfeldt

Blumfeldt 10028637 Manuel utilisateur

Sunjoy

Sunjoy L-PH011PSS-2 Manuel utilisateur

Melissa

Melissa 670-202 Manuel utilisateur

Quality Heating

Quality Heating THE-12DW Manuel utilisateur

DCS

DCS PHFS-P4 Guide d'installation

EUROM

EUROM 334241 Manuel utilisateur

Lava Heat

Lava Heat Venetian Manuel utilisateur

EHS Ltd.

EHS Ltd. HQH-2000W Manuel utilisateur

VONROC

VONROC ALICUDI PH515AC Manuel utilisateur

OZONA

OZONA Heatflow IF010997 Manuel d'exploitation et d'entretien

theBBQshop

theBBQshop 51611010 Guide de configuration