Mvotem Optics MPD-5S-4C Manuel du propriétaire
1
MPD-5/24S-4C Light Controller
Technical Instructions
This product is our programmable digital controller designed to drive machine
vision LED light source. It has the functions of 256 levels of brightness setting,
light source switching, hardware external trigger light source switching, manual
brightness adjustment, digital display, etc. for LED light source remotely
through RS232 interface. It is especially suitable for complex and high-end
machine vision equipment.
The controller has a mature design, reasonable technology, and stable quality
of selected materials, which ensure a high degree of reliability and strong
adaptability to the environment. At the same time, the controller has the
advantages of small size and simple structure.
2
1. Electrical Parameters
INPUT Voltage Range 88-264VAC
Frequency Range 47-63HZ
OUTPUT
Type constant current
Port 5V 2
Port 24V 2
Adjustment Range 0-100%
Max Current Per port ≤0.4A
Brightness Adjustment Button/host computer
Brightness adjustment level 256 levels
TRIGGER Mode +/-
Trigger Level 5-24V
PROTECTION Surge protection; Over current protection; Overheat protection.
ENVIRONMENTAOL
ADAPTABILITY
Operating Temperature 0 ～ 40℃
Storage Temperature -10 ～ 50℃
Others Size 152x174x52mm
Surface Spray
2. Interface description
P1 Operation panel diagram (front)
3
P2 Operation panel diagram (back)
Note:
CH1 and CH2 is 24V port, CH3 and CH4 5V port.
3. Wiring
Power Output Wire Connection：
P4 Output Connector
24V Plug in model：SMP-03V
1: (to light)
2: NC
3: - (to light)
5V Plug in model：SMP-03V
4
1: + (to light)
2: (to light)
3: NC
RS232 COM：PC port and RS232 plug should be connected with cable
extender.
P5 RS232 Plug
External Trigger Power Input Wire Connection：
P6 External Trigger
4. Operation Instruction
1. Manual Mode
The brightness can be adjusted by the button on the front panel.
Choose the target‘CH’ Output Button.
Press “▲”and“▼” to adjust brightness level.
Level Range: 000~255
Long Pressing “▲”and “▼” button can adjust the level more
5
quickly.
The brightness level value has a memory function, and will not be lost
when the power is turned off.
2. Hardware Trigger Working Mode
MANU is manual mode, when the trigger current is 0V, the lighting
source output works, when the trigger current is 5-24V,the lighting source
output shuts down.
REMO is remote trigger mode. When the trigger current is 0V, the
lighting source output shuts down, when the trigger current is 5-24V,the
lighting source output opens.
Note：Select the "MANU" mode, trigger level is not connected (that is, 0V),
the light source is constantly on.
3. Remote Control Mode
Run the HDPS_4C_V1.0 software on your computer and the following
screen appears:
6
P7 Demo Interface
5. Structure
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Mvotem Optics Contrôleurs
