If the product exposed to the sunlight or very close to heat source?
If the compressor or condenser covered with dust?
If the content inside of the product too much or there is hot content inside?
3.Non-stop for a
long time
If the door seal is not good enough?
If there is too much frost inside?
If the ambient temperature is too high.
If too much hot things put inside of the product.
4.Big noise from
the product
If the floor is even and stable?If the product install evenly.
If the back of the freezer very close to the wall.
Err0:malfuntion of temperature sensor.
Err1:over voltage or under voltage.
Err2:big current on cooling fan.
Err3:bad heat dissipation and lock-rotor of compressor.
The following issues are not trouble.
5.1. Sometimes there is frost on the surface of fridge caused by high
ambient temperature or infrequent door opening. Buyers can wipe the frost off.
5.2. There is sound of water flow or water boiling which is the sound of
refrigerant flowing normally.
5.3. When the freezer is working, compressor and condenser will heat,
these are normal phenomenon.
5.4 The compressor will be working for a long time when storing too
much food over heat.
5.5 The compressor will be working for a long time to keep the inner cabinet temperature when
the ambient temperature is very high.
Notice：When the freezer got problems, please check by this manual first. If the problems still
can not be resolved, please contact distributor or local service counter. Please do not disassemble
without expert guide.
6.Knowledge of usage
*Keep appropriate gap between stored items is conducive to the
circulation of cold air and heat exchange the cooling performance
will be better
*Always cool the food or drink before storing them into the freezer.,
*The freezer reboot after 5 minutes power-off time is necessary, otherwise it will affect the life of
the compressor, or even damage the compressor.
*Do not open the door more than necessary and longer to save
energy
*According to the needs of storage items to choose the appropriate
temperature unnecessary freezing will cause power waste.
*The temperature can be set lower before the expected black out, then the compressor accordingly
