03 HOW TO INSTALL
/
1. Plug the AC adaptor into the wall socket and insert the
DC socket into the DC plug hole on the back of the
Winder.
2. Turn on the Master Power Switch on the back. (If your
unit has two motors or more, each motor has its own
power on/off switch located on the back. You must turn
the individual power switch to "ON"position to operate
the unit. You may also turn anyone to "Off"position).
Check all the motors are working properly. Now turn
the Master Power Switch on the back to "Off"position.
Note: Neverput in or remove your watch when the
winder is rotating.
3.Take the watch pillow out of the watch winder.
Note: If the watch has completely stopped, you must
wear the watch a few minutes to make the watch work
again before putting the watch into the winder.
4. Fasten the straps of the watch, then squeeze the
pillow and put the watch, which is already buckled on
the pillow.
Note:When putting in or taking out the watch, be sure
to fix the roller by hand, do not rotate the roller, to
prevent the motor from rotating and causing the motor
to damage.
05
EN
