Third Party Equipment
The use of third-party equipment, cables, or accessories,
not made or authorized by KonnectONE, LLC, may
invalidate the warranty of the device and also adversely
aect the device performance and stability.
Ecient Use
For optimum performance with minimum power
consumption, do not cover the device with anything.
Covering the device may cause damage by operating at
higher power levels than recommended.
California Proposition 65 Warning
The device includes batteries, circuit boards and other
materials that can expose you to chemicals including
cobalt lithium nickel oxide, and nickel, which are known to
the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
RF Exposure Information (SAR)
This device meets the FCC’s requirements for exposure
to radio waves. This device is a Class B digital device,
pursuant to part 15 of the FCC Rules designed and
manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S.
Government.
Operation is subject to the following two conditions: (1)
the device does not cause harmful interference, and (2)
this device accepts any interference received, including
interference that may cause undesired operation.
The FCC has granted an Equipment Authorization for this
device with all reported Specic Absorption Rate (“SAR”)
levels evaluated in compliance with the FCC RF exposure
guidelines. SAR information on this device is on le
with the FCC and can be found under the Display Grant
section of www.fcc.gov/oet/ea/fccid after searching on
FCC ID: 2APQU-MT-T8B22.
The highest SAR value for this device as reported to the
FCC when tested for use in body is x.xxW/Kg. While there
may be dierences between the SAR levels of various
devices at various positions, they all meet the government
requirement.
Any changes or modications not expressly approved by
the party responsible for compliance could void the user’s
authority from the FCC to operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
CTIA Compliance
a) Do not disassemble or open crush, bend or deform,
puncture or shred.
b) Do not modify or remanufacture. Attempt to insert
foreign objects into the battery, immerse or expose
to water or other liquids expose to re, explosion or
another hazard.
c) Only use the battery for the system for which it is
specied.
d) Only use or replace the battery with a charging
system that has been qualied with the system per
CTIA Certication Requirements for Battery System
Compliance to IEEE1725. Use of an unqualied battery
or charger may present a risk of re, explosion,
leakage, or another hazard.
e) Do not short circuit a battery or allow metallic
conductive objects to contact battery terminals.
f) Promptly dispose of used batteries in accordance with
local regulations.
g) Battery usage by children should be supervised.
h) If the device or battery is dropped and the user
suspects damage, take it to a service center for
inspection.
i) Improper battery use may result in a re, explosion, or
other hazard.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. There is no guarantee that interference
will not occur in a particular installation. If this equipment
