Motorola PMAN5100 Manuel utilisateur

Installation Manual

WINDOW MOUNT ANTENNA

COVERT WIFI

PMAN5100

Foreword

This manual applies to digital mobile radios, unless otherwise specified. It

includes instructions for installing the Covert WIFI antenna in a vehicle window

mount configuration.

Product Safety and RF Exposure Compliance

ATTENTION

This radio is restricted to occupational use only to satisfy FCC RF energy exposure

requirements. Before using this product, read the RF energy awareness informa-

tion and operating instructions in the Product Safety and RF Exposure booklet en-

closed with your radio (Motorola Solutions Publication part number 6881095C99)

to ensure compliance with RF energy exposure limits.

For a list of Motorola Solutions-approved antennas, batteries and other accesso-

ries, visit the following web site which lists approved accessories:

http://www.motorolasolution s.com/en_us/products/two-way-radios/project-

25-radios.html

Document Copyrights

No duplication or distribution of this document or any portion thereof shall take

place without the express written permission of Motorola Solutions. No part of this

manual may be reproduced, distributed, or transmitted in any form or by any

means, electronic or mechanical, for any purpose without the express written

permission of Motorola Solutions.

Disclaimer

The information in this document is carefully examined, and is believed to be

entirely reliable. However, no responsibility is assumed for inaccuracies.

Furthermore, Motorola Solutions reserves the right to make changes to any

products herein to improve readability, function, or design. Motorola Solutions

does not assume any liability arising out of the applications or use of any product

or circuit described herein; nor does it cover any license under its patent rights nor

the rights of others.

Before using this product, read the operating instructions

for safe usage contained in the Product Safety and RF

Exposure booklet enclosed with your radio.

C a u t i o n

Trademark

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are

trademarks or registered trademarks of Motorola Trademark Holdings, LLC and

are used under license. All other trademarks are the property of their respective

owners.

Introduction

The vehicle WIFI window mount antenna is intended for mounting on the

windshield of the vehicle. After completing the installation, the cable is concealed

between the headlining and the roof of the vehicle, with minimum disturbance to

the headlining and the upholstery. Figure 1-1 shows the WIFI window mount

antenna.

Figure 1-1. WIFI Window Mount Antenna

FCC Requirements

Consider the following factors when installing an antenna.

• Install the vehicle antenna internal to the vehicle on the windshield, and in

accordance with the requirements contained in this manual.

• Ensure the antenna cable can be easily routed to the radio.

• Ensure that the antenna cable is routed separately and not in parallel to any

other vehicle wiring or mobile radio cable wiring.

To comply with FCC regulations when installing the antenna

lead-in cable, DO NOT shorten the cable.

C a u t i o n

Figure 1-2. Recommended Installation on Windshield

Required Tools and Materials

No tools and materials are needed to install the antenna.

MIN. 1 in.

WINDSHIELD

- VERTICAL ORIENTATION

- NO METALIC OBJECT

NEAR AROUND

- MIN. 1 IN. DISTANCE FROM

EDGES

Installation Procedure

The installation procedure that follows is for a typical passenger car. The

procedure may vary slightly with the type of vehicle on which the antenna is to be

installed. Generally, however, the procedure outlined below is universal in nature.

Antenna Installation

1. Select a location for the antenna on the windshield. The antenna should be on

the PASSENGER side, close to the TOP, and on the FRONT WINDSHIELD

only. Make sure the antenna does not obstruct the view of the driver. For opti-

mum performance, a higher location on the windshield is better than a lower

one.

NOTE:

• Do not mount the antenna to the dashboard or the rear deck as the antenna

may obstruct the view of the vehicle driver as well as effect optimal RF per-

formance.

• Check the antenna location for any electrical interference. Keep away from

metallic tint, defroster wires, or other obstructions on the windshield.

• Keep WIFI Antenna at least one inch away from windshield edge and car

chassis metal.

2. Make sure the antenna is vertically polarized, so the radiation pattern is omni-

directional.

3. Test fit the antenna on the selected area prior to removing the release liner

from the tape on the antenna’s mounting surface.

4. Probe the headlining with your fingers to make sure that all points of obstruc-

tion are avoided.

5. Determine the routing of the cable from the antenna to the radio set, and then

remove the molding and trim necessary to facilitate pulling the cable through.

NOTE: If you experience difficulty with cable routing, use an electrician's

fishtape to perform this step.

6. Make sure the mounting glass surface is clean and free of debris. Clean sur-

face area with a lint-free cloth using isopropyl alcohol to remove any residue

grease or dirt buildup.

7. Remove the release liner and carefully position the antenna above the

selected mounting area.

8. Place the antenna on the mounting surface and apply even pressure to allow

the foam tape to conform to the windshield curvature.

NOTE: 50% of the bond strength is achieved after 20 minutes. Avoid contact with

the antenna for a minimum of 20 minutes after initial installation. Full bond

strength of the adhesive tape is realized after 72 hours.

9. Double check the connections and then reinstall molding and trim.

The adhesive tape is very strong and will bond instantly on

the mounting surface. Once the antenna is placed on the

surface, it cannot be moved.

C a u t i o n

PMAN4000

User Guide Accessories

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or

registered trademarks of Motorola Trademark Holdings, LLC and are used under license.

All other trademarks are the property of their respective owners.

*PMLN7726A*

PMLN7726A

Table des matières

Autres manuels Motorola Antenne

Motorola

Motorola AN720 Manuel d'instructions

Motorola

Motorola HAD4006A Manuel utilisateur

Motorola

Motorola PMAN4009 Manuel utilisateur

Motorola

Motorola RAD4020ARB Manuel utilisateur

Motorola

Motorola Astro APX 3000 Manuel utilisateur

Motorola

Motorola PMAN4010 Manuel utilisateur

Motorola

Motorola Nitro SLX 5000 Manuel utilisateur

Motorola

Motorola PMAN4002 Manuel utilisateur

Motorola

Motorola PMAE4030 Manuel utilisateur

Motorola

Motorola PMAN4008 Manuel utilisateur

Motorola

Motorola RRA-4935 Manuel utilisateur

Motorola

Motorola Spectrum Series Manuel utilisateur

Motorola

Motorola HAD4021A Manuel utilisateur

Motorola

Motorola HAF4015 Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur