Mopar K6860274 Manuel utilisateur

K6860274 – SDARS ANTENNA

Click on the desired vehicle to take you directly to the vehicle specific

instructions.

RAM

300/CHARGER/

CHALLENGER

CALIBER

COMMANDER

COMPASS

DAKOTA

DURANGO/ASPEN

GRAND CHEROKEE

MINIVAN

PATRIOT

Aug 08, 2008 K6860274 Rev. 1

SDARS ANTENNA

COMMANDER

PROCEDURE STEPS:

1. Disconnect and Isolate the negative battery cable.

2. Using Trim Stick C-4755, or equivalent, release the retaining

clips that secure the header trim molding (1) in the liftgate

opening and remove.

3. Remove the push pins from the headliner at the rear of the

vehicle.

4. Using Trim Stick C-4755, or equivalent, disengage the

retaining tabs that secure the liftgate scuff plate to the liftgate

door sill and remove the scuff plate (1).

NOTE: Load oor shown, jack tray similar.

4/1/2008 K6860274 Rev. 1

5. Equipped with Load Floor - Remove the two nuts (1) that

secure the load ﬂoor to the ﬂoor panel.

6. Remove the load ﬂoor.

7. Equipped with Third Row Seats - Remove the four nuts

holding in the jack storage compartment.

8. Remove the jack storage compartment.

NOTE: Drivers side shown, passenger side similar.

9. Remove the passengers side rear door scuff plate.

10. Remove the passengers front door scuff plate.

4/1/2008 K6860274 Rev. 1

11. Remove the passenger side cowl trim panel (1).

NOTE: Passenger side shown, driver side similar.

12. Position the third row seat down.

13. Remove the screw cover for the third row seat release and

remove the lever (2), both sides.

14. Using a trim stick C-4755 or equivalent, disengagethe

retaining tabs that secure the D-pillar trim panel to the

retaining clips in the D-pillar and remove the trim panel, both

sides.

15. Remove the trim plug (1) from the upper c-pillar trim, both

sides.

4/1/2008 K6860274 Rev. 1

16. Using a magnetic screwdriver or equivalent, remove the upper

screw and pull the upper part of the trim panel (1) away from

the pillar and release the bottom tabs (2).

17. Position aside the c-pillar trim, both sides.

18. Pull the grab handle downward, remove the two screws that

secure the grab handle to the roof panel, and remove the grab

handles from the headliner.

19. If equipped, disconnect the reading lamp wire connector from

the grab handles, both sides.

20. Partially separate the door seals from the door opening, both

sides.

21. Remove the screws and the cargo net d-ring that secure the

quarter trim panel to the quarter panel.

22. Using a trim stick C-4755 or equivalent, disengage the

retaining tabs that secure the quarter trim panel to the quarter

panel.

23. Pull the quarter trim panel away from the quarter panel (3).

24. If equipped, disconnect the rear heater control connectors (1).

25. Remove the quarter trim panel.

26. Separate the glove box damper rod (1) from the clove box by

sliding the rod towards the rear of the vehicle to release it from

the bin.

27. Open the glove box and carefully use ﬁngers to press down

glove box open stops at the top of the bin, downward to allow

the glove box to rotate toward the carpet.

28. Rotate the box down and release the door hinges (2) at the

bottom and remove the glove box.

4/1/2008 K6860274 Rev. 1

29. Using a trim stick C-4755 or equivalent, remove the shifter

bezel.

30. Remove the radio bezel screw.

31. Remove the radio mounting fasteners.

WARNING: Disable the airbag system before attempting

any steering wheel, steering column, or instrument panel

component diagnosis or service. Disconnect and isolate the

negative battery (ground) cable, then wait two minutes for

the airbag system capacitor to discharge before performing

further diagnosis or service. This is the only sure way

to disable the airbag system. Failure to take the proper

precautions could result in an accidental airbag deployment

and possible serious or fatal injury.

CAUTION: Pulling the antenna cable straight out of the radio

without pulling on the locking antenna connector could

damage the cable or radio.

32. Disconnect the electrical connector and remove radio.

33. Starting at the radio, route the harness from the rear of the

radio along the bottom of the glove box and secure to the

support brace (1).

34. Route the antenna down to the cowl trim area and secure to

the body harness.

4/1/2008 K6860274 Rev. 1

35. Route along the front passenger scuff plate and under the b-

pillar trim.

36. Route antenna harness along the rear passenger scuff plate

and up the c-pillar.

37. Route the antenna cable behind the rear HVAC housingand

secure to the body harness and up the d-pillar.

4/1/2008 K6860274 Rev. 1

38. Starting from the door side use a trim stick C-4755 or

equivalent, disengage the retaining tabs that secure the trim

ring (1) to the rear sunroof support bracket (2).

39. Remove the four mounting fasteners for the video monitor, if

equipped.

40. Disconnect electrical connectors (1) and remove monitor.

41. Remove the rear and center rear push pins from the rear of

the headliner (3).

CAUTION: Be careful not to crease the headliner.

4/1/2008 K6860274 Rev. 1

42. Cut out the template.

43. Center the template on the rear of the roof, aligning the

template with the roof edge.

44. Center punch the two holes marked on the template.

45. Remove the template.

CAUTION: Do not drill more than a 6 mm (1/4 in.), failure to do

so will result in damage to the vehicles headliner.

46. Drill a 3 mm (1/8 in.) pilot hole at each of the center punched

locations.

47. Drill the rear hole to 5 mm (13/64 in.).

48. Drill the front hole to 19 mm (3/4 in.).

49. Debur both of the holes.

50. Apply Mopar® Corrosion Inhibitor, p/n 82300508, to the bare

metal surface of the drilled holes.

51. Clean and prep the area for the antenna.

52. Install the satellite antenna. Tighten to 9 N·m (80 in. lbs.).

4/1/2008 K6860274 Rev. 1

53. Connect the antenna harness to the antenna.

54. Install the rear head liner push pins and the rear centerpush

pins.

55. Install the video monitor, if equipped.

4/1/2008 K6860274 Rev. 1

Table des matières

Langues :

Autres manuels Mopar Antenne

Mopar

Mopar 82210940AD Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur