Monte Carlo Fan Company CKF310 Manuel utilisateur
CKF310-ENG
1. Model CD-52, manufactured by Ja Yang (E106510)
CKF310
Top view of switch housing plate.
2
Disconnect Molex Connectors in switch housing
plate by pushing down on tab and pulling the
two (molex connectors) apart.
3
CAUTION: To reduce the risk of electric shock,
install only in Fan
CAUTION : FOR CONTROL OF SHADE POLE, PERMANENT SPLIT
CAPACITOR, OR UNI ERSAL MOTORS ONLY.
Connect the molex from the receiver to the
molex in the switch housing plate by aligning
and sliding together. Note: For longer distance
operation, coil receiver antenna around the
natural wire (white wire).
4
Align gap in receiver with the screw between
speed switch and reverse switch and slide
receiver (Dip switch facing housing plate) into
switch housing plate. Receiver should fit direct-
ly into area in the switch housing plate. Note:
If installing light kit, use the blue and white
wire from the receiver.
6
Set dip switches on the Remote Transmitter and
Remote Receiver to the same settings. This
must be done so the units will communcate
properly. If you have other fans you can set to
control from one transmitter by setting both
receivers the same as the transmitter. If you
have more than one fan with remote. You can
set the dip switches to different positiosns to
have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
5
2. Model 9701, manufactured by Furn Fan (E141261)
3. Model AC-552, manufactured by Air Cool (E75795)
For Monte Carlo Remote
Caution: Turn off power at fuse box to avoid
possible electrical shock.
1
The wall control transmits the command signals via radio waves to the receiver
installed in the fan’s hanging bracket or on the fan. The receiver is required for
the wall control to function. ower for the wall control comes from the 12V bat-
tery located in the wall remote. Duracell MN21 / Eveready A23 / G 23A all 12V.
The frequency switches (dip switches) on the wall control and the receiver have
been preset at the factory. lease recheck to make sure the switches on the wall
control and receiver are set to the same position. Any combination of settings are
fine as long as the wall control and ceiling fan receiver are set to the same posi-
tion.
CAUTION: TURN OFF POWER AT FUSE BOX TO A OID POSSIBLE ELECTRICAL SHOCK.
Install wall control unit to outlet box
using machine screws provided.
3
Attach front cover to wall control
with screws provided. Snap battery
cover in place.
4
Remove cover by snaping off from top or bot-
tom. Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready A23
/ G 23A all 12V.
lace face plate over battery compartment and
buttons. lace remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snaping into place.
2
1HAND HELD INSTALL
WALL MOUNT INSTALL
Remote Control Transmitter Features:
FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for
high. To turn fan off press square”.
LIGHT ON/OFF To turn light on, press light button once quickly. To turn off
press once quickly while light is on.
FORWARD/RE ERSE Depress rev button allow a few seconds for remote to
change rotation direction.
HIGH S EED
MEDIUM S EED
LOW S EED
FAN OFF SETTING
(Turns fan off only)
FAN REVERSE ( ress
once to change direc-
tion of the fan)
LIGHT ON/OFF SETTING
( ress to turn on/off light)
LED LIGHT
8/8/09 REV.0 CKF-310-ENG
Table des matières
Autres manuels Monte Carlo Fan Company Télécommande
Monte Carlo Fan Company
Monte Carlo Fan Company CK-300 Manuel utilisateur
Monte Carlo Fan Company
Monte Carlo Fan Company MCRC1R series Manuel du propriétaire
Monte Carlo Fan Company
Monte Carlo Fan Company MCRC1 series Manuel du propriétaire
Monte Carlo Fan Company
Monte Carlo Fan Company CT-100 Manuel utilisateur
Monte Carlo Fan Company
Monte Carlo Fan Company ESSWC-4-WH Manuel
Monte Carlo Fan Company
Monte Carlo Fan Company MCSMRC Manuel du propriétaire
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
