Monster 2MNHP2091 Manuel utilisateur
MONSTER
User manual
Name: Wireless Headset
Model: 2MNHP2091, 2MNHP2091B0L2, 2MNHP2091G0L2
Bluetooth® Version: 5.3
Supported profiles: HSP/HFP/A2DP/AVRCP
Frequency response: 20Hz-20kHz
Impedance: 32Ω
Driver: Ø50mm Integrated Dynamic Driver
Sensitivity: 106±3dB at 1KHz
Effective range: up to 10 meters
Battery capacity: 1000mAh
Playing time: Up to 60hours
Charging time: Max. 2 hours
Charging port: Type-C™
Input voltage: DC 5V / 1A
Working temperature: 0~45℃
Storage temperature: -20~70℃
Wireless Headset Operation:
Power ON:
Press and hold the “MFB” button for 2 seconds.
Power OFF:
When the power is ON, press and hold the “MFB” for 5 seconds.
Bluetooth® Pairing:
Go to “Bluetooth” Setting on your Bluetooth® device (phone, tablet, etc.), turn the Bluetooth® ON, on your device.
Press and hold the “MFB” for 5 seconds and then release it to enter pairing mode. (The LED indicator will blink red
and blue intermittently).
On your Bluetooth® device, select “Monster MAMBO M1” from the list of available devices.
Dual Connection:
You can connect to two Bluetooth® transmitting devices (phone, tablet, etc.) at the same time. Simply pause the
audio on the first device to play audio from the second device.
Aux input:
Plug the Aux 3.5mm connector of the included Aux to USB-C cable into a compatible device (computer, phone,
etc.) and plug the USB-C side to your MAMBO M1 to use it as a wired headset.
Answer call:
Single press the “MFB” button to answer a call.
End call / Reject call:
Double press on the “MFB” button to end a call, or to reject an incoming call.
Voice assistant:
Double press on the “MFB” button. (Only when connected to a Bluetooth® device that supports Voice Assistant.
This feature is not available duration a call.)
Play/Pause:
Single press the “MFB” button to play/pause music.
MONSTER
Previous Track:
Double press on the “-“ button.
Next Track:
Double press the “+” button.
Volume Up:
Single press “+” to increase the volume.
Volume Down:
Press “-” to decrease the volume.
Mute/Unmute microphone:
Press and hold the “+” button for 3S to mute/unmute the microphone. While the headphones are muted, the Mic
LED will be ON, red.
Charging the headset:
Connect the included charging cable to an appropriate power source and plug it into the USB-C port on the headset
to begin charging. The LED indicator will be ON red while charging and will turn OFF once the battery reaches %100.
Quick Charge:
Charging the headset for 10min provides 2 hours of playtime.
Please Note:
This Bluetooth headphone shall be charged by the supplied charging unit only.
Caution: The batteries in this product are not replaceable. During use,
storage or transportation the battery should not be subjected to
extremely low temperatures, or low air pressure at high altitude. If the
battery is exposed to extremely high temperatures it could result in an
explosion or the leaking of flammable liquid or gas. Please take care when disposing of the unit; disposal in a fire,
oven, mechanically crushing or cutting machine could cause an explosion.
Warning: Do not dispose of the unit in fire or water. Never attempt to
disassemble and reassemble. Waste electrical products should not be disposed of with household waste, please
recycle where facilities exist.
Check with your local authority for recycling advice. Keep your device and
all accessories out of the reach of children and animals. Small parts may
cause choking or serious injury if swallowed. Avoid exposing your device to very cold or very hot temperatures
(Below 0° or above 45° C).
Extreme temperatures can cause deforming of the device and reduce the
charging capacity and life of your device. Do not allow your device to get wet, liquids can cause serious damage.
Do not handle your device with
wet hands.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc., iPhone, iPad, and
Mac is a trademark of Apple Inc., registered in the U.S. and other countries.
MONSTER
MONSTER
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Avertissement RF pour les appareils portables:
L'appareil a été évalué et répond aux exigences générales d'exposition aux RF. L'appareil peut être utilisé dans des
conditions d'exposition portables sans restriction.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Monster casque
