Wire Guide Funnel –Mylar Tape Carrier
Doc No. 63885-1061 Release Date: 03-02-06 UNCONTROLLED COPY Page 3 of 5
Revision: A Revision Date: 03-02-06
WIRE GUIDE FUNNEL ADJUSTMENTS
The wire guide funnel can be adjusted left-
to-right and up or down for alignment with
the terminal.
Since the wire guide funnel is centrally
mounted to the applicator ram, left-to-
right adjustment should not be necessary.
If it is required, some movement is
available by loosening the two M4 socket
head cap screws (holding the funnel slide
to the applicator frame) and moving the
slide left or right.
Left-to-right positioning can also be
accomplished by adjusting the applicator’s
terminal feed to relocate the terminal
itself.
Up or down funnel adjustment:
1. With a terminal in position over the crimp anvils, cycle
the press to its split-point.
Note: If the press has an adjustable split-point, adjust it
as low as possible (without starting to crimp the
terminal). This will hold the terminal more securely
against the anvils.
2. Using a 2mm hex wrench, loosen the adjustment lock
screw on the front of the funnel slide.
3. The height adjustment screw is accessed through the hole
on the top of the slide. Using a 2mm hex wrench, turn
the adjustment screw clockwise to raise the funnel or
counter-clockwise to lower the funnel. Proper
adjustment should result in the insulation guide hole
being concentric with the terminal barrel. See Figure 5
4. Tighten the adjustment lock screw. Over-tightening the
lock screw will damage the threads of the height
adjustment screw.
HEIGHT ADJ SETSCREW
(USE A 1.5mm
HEX
LOCK SETSCREW
Figure 5
SETSCREW
M8 CAP
SCREW
M4 CAP SCREW
M4 THREADED
HOLES
GUIDE
SPACER
BLOCKS
Figure 4
