MOB MO8734 Manuel utilisateur
USER MANUAL
(2014/53/EU art. 10-8)
(a) Frequency Range; GSM/GPRS 900: Tx: 880-915MHz, GSM/GPRS 1800: Tx: 1710-
1785MHz, Rx: 1805-1880 MHz, GPS: 1.57GHz.
(b) Maximum radio-frequency power; GSM900: 32.63dBm, GSM1800: 29.63dBm
(2014/53/EU art. 10-9 Simplified Declaration of Conformity)
Hereby, MOB, declares that item MO8734 complies with the essential requirements and
other relevant conditions of directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: www.momanual.com
MOB, PO BOX 644, 6710 BP (NL).
PO: 41-XXXXXX
Made in China
GPS tracker
Accessories:
1 X Device
1 X USB charge cable
1 X User Guide
HardwareSpecification:
Hardware Specification:
Mainframe Dimension
Net weight
GSM frequencies
GPRS
GPS chip
Voltage range
Standby Current
GPS locating time
GPS Accuracy
GPS sensitivity
Work environment temperature
Work environment humidity
Battery Chargeable
86*55*6mm
40g
850/900/1800/1900Mhz
Class12, TCP/IP
UBLOX G7020
3.6-4.2VDC
≤2mAh
Cold start 38s
Warm start 32s
Hot start=2s
≤ 10m
-159DB
-40℃+80℃
20%-80%RH
3.7v 1000mAh
SIM Card Installation:
※
Micro SIM card ( 12*15mm)
※
Insert the SIM card in the SIM card slot
※
The SIM card chip inserted towards the side without the SOS button
※
The SIM card isnotincluded inthe package, AnySIMcard which
support GSM 2G can work and be available from the user’s local operator.
※
Before installing the SIM card, please check if the SIM card has a PIN code
or not, if yes, please use a cell-phone to unlock the card’s PIN code. In addition,
make sure it is activated and has sufficient credit on it.
Device Charging:
For the first time of use, please fully charge the battery for around 2-3 hours
with the USB charger.
Turn on the device by Inserting Card
Please insert the SIM card in the correct direction. You will see the indicator light blinks,
then turns off. This means the SIM card has been inserted successfully.
Led indicator:
Solid blue: SIM card inserted incorrectly
Flashing blue: Searching for GPS signal
Blue off: Is working correctly
Red on: Charging the battery
Red off: Fully charged
Configuration and Operation by SMS
1.
To Set the authorized Number
Command: CENTER,000000,phone number#
NOTE: The letters or symbols should be English and the letters should be in
capital.
Example: CENTER,000000,123456789#
※
Using your mobile phone, send the above command tothephone
number of the device, it will reply: CenterOK!
※
Todeletethisnumber, youcansend :CENTER,000000,0# to
the phone number of the device.
2.
GPRS Setting
In order to use the GPRS function, the user needs to setup the APN by
sending an SMS command.
What is APN? Access Point name (APN) is the name used to identify a general
packet radio service (GPRS) bearer service in the GSM mobile network. The
APN defines the type of service that is provided in the packet data connection.
※
Make sure that the SIM card in the tracker supports the GPRS function.
※
The APN can be acquired from your local GSM operators.
Command: APN, APNinformation, user name, password#
Note: Some APN are without user name and password, so please leave it blank.
For example: APN, internet, 123,456# (with the user name and password)
APN, internet# (without the user name and password)
※
please set it upwhen the device cannot connect with the web platform
or the APP.
※
After sending the command, it will reply: APN OK!
3.
Location request
Reply with coordinates and web link
Command:URL#
The device will reply: the map link, the longitude and latitude
Example:http://maps.google.com/maps?q=N22.669534,E114.011888
※
Click on the linkthen the location can be shown directly onGoogle
Map on your mobile phone.
4.
Vibration Alarm
Command: VA, ON# (turn on this function)
VA, OFF# (turn off this function)
※
Please move the device after 5minutes,then you will geta message
reply: vibration alarm, please note!
※
This function is off by default setting.
※
After sending the command, it will reply: VA OK!
5.
Over-Speed Alert
Command: OS, 80# (80 is the set-up speed)
OS, OFF# (turn off this function)
※
This is to turn on/off the over-speed alarm, speed unit:km/h
※
Speed range:30-180km
※
This function is off by default setting.
※
After sending the command, it willreply: OSOK!
6.
Listen-in (Voice Monitoring)
Command: JT# (turn on the function)
JT0# (turn off the function)
※
Please call the mobile number in the device, then you can hear what is
happening around the tracker after you get the SMS reply when turning on this
function.
7.
SOS Alarm
Command: SK, 1# (Alarm on)
SK, 0#(Alarm off)
※
Press the SOS button for 3 seconds, it will call the authorized number.
※
After thefirst operation, please waitatleast 3minutestotest again,
otherwise it will not work.
8.
Checking Settings
Command:QP#
※
The device will reply : IMEI:3568XXXXXXXXX90
APN: cmnet
IP:b.gps903.net/7700
LMT, 0#
CENTER:
SOC4 ：1
GSM: 100
GPS: FIXED
BAT: 3.9
9.
Reboot device
Command:RESET#
※The device will restart itself without changing any settings.
10.
Initialization
Command:RFS#
※
This is to restore all settings back to the factory default, except the IP.
※
Only the authorized number has the right to operate.
※
Please use with caution
How to Connect Device to the Platform
for real time tracking via GPRS
Check through PC
Web Platform : www.gps903.net (International)
Account: Device IMEI (shown on the back of the device cover))
Original passwords: 123456
Operations of APP in a Cellular Phone
APP NAME: GPSONE
available at
※
please search foritinthe IOSapp store orGoogle play store or scan
the QR code from the web platform
※
please login the app as following:
IMEI serial number
passwords: 1234 56
choose the maps
Geo-fence
An electronic fence can be set up after login APP or PC. Then you can check the
messages from the device messages.
Cautions:
Please comply with the instructions to extend the life of the device:
1. Do not use & store the unit in dustyplaces.
2. Do not put expose the unit to extremes in temperature hot orcold.
3. Clear theunit with a piece of dry cloth. Do not clean in chemicals or detergent.
4. Do not disassemble theunit.
5. Do not change the battery in the unit as this can causedamage.
DE
GPS-Tracker
Inhalt:
1 x Gerät
1 x USB-Ladekabel
1 x Benutzerhandbuch
Technische Daten Hardware:
Außenmaße 86 * 55 * 6mm
Nettogewicht 40g
GSM-Frequenzen 850/900/1800/1900Mhz
GPRS Klasse12, TCP / IP
GPS-Chip UBLOX G7020
Spannungsbereich 3,6-4,2VDC
Standby-Betrieb ≤2mAh
GPSOrtungszeit Kaltstart 38s
Warmstart = 32s
Heißstart = 2s
GPS-Genauigkeit ≤10m
GPS-Empfindlichkeit -159DB
Arbeitsumgebungstemperatur -40 ℃+ 80℃
ArbeitsumgebungLuftfeuchtigkeit 20% -80% RH
AufladbarerAkku 3.7v 1000mAh
Installation SIM Karte:
※
Micro-simkaart (12 * 15 mm)
※
De opening van de SIM-kaart naar binnen.
※
De simkaart-chip naar de zijkant zonder SOS-knop
※
SIMDeSIM-kaartisnietinbegrepeninhetpakket.ElkeSIM-kaart
die GSM 2G ondersteunt, van uw lokaleoperator.
※
Controleer voordat u deSIM-kaart installeert of deSIM-kaart een pincode
heeft of niet,zoja, gebruik eenmobiele telefoon enontgrendeldePIN-codevan
de kaart. Zorg ervoor dat deze geactiveerd is met voldoende saldo.
Geräteaufladung:
Laden Sie den Akku vor dem ersten Gebrauch ca. 2-3 Stunden über das USB-
Ladekabel vollständig auf.
Schalten Sie das Gerät ein, indem Sie die Karte
einlegen
Autres manuels pour MO8734
1
Table des matières
Langues :
Autres manuels MOB GPS
