Milwaukee CD97 Manuel utilisateur

INSTRUCTION

MANUAL

CD97

TDS Tester

www.milwaukeeinst.com

OPERATING

• Remove the

protection cap.

• Turn the CD97 on

with the ON/OFF

switch located on the

top.

• Immerse into solution

up to the maximum

immersion level without

touching the bottom of

the beaker.

• Stir gently and wait

until the display

stabilizes. CD97

compensates for the

temperature variance

automatically.

• Read the value on the

display.

CALIBRATION

• The calibration

procedure is very

simple and

fast.

• Immerse

the tester up

to the

maximum

level into the

appropriate

optional

calibration

solution

M10080

corresponding to 800

ppm.

• Allow the displayed

value to stabilize.

• Pull out the battery

compartment and

locate the calibration

trimmer on the top of

the internal circuitry.

• By turning the

calibration trimmer with

a small screwdriver,

adjust the reading to

match the solution

value of 800 ppm

(normally to the value

at 25°C). Replace the

battery compartment in

the original position.

• Calibration is now

complete.

BATTERY

REPLACEMENT

When the CD97

cannot be

switched on or

the display

fades, pull out

the battery

compartment

and replace all

three 1.5V batteries,

paying attention to their

polarity. Batteries

should be replaced in a

non-hazardous area

using the battery types

specified in this

instruction manual.

RECOMMENDATIONS FOR

USERS:

Before using this product, make

sure that it is entirely suitable for

the environment in which it is used.

Operation of this instrument in

residential area could cause

unacceptable interferences to radio

and TV equipments, requiring the

operator to take all necessary steps

to correct interferences.

The glass bulb at the end of the pH

electrode is sensitive to

electrostatic discharge. Avoid

touching this glass bulbat all times.

During operation of instrument,

ESD wrist straps should be warn to

avoide possible damage to the pH

electrode by electrostatic

discharge. Any variation introduced

by the user to the supplied

equipment may degrade the

instrument’s EMC performance. To

avoid electrical shock, do not use

this instrument when voltages at the

measurement surface exceed 24

VAC or 60 VDC. To avoid damages

or burns, do not perform any

measurement in microwave ovens.

SPECIFICATIONS

Range 0 to 999 ppm

Resolution 1 ppm

Accuracy ±10 ppm

Temperature automatic,

Compensation from

5 to 50°

Environment 0 to 50°C

Battery Type 4x1.5V

alkaline

Battery life 150 hours

Dimensions 150x30x24 mm

Weight 85 g

Autres manuels Milwaukee Équipement de test

Milwaukee

Milwaukee ORP57 Manuel utilisateur

Milwaukee

Milwaukee 2210-20 Manuel utilisateur

Milwaukee

Milwaukee MW803 Manuel utilisateur

Milwaukee

Milwaukee MW804 Manuel utilisateur

Milwaukee

Milwaukee pH55 PRO Manuel utilisateur

Milwaukee

Milwaukee 2237-40 Manuel utilisateur

Milwaukee

Milwaukee MW14 Manuel utilisateur

Milwaukee

Milwaukee ORP57 Manuel utilisateur

Milwaukee

Milwaukee pH51 Manuel utilisateur

Milwaukee

Milwaukee MW10 Manuel utilisateur

Milwaukee

Milwaukee pH58 Manuel utilisateur

Milwaukee

Milwaukee HEAVY DUTY 2216-40 Manuel utilisateur

Milwaukee

Milwaukee EC59 Manuel utilisateur

Milwaukee

Milwaukee MW12 Manuel utilisateur

Milwaukee

Milwaukee MW11 Manuel utilisateur

Milwaukee

Milwaukee pH600 Manuel utilisateur

Milwaukee

Milwaukee MW14 Manuel utilisateur

Milwaukee

Milwaukee pH54 Manuel utilisateur

Manuels Équipement de test populaires d'autres marques

SMART

SMART KANAAD SBT XTREME 3G Series Manuel utilisateur

Agilent Technologies

Agilent Technologies BERT Serial Manuel utilisateur

Agilent Technologies

Agilent Technologies N3280A Manuel utilisateur

Vernier

Vernier Go Direct Voltage Manuel utilisateur

Lifeloc

Lifeloc R.A.D.A.R. Manuel utilisateur

Fluke

Fluke T5-600 Instructions d'utilisation et d'installation

Mercury

Mercury TSL01 Manuel utilisateur

MAHA

MAHA MBT Series Manuel utilisateur

Fuji Electric

Fuji Electric P-61 Manuel utilisateur

ETC

ETC SealerAtor Manuel utilisateur

Skyfine

Skyfine ETHYWAY V2 Manuel utilisateur

Appion

Appion G5 Twin Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 8159-0112A Manuel utilisateur

BW Technologies

BW Technologies MicroDock II Manuel utilisateur

Sun Nuclear

Sun Nuclear 1027 Manuel utilisateur

Biomark

Biomark HPR LITE READER Manuel utilisateur

Hioki

Hioki 3169-20 Manuel utilisateur

Ashcroft

Ashcroft ATE-100 Manuel utilisateur