Milkotester Ltd
Thermostatic device
6
Attention: In entry of mode SET UP, temperature and time values are
reset! When change the temperature to a lower value (for example: from 60 to
40 degrees) you must wait until heater plate gets cooler (switch off the device
for 30 minutes)
6. Operation of the thermostatic device
When the device is switched ON, on the display appears the working
mode:
Mode 1
Mode 2
After 2 sec the device beeps and on the display appears the current
temperature. If indication blinks it means that the adjusted temperature is not
reached. Timer 1 and Timer 2 starting is possible only when the temperature is
adjusted (i.c. indication doesn’t blink)
Timer is started by pressing START as the indicator displays the specified
time and start Timer 1 (timer 1 indicator lights). Time decrease and reaching
000 the device gives an intermitted sound signal and on the display is flashing
“1”. After pressing the START button starts Timer 2, which indicates time. After
time indication appears flashing symbol “2” and intermitted sound signal. The
device waits for pressing the START button to complete the cycle and to go in
mode temperature measurements.
If the button START is not pressed in order to start timer 2 or to finish the
cycle the device for 5 min gives intermittent sound signal and symbol “1” or “2”
is flashing on the display. After that the sound signal stops and the device waits
for pressing the button START in order to start Timer 2 or to finish the cycle.
For the time of waiting device keeps the set temperature depending on
the selected mode.
7. Models thermostatic devices
