The DA-606 Wireless Remote Control Transmitter activates light switches, lamp modules, and heavy-duty outlets.
The DA-606 Remote Control is triggered by a relay closure in a Drive-Alert control panel. It easily hooks directly up to a DA-600, DA-605 or
DA-700 Wireless Drive-Alert. However, if using a DA-500 Buried Sensor Drive-Alert you must also order the additional DA-500LKA Light Kit
Adapter.
This timer control can be set from 1 to 60 minutes. When triggered, the DA-606 transmits a UHF (318 MHZ) coded radio signal to activate the
installed DA-071 Wireless Light Switch (sold separately), DA-072 Lamp Module (sold separately), and/or DA-073 Heavy Duty Outlet devices for
the specic time interval that was set. After the preset time interval, the devices will turn off.
The signal path from the DA-606 to any DA-071, DA-072, and DA-073 devices must be unobstructed by metal objects such as large appliances
or mirrors so the signal path isn’t blocked. If the devices are not working when a Drive-Alert detects a vehicle, try moving the DA-606, and/or the
devices, so there is a clear signal path. Use the “TEST” push-button to verify operation.
The DA-606 ts into the magnetic base cradle and attaches to the Drive-Alert control panel.
The cradle switch on the DA-606 (see Figure B) should be ON to enable the Drive-Alert
control of the lights. If you wish to control the lights manually, and bypass Drive-Alert
activation of those lights, such as leaving the lights on during a party so arriving guests’ cars
won’t turn the lights on and off, turn this cradle switch OFF and the Drive-Alert will have no
effect on the lights. Other devices controlled by the Drive-Alert will operate as usual.
When using with a DA-600 or DA-605 Drive-Alert (see Figure C) connect the gray wires
from the DA-606 to the LAST two contacts on to the Drive-Alert control panel terminal board
marked NO and C. The polarity makes no difference.
When using with a DA-500 Drive-Alert (see Figure D) the whistle switch on the control
panel must be in the ON position. The gray wires from the DA-606 go to the FIRST two
contacts on the DA-500LKA Light Kit Adapter. The BLACK wire from the DA-500LKA is
attached to the fourth contact on the DA-500 Drive-Alert control panel marked NEG, and
the RED wire is attached to the sixth contact on the terminal board marked NO.
When using with a DA-700 Drive-Alert (see gure E below)
DA-600 or DA-605
SIG ALA +5VDC GND +24DC NO NC C NO C
UN REG
Figure C
Figure B
`
DA-500 with whistle ON
Figure D
RED BLACK SHLD NEG +24DC NO NC C
UN REG
NO C NO NC C
DA-500LKA
Black Red
MPI-DA073
Contact us for free installation and technical support:
Figure E
DA-700 Control Panel
1234567891011 12 13 14 15 16 17 18 19 20
+24 Gnd Z-1 Z-2 Z-3 Timer Relay All Det Relay Mute P/B Gnd +12 Not +10,0
DC or Relay Relay Relay 4 5 (Remote) or DC used Low
-24 C NO C NO C NO NC C NO NC C NO -12 Batt
Two Gray wires from the DA-606LK wireless transmitter:
one goes to #13 terminal/All Detect “C” Common, and the other
goes to terminal #14/All Detect “NO” Normally Open.
Wireless DA-073 Heavy Duty Outlet with DA-606 Timer
