Midea MAC160-S2802TPS/FM Manuel utilisateur

WASHING MACHINE

SERVICE MANUAL

CAUTION：

READ THIS SERVICE MANUAL CAREFULLY TO DIAGNOSE

TROUBLES CORRECTLY BEFORE OFFERING SERVICE.

CONTACT WITH YOUR SERVICE CENTER IF HAVE PROBLEM.

1 SAFETY AND PRECAUTIONS

2 TEST MODE ---赫英石

3 DIASSEMBLY INSTRUCTION ---王亮替换维修的照片

4 ERORR CODES AND EXPLANATIONS ---赫英石

5 TROUBLE SHOOTING

6 HOW TO CHECK THE ELECTRIC PARTS ---郭教鹏确认电器件的信息

7 CHECK POINT AFTER SERVICE

8 EXPLOADED VIEW AND BOM LIST

9 SPECIFICATIONS

Contents

IMPORTANT SAFETY NOTICE

This service information is intended for individuals possessing

adequate backgrounds of electrical, electronic and mechanical

experience.

Any attempt to repair this appliance may result in personal injury or

property damage.

The manufacturer or seller can not be responsible for the

interpretation of this information, nor can it assume any liability in

connection with its use.

•Please observe the following notes for safety.

•The symbols indicate as follows.

WARNING

No dismantling

• Please do not disassembly and assembly the machine

without

authorization.

No touching

• Please do not insert your hand and take out clothes inside

the spin barrel before it is fully stopped.

No dampness

• Please do not install the machine in damp and raining

environment to avoid electric shocking, catching fire, faults

and distortion accidents.

No rinsing

• Please do not directly rinse the machine with water when

cleaning.

Prohibited

• Please do not let children climb the machine or peer into the

rotating spin barrel to avoid accidents.

Prohibited

• It is prohibited to wash the clothes touching with kerosene,

gasoline, alcohol and other flammable materials.

1 SAFETY AND PRECAUTIONS

WARNING

Prohibited

• Please do not damage power flexible cord and power plug to

avoid electric shocking, short circuit and catching fire.

• Regularly clean the power plug to remove dust and dirt to

avoid contact failure.

Earthing

• Please well connect the earth line of socket to avoid electric

shocking by accidental leakage.

（earthing）

• Please insert the power plug tightly.

Pull out the plug

• Please pull out plug from the socket if the machine is not in

use.

Smoke and

fire prohibited

• Please do not place on the washer burning candle, mosquito-

repellent incense, cigarette and other flammablethings, as well

as electric stove, air heating fan and other heating sources.

WARNING

• Please use correct power source.

Wet hands are

prohibited

• Please do not pull out or insert the plug with wet hands to

avoid electric shocking.

CAUTION

• Please ensure that the water inlet pipe is connected and the

tap is opened before washing clothes.

Prohibited

•The water temperature shall not exceed 50℃ when washing

with warm water.

Prohibited

•Customers are not allowed to change the power line without

permission.

CAUTION

Prohibited

• Customers are not allowed to change the power line without

permission.

Prohibited

• It is strictly prohibited to place and sit children or lay weights

on the washer.

• Please do not pull the electric cord when pulling out the plug.

Prohibited

• Please do not wash down jacket, raincoat, fishing coat and

similar clothes in the washer.

2 TEST MODE

Before starting test mode, the water level sensor should be installed.

Otherwise, the unit will alarm and stop running test mode.

Test 1：Anytime you enter the test mode, all lights and digital will be ON

and then flash with 6 beeps. If any light is not ON, replace the PCB. If the

digital in not 88 displayed, replace the PCB. If you can’t hear the beep,

replace the PCB.

Test 2：Washing test, to check the motor and rotate directions.

In 9 seconds after entered test mode, press button Soil Level to enter

Washing test.

The Normal cycle light, Wash procedure light will be ON in Washing test.

The digital time will display 3 indicating that the remaining time is 3

minutes.

The motor and impeller will rotate in two-directions in turn.

The test mode will end with 6 beeps and Done light flashing after 3

minutes’ operation. All lights will be OFF when the lid is opened.

Test 3：Spinning test, to check clutch and pump.

In 9 seconds after entered test mode, press button Temp to enter Spinning

test.

The Normal cycle light, Spin procedure light will be ON in Spinning test.

The digital time will display 3 indicating that the remaining time is 3

minutes.

The pump will start in 8 seconds. Another 2 seconds later, the unit will start

Spinning test.

The test mode will end with 6 beeps and Done light flashing after 3

minutes’ operation. All lights will be OFF when the lid is opened.

Test 4：Inlet valve test, Software version check

In 9 seconds after entered test mode, press button Fabric Softener to enter

Inlet valve test.

2 TEST MODE

The inlet valve test will start. The valves will be ON and water can enter the

unit. Check the detergent compartment, softener compartment and the

basket water filling to check every valve.

Close the cold water faucet to see if the hot water valve is working or not.

At the same time, the digital display will show the software version. There

are two software versions: one is for display PCB displayed with “U-“ and

two digital followed; the other one is for power PCB displayed with “B-

“ and two digital followed.

The test mode will end with 6 beeps and Done light flashing after 1

minute’s operation. All lights will be OFF when the lid is opened.

Test 5：Auto-sensing check

In 9 seconds after entered test mode, press button Delay to enter auto-

sensing test.

The unit will check the auto-sensing function in this test mode.

The digital will display test result if this function is right.

Replace the Power PCB if there isn’t any display on the digital after the

test in 3 seconds.

The test mode will end with 6 beeps and Done light flashing. All lights will

be OFF when the lid is opened.

678

Number

Tools

13# sleeve spanner

8# sleeve

spanner

10# sleeve

spanner

6# inner six angle wrench

Needle

nose pliers

pliers

cross screwdriver

slot type screwdriver

3 DIASSEMBLY INSTRUCTION

Service tools needed

ITEM PICTURE HOW TO DISASSEMBLE

1.BACK COVER ①Unscrew the screws on the

back cover ( Red circle part) and

then take out the rear cover.

2. The earth screws,

capacitor screws, and

then pull out the air

pipe.

( make the air pipe

and

suspend poles

separate)

①Unscrew the earth screws to

make the earth wire

subassembly

and cabinet separate

②Unscrew the capacitor screws,

take down capacitor catch

③Pull out the air pipe to make

the air pipe and suspend poles

separate (When you install the

air pipe, you remember to coat

adhesive for preventing leakage)

UNPLUG POWER

• Unplug power cord for the work such as disassembling

which is not unnecessary to power on . Do not hold the plug

by a wet hand.

Failing to unplug may cause an electric shock.

WARNING

3 DIASSEMBLY INSTRUCTION

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Midea Rondelle

Midea

Midea MT100W70 Manuel utilisateur

Midea

Midea MAD160-A2801GPS Manuel utilisateur

Midea

Midea MLV45N1BWW Manuel

Midea

Midea MLH52S7AGS Manuel

Midea

Midea MTW70 Manuel utilisateur

Midea

Midea MLV45N1BWWC Manuel

Midea

Midea FP-90LTL085GETM-N1 Manuel utilisateur

Midea

Midea MLH52N5AWW Manuel

Midea

Midea MTWR45 Manuel utilisateur

Midea

Midea MWMTL075ZOF Manuel utilisateur

Midea

Midea MTWM80 Manuel utilisateur

Midea

Midea MLV41N1AWW Manuel utilisateur

Midea

Midea DMWM55G2 Manuel utilisateur

Midea

Midea MF710W Manuel utilisateur

Midea

Midea MLV47C3AWW Manuel

Midea

Midea 360215 Manuel utilisateur

Midea

Midea MFH180-G1302DS F01E-US Comment utiliser

Midea

Midea MA500W210 Series Manuel utilisateur

Midea

Midea MAR30-P0501GP Manuel utilisateur

Midea

Midea MJ70N68P Manuel utilisateur

Midea

Midea MAV10-A2804PS/01FM-US Manuel utilisateur

Midea

Midea MLH25N7BWW Manuel

Midea

Midea MT1250G Manuel utilisateur

Midea

Midea MWMFL070CDR Manuel utilisateur

Manuels Rondelle populaires d'autres marques

Tricity Bendix

Tricity Bendix AW 1000 W Guide produit

Panasonic

Panasonic NA-F60L5WRB Manuel utilisateur

GE WSLP1500 Manuel

Electrolux

Electrolux EWF1284EDW Manuel utilisateur

Bosch

Bosch WAN2829BSN Manuel utilisateur

LG TV2516DV3B Manuel utilisateur

LG TH2517DSAV Manuel utilisateur

VESTEL

VESTEL CMH-XL 7510 TE Manuel utilisateur

AEG

AEG 74335 Manuel d'utilisation

Johnson

Johnson JWF721A Manuel utilisateur

Beko

Beko WTE7604XLW0 Manuel utilisateur

Danby

Danby DTT100A1WDB Instructions de montage

Amica

Amica WA 14 Ex Manuel utilisateur

Daewoo

Daewoo DWD-F1222 Manuel utilisateur

Bosch

Bosch WAS28461AU Manuel utilisateur

Miele

Miele PW 6080 Vario Manuel utilisateur

Finlux

Finlux FLX108CF220 Manuel utilisateur

Whirlpool

Whirlpool 3LBR5132AN0 Manuel utilisateur