Midea C100-B Guide de l'administrateur
Jiangsu Midea Cleaning Appliances Co.,Ltd
No.39 Caohu Avenue, Xiangcheng Economic
Development Zone, Suzhou , Jiangsu Province, 215131, P.R.C
http://www.midea.com/global
VACUUM CLEANER
OPERATION INSTRUCTIONS MANUAL
C100-B
Please read this Instruction Manual carefully before operating, and keep it properly.
Contents Safety Introduction
Product Introduction
Product Operation
Product Maintenance
Trouble Shooting
2
4
32
5
6
7
Product Introduction
Safety Introduction
1. For the first operation, it is advisable to read the
manual carefully before hand and keep it properly
for future use.
2. Before the first operation, make sure the dust cup
or the dust bag is properly installed.
3. Make sure the power supply is 220-240V~ 50/60Hz
4. Do not vacuum water and inflammable material.
5. Do not vacuum burning material and ashes.
6. Do not use the machine without a motor protection
filter filled.
7. Please change the dust bag immediately when it
was damaged.
8. Do not store or use the machine close to high
temperature places.
9. Dot not let children use the machine in case of
danger.
10. If abnormal noise, smell, smoke or any other failure
or breakage is found during the operation, you
should turn off the switch and unplug it. Then
contact with your service center for repair. Do not
repair by yourself.
11. If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
12. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
13. Children should be supervised to ensure that they
do not play with the appliance.
Warning:
The plug must be removed from the power socket
before any maintenance or replacement.
If the power cord is damaged, replace them only by
the factory or maintenance center or similarly
qualified persons.
10
Lock Clip
Front Cover
On/off Pedal
Back Cover
Power Cord
Cord Rewinding Pedal
Wheel
Main Brush
1
2
3
4
5
6
7
8
9
Dust Full Indicator
Hose
Plastic Tube
2 in 1 Crevice Tool
10
11
12
Bag
13
9
Product Introduction
11 12 13
5
Product Operation
Connect the hose accessories:
Insert the hose end into the hose socket at the front cover and then hook it.
Remove the hose accessories:
Press the adaptors at both side of the hose end and then pull the hose accessories.
01
Connect the plastic tube to the curves end of the hose.
Connect different nozzle tools to the tube for different cleaning purpose: floor brush (adjust
to the type of ground) for carpet or floor; combine brush & nozzle for sofa, wall surface,
curtain, corner or space between furniture and etc.
02
Turn on the machine:
Insert the plug of cord into the power socket which conform to that on the label for power
supply, and press the on/off switch pedal, the machine could start working .
Cord rewinding:
Hold the plug and pull out the cord; press the cord rewinding pedal, that power cord will be
drawn in.
03
Illustration of the main unit
4
1
2
3
4
5
7
6
8
67
Change the dust bag:
When the wind indicator turns to be red or loss of suction is noticed, it is time to empty the
dust bag or replace with a new bag.
Open the front cover by pressing front cover locker. Take out the bag then empty it.
01
Exchange the outlet filter:
clip down and remove the outlet cover by hands for exchange of filter.
02
The motor protection filter should be cleaned or exchanged after it is dirt.
03
Product Maintenance
Dust cleaning: To maintain the suction power of the vacuum cleaner, please clean the dust regularly.
Dust full
In case of malfunction, please refer to the following table
TROUBLESHOOTING
If the problem still can’t be solved, please contact local service center.
Solution
- empty the dust bag in time
- clean the sponge filter
- clean the blockage
- dry the sponge filter in cool place after washing
- Inspect whether power plugs are tight or not or
the socket is live or not
- Press the switch button
- empty the dust bag in time
- clean the sponge filter
- clean the blockage
The vacuum
cleaner does
not switch on
Possible reason
- too much dust in the bag
- filter is blocked
- brush duct is blocked
- hasn't been fully dried after washing
- The power plugs are loose on the socket or
the power socket is not live
-The switch fails to be opened
- The dust bag is full
- The sponge filter is blocked
- Suction inlet of brush or the other accessory
is blocked
The machine
does not work
The machine
suddenly stops
Problem
Open
Autres manuels Midea Aspirateur
Midea
Midea M7 Manuel utilisateur
Midea
Midea SC861 Manuel utilisateur
Midea
Midea P71 Guide de l'administrateur
Midea
Midea MVC-I5C Manuel utilisateur
Midea
Midea VC-35A1Q3 Manuel utilisateur
Midea
Midea VCW40 Manuel utilisateur
Midea
Midea MVC-RTB2-R Manuel utilisateur
Midea
Midea MVC-P300 Manuel utilisateur
Midea
Midea VCM43B16H Manuel utilisateur
Midea
Midea VCR09B Manuel utilisateur
Midea
Midea P3-L Guide de l'administrateur
Midea
Midea VTW21A15T-140 Manuel utilisateur
Midea
Midea V19P13A20Q0C Manuel utilisateur
Midea
Midea VCP6P Manuel utilisateur
Midea
Midea M7 Manuel utilisateur
Midea
Midea VCS861P Manuel utilisateur
Midea
Midea P7 FLEX Schéma de câblage
Midea
Midea MVC-V12K-GR Manuel utilisateur
Midea
Midea VCWX10 Manuel utilisateur
Midea
Midea MCS2025GB Manuel utilisateur
