Microh LIVE575 Manuel utilisateur

LIVE575

Instruction Manual

LIVE575

Follow Spot Light

LIVE575

Please read this manual carefully before use.

Technical Specifications

Voltage: 120v 60Hz

Lamp: HMI575W

Control signal: DMX512 international standard signal

Number of channels: 4

Packing size: projector: 105.5×46×32(cm)

Control bar:39.5×32.5×23.5(cm)

Weight:40KG

Functions

zIP20 protection.

zQuick, accurate, stable and noiseless colour switching system.

zOverheat protection and high voltage line protection.

z15 degree beam angle with a projection distance of 40m.

zManual focus

zElectronically adjustable iris.

z0 – 100% linear dimmable

z6,000k, 5,600k and 3,200k colour temperature selector

zTwo high-powered fans for cooling system, optimized internal air duct design.

zAdjustable strobe effect (0-7 flashes per second).

z2 colour wheel, able to create up to 20 color combination.

zRainbow effects

zDMX 512 controllable – 4 channels

Installation Tips

zSafety inspection: after unpacking the unit, please inspect the unit for any damage that may have occurred

during shipping. If any damage is seen, please report this to your dealer immediately.

zInstallation and removal of lamps: make sure the power is disconnected and the lamp is cooled before

attempting to remove the lamp. In order to remove the lamp, carefully unscrew the two finger nuts located

on either side of the lamp. Remove defective lamp and install new lamp making sure not to touch glass

portion of the lamp with bare hands as the residue from left from touching the lamp will potentially shorten the

life of the lamp. If for any reason you accidentally touched the lamp, lightly moisten a lint free soft fabric

with rubbing alcohol and gently clean the area. Please ensure that the notch located on the round part of the

lamp is facing upwards. Once the lamp is in position, firmly tighten finger screws.

zFormula for addressing DMX code setting : This unit is capable of being controlled via DMX 512. The

unit uses 4 DMX channels to control colour, iris, dimmer and strobe effects. The address settings will be

determined by the DMX controller in use together with the position of the fixture in the DMX chain. Use the

dip switches found on the back of the unit to set the DMX address once you have calculated the DMX address

needed.

LIVE575

zPower up: make sure the power supply is sufficient for the power consumption of the unit before powering up.

Failure to do this may cause the unit to malfunction.

Operating Instructions

zPower On/Off: the unit is equipped with a HMI575GS discharge lamp. This lamp is not designed to be used

in an on-and-off manner. Each time the lamp is turned off, it must be cooled for at least 20 minutes before it

is turned on again. If this is not followed, the lamp will not turn on. You may use the dimmer function to

black out the unit during a show.

zFire notice: no flammable material, such as paper, is allowed near the lamp or the air duct. This will cause the

unit to over heat and shut off, and possibly cause a fire hazard. If any smoke is detected coming from the unit,

disconnect power supply immediately. The unit must be thoroughly checked by an authorized service

technician before powering on the unit.

zDMX Operation: When the unit is being used in DMX mode, it uses 4 DMX channels. The channels are

assigned as follows;

Channel 1 Iris (Adjust the beam size)

Channel 2 Colour Wheel (Select from the 7 colours plus white, rainbow effect)

Channel 3 Shutter (0 – 100% dimmer, Open and Strobe)

Channel 4 Colour Temp ( Select from 3,200K, 5,600K and 6,000K)

Maintenance

zThe unit must be inspected regularly ensuring that the fans and air ducts are kept clean and free of any dust

particles.

Trouble Shooting

zThe lamp does not power up:

1. Check that the power supplied is 120V.

2. Ensure that the fuse in the back of the unit is not blown.

3. Ensure that cooling process of 20 minutes is followed as explained above.

4. Check whether the fan and the air duct are blocked causing the unit to go into “overheat protection

mode”.

5. Check that the lamp is not blown. If the lamp is blown, follow replacement instructions above.

LIVE575

CONTROL PANEL

B C D E F G C B

A I H

A. When the Colour Select Button is in FIXED position, these 8 switches are used to select the individual

colours as marked..

B. Iris Size Switch – This is used to instantly change the iris size from maximum to minimum.

C. Black Out Switch.

D. Dimmer Slide or Strobe Speed Selector – Depending on the position of Switch G, this slide will dim unit

from 0 – 100% or adjust Strobe Speed from 0 – 7 flashes per second.

E. Iris Size Adjustment – This slide will allow one to adjust the size of the spot from a large to a small beam by

moving it left to right.

F. Rainbow Effect Slide – When Switch I is set to the rainbow position, the slide will adjust the speed of the

rainbow effect. Rainbow effect is when the colour wheel spins and colours are constantly changing.

G. Dimmer or Strobe Selector Switch – The position of this switch will affect slide D.

H. Colour temperature Switch – available colour temperatures 6,000k, 5,600k and 3,200k.

I. Colour Mode Switch – This allows one to switch between the fixed colour buttons or the rainbow slide.

Table des matières

Autres manuels Microh Matériel de DJ

Microh

Microh LED SLIM P64 Manuel utilisateur

Microh

Microh LED BLADE P64 MKIII Manuel utilisateur

Microh

Microh Ledstagepar v2 Manuel utilisateur

Microh

Microh ULTRA SPOT 575 Manuel utilisateur

Microh

Microh LED MAX ZOOM QUAD Manuel utilisateur

Microh

Microh LED TRI BAR V2 Manuel utilisateur

Microh

Microh LED COB100 PAR CWWW Manuel utilisateur

Microh

Microh Titan RGB 6W Manuel utilisateur

Microh

Microh OMNI HZR Manuel utilisateur

Microh

Microh NEORAY 120 Manuel utilisateur

Microh

Microh LED Bladep186 Manuel utilisateur

Microh

Microh ZM300 Manuel utilisateur

Microh

Microh LED PROFILE 120CW Manuel utilisateur

Microh

Microh LED Quadpar TRI MKII Manuel utilisateur

Microh

Microh FIREFOX-RG Manuel utilisateur

Microh

Microh LEDBARQX 185 Manuel utilisateur

Microh

Microh Wash 250 NXT Manuel utilisateur

Manuels Matériel de DJ populaires d'autres marques

ALPHA LITE

ALPHA LITE ALPHA 1500 Manuel du propriétaire

Chauvet

Chauvet OVATION E-930VW Manuel utilisateur

Zumtobel

Zumtobel APHRODITE Home Manuel utilisateur

Snow Masters

Snow Masters Zig Oscillator Manuel utilisateur

EuroLite

EuroLite 50530554 Manuel utilisateur

Beamz

Beamz BUV243 Manuel utilisateur

thomann

thomann Stairville DJ Lase 40-G MK-III Manuel utilisateur

Eagletone

Eagletone 6 Eyes Flower Manuel utilisateur

EuroLite

EuroLite FLD-1508 Manuel utilisateur

Technical Pro

Technical Pro LG8xSEA Manuel utilisateur

JB Systems

JB Systems Lounge Laser DMX Manuel utilisateur

Lightmaxx

Lightmaxx Vega Halo 90 Manuel utilisateur

Elation

Elation FUZE WASH Z350 Manuel utilisateur

Maverick

Maverick MK3 WASH Manuel utilisateur

Infinity

Infinity TF-260C7 Fresnel Manuel utilisateur

Chauvet

Chauvet EVE E-50Z Manuel utilisateur

Eliminator Lighting

Eliminator Lighting E 138 Manuel utilisateur

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manuel utilisateur