Meyer Sound DS-4P Manuel utilisateur

➪

A laser-trimmed differential

input stage affords superior

common-mode rejection to

allow signal runs through a

simple twisted pair cable.

Rear panel LEDs indicate AC

power and driver protection

limiting. The D -4P’s integral

power supply suppresses high

voltage transients and

incorporates the Intelligent

ACTM system. This automates

voltage selection, allowing

worldwide operation, and

additionally provides EMI

filtering, soft current turn-on,

and surge suppression.

Installation of this unit is

as simple as providing

power and an audio signal

source. ervicing in the

field is facilitated by the

modular design; the entire

power amplifier module

can be accessed and

replaced, if necessary.

The self-powered D -4P is

an arrayable mid-bass

loudspeaker system that

provides high power sound

reinforcement with extremely

low distortion. It was

developed to supplement the

70-200Hz band in full-range

systems, affording additional

mid-bass headroom. The

D -4P is most effective when

used in multiples within an

array, and easily can be

incorporated into

conventionally powered or

self-powered systems. The

D -4P uses two 12-inch cone

drivers in a true horn

enclosure. The horn’s flare

provides maximum energy

transfer in the mid-bands

with minimum frequency

response ripple.

Like all Meyer self-powered

loudspeaker systems, the

D -4P exhibits superior

performance across virtually

all parameters. Because the

amplifier and control

electronics are optimized for

the drivers, the system is

able to produce more power

with a flatter response and

lower distortion. The self-

powered concept simplifies

installation, and eliminates

amplifier racks and external

drive processing.

The D -4P incorporates a

two-channel Class AB/H power

amplifier, Meyer ound’s

proprietary phase-corrected

active processing circuits, and

driver protection voltage

limiters to ensure exceptional

performance and reliability.

The rugged cabinet is

coated with a textured black

finish (carpet covering is

an option) for durability and

ease of handling. The D -4P

comes standard with six

aircraft pan fittings

(ring and stud), three on the

top and three on the bottom

of the enclosure. L-Track

rigging can be fitted as an

option. Also available is a

variety of hanging and

arraying hardware to create

a complete system.

The D -4P easily

integrates with the Remote

Monitoring ystemTM (RM )

network and software

application. Windows-based

RM displays signal and

power levels, driver and

cooling fan status, limiter

activity, and amplifier

temperature for all net-

worked loudspeakers.

Integrated control

electronics and amplifiers

TruPower™

Limiting (TPL)

Intelligent AC™ System

Compatible with the

emote Monitoring

System™( MS)

High-power

Extremely low distortion

eliable and durable

Arrayable

Meyer

Sound

Superior

engineering

for the art

and science

of sound.

www.meyersound.com

FEATURES Self-Powered Mid-Bass Reinforcement Loudspeaker

DS-4P

Acoustical1

(each loudspeaker)

Coverage

Transducers

Audio Input

Amplifiers

AC Power

Physical

otes

Frequency esponse2

Phase esponse2

Maximum SPL2

Dynamic ange

(-6 dB points)

Low Frequency

Type

Connector

Nominal Input Level

Type

Burst Capability3

THD, IM, TIM

Connector

Automatic Voltage Selection

Operational Voltage ange

Max Continuous MS Current (>10 sec)

Burst MS Current (<1 sec)

Max Peak Current During Burst

Soft Current Turn-on

Dimensions

Weight

Enclosure

Finish

Protective Grill

igging

±4 dB from 70 Hz to 200 Hz

±70° from 70 Hz to 200 Hz

>142 dB PL peak@1 meter

>120 dB

120°H; 120°V

(2) M -12 12-inch cone drivers

10kΩimpedance, electronically balanced

XLR (A-3) male and female

+4 dBu

Complementary power MO FET output stages (audio class AB/H)

1240 watts (620 watts/channel)3

<.02 %

250V NEMA L6-20P (twistlock) inlet or IEC 309 male inlet

95-125 VAC and 208-235 VAC; 50/60 Hz4

Turn on: 85 VAC; Turn off: 134 VAC; 50/60 Hz

Turn on: 165 VAC; Turn off: 264 VAC; 50/60 Hz

@115V: 8A @230V: 4A @100V: 10A

@115V: 15A @230V: 8A @100V: 18A

@115V: 22Apk @230V: 11Apk @100V: 25Apk

Inrush current <12A @ 115V

Height: 36"; Width: 21.25"; Depth: 30"

(914mm H x 540mm W x 762mm D)

163 lbs (74 kg); shipping: 187 lbs (85 kg)

with carpet: 169 lbs (77 kg); shipping: 192 lbs (87 kg)

with L-Track 182 lbs (83 kg); shipping; 206 lbs (94 kg)

with carpet, L-Track: 188 lbs (86 kg); shipping: 211 lbs (96 kg)

Multi-ply hardwood

Black textured

Perforated steel grill, charcoal-grey foam

ix aircraft pan fittings (three on top and bottom). Working load for

each fitting is 600 lbs (273 kg) based on a 5:1 safety factor with a

straight tensile pull.

Optional L-Track rigging system: Working load at vertical pull using

any two points is 1500 lbs (682 kg) based on a 5:1 safety factor.5

1. Acoustical specifications are for the minimum configuration of two D -4P cabinets and

are measured on axis at 2 meters. One meter figure is derived from this data.

2. ubject to half space loading, measured with one-third octave frequency resolution in

fixed I O bands.

3. Nominal 8Ωresistive load, pink noise, 100V peak.

4. The unit is rated at 95-125 VAC and 208-235 VAC, 50/60 Hz, to satisfy EC standards for

–10% to 6% AC line voltage.

5. Based on a New Haven part number NH47556-1 fitting.

ALL UNIT IN INCHE

2.63

13.16

22.00

30.00

36.00 20.10

21.25 13.45

12.34

36.00

Front Side Back

Top and Bottom

(Without Grille Frame

WARNINGS:

THIS PRODUCT MUST BE GROUNDED

This surface may reach high tempuratures white in use.

To ensure proper operation, allow at least 6 inches

clearance from this surface and adequate ventilation.

To reduce the risk of electric shock do not remove cover.

No operator or serviceable parts inside.

Refer servicing to qualified personnel.

To reduce the risk of fire or electric shock

do not expose this appliance to rain or moisture.

ATENCIN:

ACCESO INTERNO SOLO

AUTHORIZADO A PERSONAL TCNICO CALIFICO

ACHTUNG:

GEHˆUSE NICHT OFFENE WARTUNG

UND REPARATUR NUR DURCH ELEKTROFˆCHKRAFTE

ATTENTION:

ENTRETIENET REPARATIONS

INTERNES NE SONT AUTORISEES QU’AU

PERSONNEL TECHNIQUE QUALIFI

U.K. WARNING:

THIS APPARATUS MUST BE EARTHED.

NO OPERATOR SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED PERSONNEL.

PHYSICALDIMENSIONS

DS-4P - 04.085.013.01 Rev A

UPM-1P - 04.084.004.01 REV A

Meyer Sound Laboratories, Inc.

28 2 San Pablo Avenue

Berkeley, CA 94702

tel: 510.486.1166

fax: 510.486.8 56

e-mail: techsuppor[email protected]

http: www.meyersound.com

Made by Meyer Sound, Berkeley, CA, USA

Europe n Office:

Meyer Sound Europe

Dalston House

9-49 Hastings Street

Luton Bedfordshire

England, LU1 5BE

®®

LISTED

3K59

COMMERCIAL

AUDIO SYSTEM

Meyer Sound reserves the

right to lter ny specific tion

without notice.

Ple se visit our web site t

www.meyersound.com for

up-to-d te inform tion.

Meyer Sound L bor tories

h s devoted itself to

designing, m nuf cturing,

nd refining components

th t deliver superb sonic

reproduction. Every p rt of

every component is

designed nd built to

ex cting specific tions nd

undergoes rigorous,

comprehensive testing

in the l bor tories.

Rese rch rem ins n

integr l, driving force

behind ll production.

Meyer strives for sound

qu lity th t is predict ble

nd neutr l over n

extended lifetime nd

cross n extended r nge.

DS-4P - 04.085.013.01 REV A

DS-4PSPECIFICATIONS

Autres manuels pour DS-4P

Table des matières

Autres manuels Meyer Sound Intervenants

Meyer Sound

Meyer Sound 750-LFC Manuel utilisateur

Meyer Sound

Meyer Sound M1D Manuel utilisateur

Meyer Sound

Meyer Sound Stella-4 Constellation Manuel utilisateur

Meyer Sound

Meyer Sound Self-Powered Reinforcement Loudspeaker MTS-4 Manuel utilisateur

Meyer Sound

Meyer Sound UPA-1C Manuel utilisateur

Meyer Sound

Meyer Sound Stella - 4 Constellation Manuel utilisateur

Meyer Sound

Meyer Sound 1100-LFC Manuel utilisateur

Meyer Sound

Meyer Sound UPA-2C Manuel utilisateur

Meyer Sound

Meyer Sound DS-2 Manuel utilisateur

Meyer Sound

Meyer Sound Reinforcement Loudspeaker UPM-2 Manuel utilisateur

Meyer Sound

Meyer Sound Compact VariO UPJ-1P Manuel utilisateur

Meyer Sound

Meyer Sound CAL Manuel utilisateur

Meyer Sound

Meyer Sound Self-Powered Loudspeaker HM-1 Manuel utilisateur

Meyer Sound

Meyer Sound HMS-10 Manuel utilisateur

Meyer Sound

Meyer Sound Self-Powered Reinforcement Loudspeaker MTS-4 Manuel utilisateur

Meyer Sound

Meyer Sound MJF-212A Manuel utilisateur

Meyer Sound

Meyer Sound HD-2 Manuel utilisateur

Meyer Sound

Meyer Sound UPL-2 Manuel utilisateur

Meyer Sound

Meyer Sound CQTM Series Manuel utilisateur

Meyer Sound

Meyer Sound UPQ-D Series Manuel utilisateur

Meyer Sound

Meyer Sound Self-Powered Studio Monitor HM-1S Manuel utilisateur

Meyer Sound

Meyer Sound HIGH DEFINITION AUDIO MONITOR HD-1 Manuel utilisateur

Meyer Sound

Meyer Sound Stella-8C Manuel utilisateur

Meyer Sound

Meyer Sound Compact VariO UPJ-1P Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur