6
Warranty
The MOBIPREP is guaranteed against defective material or
workmanship defects for a period of 12 months from the date
of receipt by the customer or latest 18 months after the
shipping date. The warranty is not valid if inspection shows
evidence of misuse or unauthorized repair. Warranty covers
only replacement of defective materials. If this unit need to be
returned to our factory for service, please contact your
distributor for authorization and include the following details:
Serial Number of the unit, Invoice number and date. Transport
costs belong to the customer.
NOTE
The equipment is designed to be used with
METKON accessories and consumables. In case of
misuse of equipment, improper installation,
alteration, use of different source parts, improper
repair, METKON will accept NO responsibility for any
damages to the operator or the equipment. Disassembling of
any part should always be performed by a qualified
technician
NOTE
METKON Instruments Inc. can make any changes
without notice on the equipment, accessories,
consumables and miscellaneous products.
Consequently; visual or written information on
the instruction manuals, technical materials, catalogues,
website, product videos and other marketing materials may
show inconsistencies and may be different from the product.
Safety Precautions
Read the below instructions carefully before use.
The operator must be fully instructed in the use of the
equipment and its accessories and consumables,
according to the Instruction Manual.
The Material Safety Data Sheet for each Metkon
consumable can be reached from www.metkon.com
under E-Metkon section.
Check that the MOBIPREP is standing firmly on the
support.
Always place the MOBIPREP, micro motor, accessories
and the consumables in its carrier and protection bag.
Do not touch the electrical cable or other electrical parts
with wet hands!
When disconnecting MOBIPREP from power supply
always pull the plug out. Do not pull the cable!
Immediately disconnect MOBIPREP from power if water
or any other liquid penetrates the unit!
Do not put any metallic, flammable or other parts into
MOBIPREP or to its sockets!
Disconnect MOBIPREP from power after charging!
Do not connect any other devices than supplied to
MOBIPREP sockets!
Do not open the control unit or change any parts within
it!
Do not touch the micro motor while it is rotating.
When installing the accessories to the micro motor,
tighten the collet chuck correctly and recheck the collet
chuck before use. Do not over tighten the collet chuck.
This may cause damage to the spindle.
Do not apply excessive force. This may cause tool
slippage, tool damage, and injury to the operator, Ioss of
concentricity and precision.
Be sure to clean the collet chuck, the inside of the
spindle before replacing the grinding tool. If ground
particles or metal chips stick to the inside of spindle or
the collet chuck, damage to the collet chuck or spindle
can occur.
Stop working immediately when abnormal rotation or
unusual vibrations are observed. Immediately, check the
content of section “TROUBLESHOOTING”
When the motor and the attachment generate heat
because of continuous work, slow down the motor
speed, or stop the motor. Then, use it after the motor and
the attachment gets cold.
Always check if there are any damage on the equipment
and the accessories before and after operating.
Do not disassemble, modify or attempt to repair the
MOBIPREP. Additional damage will occur to the internal
components. Service must be performed by METKON or
an authorized service center.
In any case of disorder, please contact your supplier or
the manufacturer!
